Panasonic LCD Projector PT-FZ570 PT-FW530 PT-FX500 Operating Instructions

Chapter 5 Operation of Function — Web control function
ENGLISH - 121
Click [Detailed set up] 
→ [ECO management set up].
1
2
3
4
5
6
7
8
1  [LAMP POWER]
Selects the [LAMP POWER] setting.
2  [AUTO POWER SAVE]
Sets to [ON] when setting [AMBIENT LIGHT DETECTION], 
[SIGNAL DETECTION] and [AV MUTE DETECTION].
3  [AMBIENT LIGHT DETECTION]
Selects enable ([ON])/disable ([OFF]) of the environmental 
luminance interlock function.
4  [SIGNAL DETECTION]
Selects enable ([ON])/disable ([OFF]) of the no signal...

Chapter 5 Operation of Function — Web control function
122 - ENGLISH
8
7
8
7
9
7 
[E-MAIL ADDRESS 1], [E-MAIL ADDRESS 2]
Enter the E-mail address to be sent. Leave [E-MAIL ADDRESS 
2] blank when two E-mail addresses are not to be used.
8  Settings of the conditions to send E-mail
Selects the conditions to send E-mail.
[MAIL CONTENTS]: 
Selects either [NORMAL] or [SIMPLE].
[ERROR]: 
Sends an E-mail when an error occurred in the self-diagnosis.
[LAMP RUNTIME]: 
Sends an E-mail when the remaining time for...

Chapter 5 Operation of Function — Web control function
ENGLISH - 123
=== Panasonic projector report(CONFIGURE) ===
Projector Type          : PT-FZ570
Serial No               : SH1234567
-----  E-mail setup data -----
TEMPERATURE WARNING SETUP 
MINIMUM TIME            at [ 60] minutes interval 
INTAKE AIR TEMPERATURE  Over [ 45 degC / 113 degF ] 
ERROR                   [ OFF ] 
LAMP RUNTIME            [ OFF ]   at REMAIN [ 400] H 
LAMP RUNTIME            [ OFF ]   at REMAIN [ 200] H 
INTAKE AIR...

Chapter 5 Operation of Function — Web control function
124 - ENGLISH
=== Panasonic projector report(ERROR) ===
Projector Type          : PT-FZ570
Serial No               : SH1234567
-----  check system -----
FAN                           [   OK   ]
INTAKE AIR TEMPERATURE        [   OK   ]
EXHAUST AIR TEMPERATURE       [   OK   ]
LAMP REMAIN TIME              [   OK   ]
LAMP STATUS                   [   OK   ]
APERTURE(CONTRAST-SHUTTER)    [   OK   ]
INTAKE AIR TEMP.SENSOR        [   OK   ]
EXHAUST AIR...

Chapter 5 Operation of Function — Web control function
ENGLISH - 125
Note
 
f The replacement of the battery inside the projector is required when the time goes out of alignment right after correcting the time. Consult 
your dealer.
[Change password] page
Click [Change password].
1
2
3
1 
[Administrator]
Used to change the setting of the [Administrator].
2  [User]
Used to change the setting of the [User]. 3 
[Next]
Used to display the screen for changing the password.
[Administrator] account
1
2
3
4
1...

Chapter 5 Operation of Function — Web control function
126 - ENGLISH
1 
[Account]
Displays the account to change.
2  [New]
[User name]:
Enter the desired new user name. (Up to 16 characters in single 
byte)
[Password]:
Enter the desired new password. (Up to 16 characters in single 
byte)
[Password(Retype)]:
Enter the desired new password again. 3 
[OK]
Determines the change of password.
[Change password] (For user rights)
The change of password is enabled only under the user rights.
1
2
4 3
1  [Old...

Chapter 5 Operation of Function — Web control function
ENGLISH - 127
1 
[Tools], [Info], [Help]
Tabs for selecting the setting, information, or help page of the 
projector.
2  [POWER]
Turns off/on the power.
3  [VOL DOWN], [VOL UP]
Adjusts the volume.
[AV MUTE] 
Switches on/off the AV mute function. 4 
[Input Select]
Controls input selection.
Not available when the power of the projector is turned off.
5  Menu screen control buttons
Navigates the menu screen.
6  Freeze/image quality adjustment/digital...

Chapter 5 Operation of Function — Web control function
128 - ENGLISH
1 
[Projector Name]
Displays the projector name.
2  [Mac Address]
Displays the MAC address.
3  [Lamp Hours]
Displays the runtime of the lamps (converted value).
4  [Power Status]
Displays the status of the power. 5 
[Source]
Displays the selected input.
6  [Lamp Mode]
Displays the setting status of [LAMP POWER].
7  [Error Status]
Displays the error status.
8  [Exit]
Returns to the control page. 
[Help] page
Click [Help] on the control...

ENGLISH - 129
Chapter 6 Maintenance
This chapter describes methods of inspection when there are problems, ma\
intenance, and replacement of the 
units.  

Chapter 6 Maintenance — Lamp/temperature/filter indicators
130 - ENGLISH
Lamp/temperature/filter indicators
When an indicator lights up
If a problem should occur inside the projector, the lamp indicator , the temperature indicator , 
and the filter indicator  will inform you by lighting or blinking. Check the status of the indicators and 
remedy the indicated problems as follows.
Attention
 
f When switching off the projector to deal with problems, make sure to follow the procedure in “Switching off the...