Panasonic Kx Th1211 Operating Instructions Manual

Intercom/Locator
41For assistance, please visit http://www.panasonic.com/help
Intercom
Intercom calls can be made between 
handsets.
Note:
LIf you receive an outside call while 
talking on the intercom, you hear 2 
tones. To answer the call, press 
{OFF}, then press {C}.
LWhen paging a unit for an intercom 
call, the paged unit beeps for 1 
minute.
Making an intercom call
1
{INTERCOM}
2{V}/{^}: Select the desired unit. i 
{Select}
LTo stop paging, press {OFF}.
3When you finish talking, press 
{OFF}....

Intercom/Locator
42For assistance, please visit http://www.panasonic.com/help
Conference calls on 
the landline
2 handsets can have a conference call 
with an outside party on the landline.
1During an outside call, press 
{INTERCOM} to put the call on hold.
2{V}/{^}: Select the desired unit. i 
{Transfer}
3Wait for the paged party to answer.
LIf the paged party does not 
answer, press {C} to return to 
the outside call.
4{Conf}
LTo leave the conference, press 
{OFF}. The other parties can 
continue the...

Useful Information
43For assistance, please visit http://www.panasonic.com/help
Belt clip
You can hang the handset on your belt or 
pocket using the supplied belt clip.
To attach the belt clip
To remove the belt clip
Wall mounting
Base unit
1
Remove the base unit stand by 
pushing (A) and sliding down (B).
2Tuck the telephone line cord and 
connect the cord. Mount the unit by 
inserting the mounting pins into the 
round openings on the unit (for pin 
2, use the round cut out at the 
bottom of the unit if...

Useful Information
44For assistance, please visit http://www.panasonic.com/help
3Put the telephone line cord into the 
gap between the wall and the base 
unit.
To attach the base unit stand
Place the base unit stand by fitting the 
tab into the slot on the base unit. Then 
slide the stand until it clicks.
Charger
1
Drive the screws (not included) into 
the wall.
2Mount the charger (A), then slide it 
down (B) and to the right (C) until it 
is secure.
Headset (optional)
Connecting a headset to the handset...

Useful Information
45For assistance, please visit http://www.panasonic.com/help
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display messageCause/solution
Busy
or
System is busy. Please 
try again later.LThe called handset is in use.
LOther units are in use and the system is busy. 
Try again later.
LThe handset you are using is too far from the 
base unit. Move closer and try again.
LA line is being used by another handset. A 
cellular line and the...

Useful Information
46For assistance, please visit http://www.panasonic.com/help
Phonebook fullLThe phonebook memory is full. Erase 
unnecessary entries (page 25).
Store VM access#LYou have not stored the voice mail access 
number. Store the number (page 39).
Display messageCause/solution
TH12XX.book  Page 46  Wednesday, January 30, 2008  3:05 PM 

Useful Information
47For assistance, please visit http://www.panasonic.com/help
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect 
the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the 
batteries from the handset, and then insert the batteries into the handset again.
General use
ProblemCause/solution
The unit does not work.LMake sure the batteries are installed correctly 
(page 13, 14).
LFully charge the batteries (page...

Useful Information
48For assistance, please visit http://www.panasonic.com/help
I cannot connect a cellular 
phone to the base unit.LDepending on the compatibility of your cellular 
phone, you may not be able to connect it to 
the base unit.
LConfirm that you have registered your cellular 
phone to the base unit using the cellular 
phone (page 17). Refer to the operating 
instructions of your cellular phone for 
registration.
LConfirm that your cellular phone is turned on.
LConfirm that the Bluetooth...

Useful Information
49For assistance, please visit http://www.panasonic.com/help
Programmable settings
Battery rechargeI cannot hear a dial tone.LMake sure the base unit’s AC adaptor is 
connected properly (page 12).
LMake sure that the LINK TO CELL indicator 
lights green and the cellular phone is 
connected to the base unit (page 18).
LMake sure the telephone line cord is 
connected properly (page 12).
LIf you are using a splitter to connect the unit, 
remove the splitter and connect the unit to the...

Useful Information
50For assistance, please visit http://www.panasonic.com/help
Making/answering calls, intercomI fully charged the batteries, but 
7 still flashes or 8 is 
displayed.LClean the charge contacts and charge again 
(page 14).
LIt is time to replace the batteries (page 13, 14).
I fully charged the batteries, but 
the operating time seems to be 
shorter.LClean the battery ends (S, T) and the 
charge contacts with a dry cloth, and charge 
again.
ProblemCause/solution
Noise is heard, sound cuts...