Panasonic Kx Tg2322 Operating Instructions Manual

Preparation
For assistance, please call: 1-800-211-PANA(7262)11
Installation
Recharge
Recharge the battery when: 
—the RECHARGE indicator flashes, or
—the handset beeps intermittently while it 
is in use.
• The RECHARGE indicator will flash when  the handset battery is charged less than 
15 minutes and the handset is lifted off 
the base unit.
A nickel metal hydride battery that is recyclable powers the 
product you have purchased. Please call 
1-800-8-BATTERY for information on how to recycle this...

12
Programmable Settings
Programmable Functions 
You can use the following functions to customize your unit. See the 
corresponding pages for function details.
Make sure the handset and base unit are not being used. The handset 
must be operated near the base unit and while off the base unit.
• If an alarm tone sounds during programming, walk closer to the base unit and start again from the beginning.
• You can exit programming mode at any time by pressing  [OFF].
• If you do not press any buttons for...

Preparation
For assistance, please call: 1-800-211-PANA(7262)13
Programmable Settings
Time and Day   
We recommend you set the time and day so that the unit will announce the 
day and time each message was recorded when you play back messages.
• When entering the time in step 3, you cannot enter numbers greater than  12.  Do not use military time.  (To set 13:00 hours, enter “0100”, then 
select PM in step 4.)
 
To confirm the time and day,  press [VOICE ENHANCER]  then [0]. 
• The current day and time...

Programmable Settings
14
Dialing Mode 
If you have touch tone service, set the dialing mode to “Tone”. For rotary or 
pulse service, set to “Pulse”. The factory preset is “Tone”.
Ringer Volume 
You can set the handset ringer volume to high, medium, low, or off. 
The factory preset is HIGH. If the handset ringer is turned off, the handset 
will not ring. 
To set the ringer volume to high (preset), medium or low,  press [
d] or  [B].
• To increase volume, press  [
B]. To decrease volume, press  [d].
• To...

Preparation
For assistance, please call: 1-800-211-PANA(7262)15
Programmable Settings
Ringer Tone 
You can select the handset ringer to use one of 7 ringer patterns. There are 
3 bell ringer patterns and 4 melody patterns available. The factory preset is 
“Bell ringer pattern 1”.
• If you subscribe to a Distinctive  Ring Service (such as IDENTA-RING) 
from your telephone company with 2 or 3 consecutive rings, select a bell 
ringer pattern (1 to 3). If you select  a melody pattern, you will not be able...

16
Preparing the Answering System
Greeting Message 
You can record a personal greeting message of up to 2 minutes. If you do 
not record your own message, a pre- recorded greeting will be played for 
callers (p. 17). 
To record a greeting message
• If “ ” is displayed, 6 beeps sound and “ Your greeting was not recorded. 
Record your greeting again. ” is announced, start again from step 1.
To adjust the speaker volume,  press [< ] or  [> ] during playback.
• 9 levels (0–8) are available while using the...

Preparation
For assistance, please call: 1-800-211-PANA(7262)17
Preparing the Answering System
To review the greeting
Press [GREETING CHECK] .
To erase the greeting
Press [GREETING CHECK] , then press [ERASE] while the recorded 
message is being played.
• The unit will answer calls with a pre- recorded greeting (see below).
Pre-recorded greeting
If you do not record a greeting (p. 16), a pre-recorded greeting will be 
played when a call is received.
To review the pre-recorded greeting,  press [GREETING...

Preparing the Answering System
18
Number of Rings 
You can select the number of times the unit rings before the Answering 
System answers a call, from “2” to “7” or “Toll saver”*. The factory preset is “4”
.  
Remote Code 
The remote code prevents unauthorized people from accessing your unit 
and listening to your messages from any touch tone phone (see “Remote 
Operation from a Touch Tone Phone” on page 28).
Choose any  2-digit number (00–99)  for your remote code. 
The factory preset remote code is “...

Telephone System
For assistance, please call: 1-800-211-PANA(7262)19
Making Calls
 
To have a hands-free phone conversation  1
Press [C ].
• The TALK indicator lights.
2Dial a phone number.
3To hang up, press  [OFF] or place 
the handset on the base unit.
• The indicator light goes out.
1Press  [SP-PHONE] .
• The TALK indicator lights.
2Dial a phone number.
3When the other party answers, talk into the microphone.
4To hang up, press  [OFF] or place the handset on the base unit.
• The indicator light goes...

Making Calls
20
To redial the last number dialed
Press [C ] or  [SP-PHONE] , then press [REDIAL].
To adjust the receiver/s peaker volume during a 
conversation
There are 3 volume levels for the receiver and 6 volume levels for the 
speaker. 
To increase volume, press  [
B]. 
To decrease volume, press  [
d].
• If you try to increase/decrease volume when it is at the maximum/ minimum level, the han dset will beep 3 times.
Voice Enhancer Technology
Panasonic’s Voice Enhancer Technology clarifies the voice...