Panasonic Kx Tgl460 Operating Instructions Manual

4Adjust the adaptor to hold the base unit,
then push it in the direction of the arrow
until it clicks into place.5Mount the unit on a wall then slide down
to secure in place.
 AC adaptor cord
R This product is compliant with the
following wall phone plate sizes (2
types).
 83 mm (3  1
/4  inches) 102 mm (4 inches)
Fit the slots of the unit onto the
corresponding wall phone plate tabs
for (
) and () respectively.
For assistance, please visit http://shop.panasonic.com/support61
Useful Information...

To remove the wall mounting adaptor
While pushing down the release levers (A),
remove the adaptor ( B).
Charger
Drive the screws (
) (not supplied) into the
wall.
 27.2 mm (1  1
/16  inches)
62For assistance, please visit http://shop.panasonic.com/support
Useful Information

TGL46x(en)_1118_ver044.pdf   622015/11/18   9:33:33B
AA 1 2 1
2   

Error messages
Display messageCause/solution
Ask phone
company for
VM access #RYou have not stored the voicemail access number.
Store the number (page 59).
Base no power
or
No link. Re-
connect base
AC adaptor.RConfirm the base unit’s AC adaptor is connected to
the unit and the power outlet correctly.
R The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The...

Display messageCause/solution
Requires
subscription
to Caller ID.RYou must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Use
rechargeable
battery.RA wrong type of battery such as alkaline or
manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 4, 7.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC...

ProblemCause/solution
I cannot connect a cellular
phone to the base unit.RConfirm that your cellular phone is turned on.
R Confirm that your cellular phone is within base unit range
(page 13).
R Your cellular phone’s Bluetooth feature is turned off. Turn
it on.
R Depending on the state of the wireless environment, such
as the presence of any electrical interference, there may
be a delay even if the auto connection feature is turned
on. You can connect to the base unit manually (page 18).
R The cellular...

ProblemCause/solution
I fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to be shorter.
RClean the battery ends (, ) and the charge contacts
with a dry cloth and charge again.
R It is time to replace the batteries (page 10).
Making/answering calls, intercom
ProblemCause/solution
 is displayed.RThe handset is too far from the base unit. Move closer.
R The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset...

ProblemCause/solution
I can make and answer cellular
calls but cannot hear a sound.RThe Bluetooth technology on your cellular phone may not
be functioning normally. Turn off and on your cellular
phone.
R Disconnect and reconnect the base unit AC adaptor and
try again.
I cannot switch cellular calls
from the unit to the cellular
phone.RYour cellular phone may not support this feature. Refer to
the operating instructions of your cellular phone.
I cannot make a call using a
landline.RThe dialing mode may...

ProblemCause/solution
Caller information is not
announced.RThe ringer volume for landline is turned off. Adjust the
ringer volume (page 37).
R The ringer volume for cellular line is turned off. Adjust the
ringer volume (page 35).
R The unit which is not selected to ring for cellular calls
does not announce caller information. To change the
selection, see page 17.
R The Talking Caller ID feature is turned off. Turn it on
(page 37).
R The ring as cell mode is set to  “On (without Talking
CID) ”. To change...

Using Bluetooth devices
ProblemCause/solution
I cannot copy phonebook
entries from a cellular phone.RConfirm that the cellular phone supports Bluetooth
wireless technology.
R Confirm that the cellular phone supports the Phone Book
Access Profile (PBAP) or Object Push Profile (OPP)
specification.
R If the cellular phone is already connected to another
Bluetooth device such as a Bluetooth headset, turn it off
or disconnect it from the cellular phone.
R Someone is using a cellular line or headset. Try...

ProblemCause/solution
App alert is not displayed or
announced.
or
Text message alert is not
displayed or announced.RConfirm that the cellular phone supports the Message
Access Profile (MAP) specification to use text message
alert feature.
R Confirm that the cellular phone supports the Serial Port
Profile (SPP) specification to use App alert feature.
R Confirm that the  [Application Alerts manager]  setting of
your Android phone is turned on.
R “Alert On/Off ” is set to  “Off ”. Set it to  “On ”
(page...