Panasonic LCD Projector Pt Lw362 Operating Instructions

ENGLISH - 101
Chapter 7   Appendix
This chapter describes specifications and after-sales service for the projector.  

102 - ENGLISH
Technical Information
Using the PJLink protocol
The network function of the projector supports PJLink class 1, and the PJLink protocol can be used to perform projector setting 
and projector status query operations from a computer.
Control commands 
The following table lists the PJLink protocol commands that can be used to control the projector.
 fx characters in tables are non-specific characters.
CommandControl detailsParameter / return stringRemark
POWRPower supply control01StandbyPower...

ENGLISH - 103
 terminal
The  terminal of the projector conforms with RS-232C so that the projector can be connected to and controlled 
from a computer.
Connection
Pin assignments and signal names
D-Sub 9-pin (female)
Outside viewPin No.Signal nameContents
—NC
TXDTransmitted data
RXDReceived data
—NC
GNDEarth
—NC
CTSConnected internallyRTS
—NC
Communication conditions (Factory default)
Signal levelRS-232C-compliant
Sync. methodAsynchronous
Baud rate19 200 bps
ParityNone
Character length8 bits
Stop bit1...

104 - ENGLISH
Basic format
Transmission from the computer starts with STX, then the command, parameter, and ETX are sent in this order. Add 
parameters according to the details of control.
STXC1C2 C3 : P1 P2Pn ETX
Basic format (with sub command)
S1S2S3S4S5 EP1P2P3P4P5P6
STX C1C2C3 :  ETX
Same as basic format
Sub command (5 bytes) Operation (1 byte)
“=” (Value specified using parameter is set)Parameter (6 bytes)*
1
Symbol “+” or “-” (1 byte) and set value or ad
-
justment value (5 bytes)
*1 When...

ENGLISH - 105
Cable specifications
[When connected to a computer] 
Projector
( terminal)
1NCNC1
Computer
(DTE specifications)
22334NCNC4556NCNC677889NCNC9
Control commands
When controlling the projector from a computer, the following commands are available.
 rProjector control command
CommandControl contentsParameter/return stringRemark (parameter)
PONPower on―To check if the power is on, use the “Power 
query” command.POFPower standby
IISSwitching the input 
signal
VID
SVD
RG1
RG2
HD1
CP1
MV1
UD1
NWP...

106 - ENGLISH
List of compatible signals
The following table specifies the type of signals compatible with the projectors.
 fSymbols that indicate formats are as follows. 
V = VIDEO/S-VIDEO, R = RGB, Y = YCBCR/YPBPR, H = HDMI
ModeDisplay resolution
(dots)
Scanning frequencyDot clock frequency (MHz)Format*1
PnP *2
H (kHz)V (Hz)Computer 1/ 
Computer 2HDMI
NTSC/NTSC4.43/
PAL-M/PAL60720 x 480i15.759.9--V----
PAL/PAL-N/
SECAM720 x 576i15.650.0--V----
525i (480i)720 x 480i15.759.913.5R/Y----
625i (576i)720 x...

ENGLISH - 107
ModeDisplay resolution
(dots)
Scanning frequencyDot clock frequency (MHz)Format*1
PnP *2
H (kHz)V (Hz)Computer 1/ 
Computer 2HDMI
1280 x 9601 280 x 96060.060.0108.0R/Hll
SXGA
1 280 x 1 02464.060.0108.0R/Hll
1 280 x 1 02480.075.0135.0R/Hll
1 280 x 1 02491.185.0157.5R/H----
1366 x 7681 366 x 76839.649.969.0R/H----
1 366 x 76847.759.885.5R/H----
1400 x 10501 400 x 1 05065.360.0121.8R/H----
1 400 x 1 05082.374.9156.0R/H----
1440 x 9001 440 x 90055.959.9106.5R/H----
1600 x 9001 600 x...

108 - ENGLISH
Specifications
The specifications of the projector are as follows.
Power supply100 V - 240 V  (100 V - 240 V alternating current), 50 Hz/60 Hz
Power consumption
 3.5 A, 300 W
In standby mode (when [Standby mode] is set to [Eco]): 0.5 W
In standby mode (when [Standby mode] is set to [Normal]): 6 W
LCD 
panel
Panel sizePT-LW362, PT-LW3121.5 cm (0.59") (aspect ratio 16 : 10)
PT-LB412, PT-LB382, PT-LB3321.6 cm (0.63") (aspect ratio 4 : 3)
Display method3 transparent LCD panels (RGB)...

ENGLISH - 109
Projection scheme[Front], [Rear], [Ceiling/Front], [Ceiling/Rear] (Menu setting system)
Built-in speaker10 W (monaural) x 1
Termi-
nals

1 (High-density D-sub 15 pin female)
[RGB signal] 0.7 V [p-p] 75 Ω 
 HD/SYNC TTL high impedance, automatic positive/negative polarity compatible
 VD TTL high impedance, automatic positive/negative polarity compatible 
 (HD/SYNC and VD do not support 3 value SYNC.)
[YPBPR signal] Y: 1.0 V [p-p] including synchronization signal, PBPR: 0.7 V [p-p] 75 Ω
[Y/C...

110 - ENGLISH
Dimensions

335 (13-3/16)87 (3-7/16)
250 (9-27/32)
252 (9-29/32)
61 (2-13/32)
9 (11/32)
96 (3-25/32)
167.5 (6-19/32)
68.5 (2-11/16)
55 (2-5/32)
 Actual dimension may differ by product.
Chapter 7   Appendix - Dimensions