Panasonic Kx Tg2313 Operating Instructions Manual

Useful Information
For assistance, please call: 1-800-211-PANA(7262)41
Belt Clip
You can hang the handset on your belt or pocket using the included belt clip.
To attach the belt clip To remove the belt clip  
Shoulder Rest Attachment
Use the shoulder rest attachment if you need to keep your hands free during a 
phone conversation.
To attach the shoulder rest 
attachment
Attach the included belt clip to the 
handset (see above), then attach the 
shoulder rest attachment to the belt clip 
as shown below....

42
Wall Mounting
This unit can be mounted on a wall phone plate.
1Press the tabs in the direction 
of the arrows (1), then remove 
the wall mounting adaptor (2).
2Connect the AC adaptor. 
• Fasten the AC adaptor cord to 
prevent it from being 
disconnected. 
3Tuck the telephone line cord 
inside the wall mounting 
adaptor, then push the adaptor 
in the direction of the arrows 
(1 and 2) while pressing the 
tabs.
• The word “UP WALL” should face 
upward.
4Connect the telephone line 
cord. Mount the unit,...

Useful Information
For assistance, please call: 1-800-211-PANA(7262)43
Optional Headset
Connecting an optional headset to the handset allows hands-free phone 
conversation. Please use only a Panasonic KX-TCA60, KX-TCA86, KX-TCA88, 
KX-TCA88HA, KX-TCA91, KX-TCA92, or KX-TCA98 headset. To order, call the 
accessories telephone number on page 2.
Connecting an optional headset
Open the headset jack cover, and insert the headset plug into the headset jack as 
shown below. 
• Headset sold separately. Model...

44
Direct Commands
After pressing [MENU], you can also program menu items directly by pressing ([0] 
to [9], and [#]) instead of using the soft keys.
Menu item Command Selection items Page
Ringer volume[1] [1]  [0] : Off 
[1] : Low
[2] : Medium
[3] : Highp. 15
Ringer tone [1] [2] [1]–[3] : Tone pattern 1– 3 
[4]–[7] : Melody pattern 1– 4p. 16
V.M. access[3]p. 36
Voice enhancer[5] [1] : On  [0] : Off p. 20
Activate Caller IQ *1 [7] [1]—
View information *3[7] [2] *4Go to Step 4 on page 53. —
Get new...

For assistance, please call: 1-800-211-PANA(7262)45
Direct Commands
Useful Information
During programming:
When “Save” is displayed, press the right soft key to save the new settings.
To exit programming, press [OFF].
• If you press the direct command incorrectly, press [OFF], then re-enter 
programming mode by pressing [MENU].
• For function details, see the corresponding pages.
*
1Can be used to activate Caller IQ. See the leaflet included with this unit for more 
information.
*
2For openLCR...

46
If the Following Appear on Your Display...
The following will be displayed when the unit needs your attention.
Display message Cause & Remedy
Recharge battery• The battery needs to be charged. Recharge the 
battery (p. 9).
Charge for 6h• The battery has been discharged. The handset will 
not work. Fully charge the battery (p. 9).
No link to base.
Move closer to 
base, try again.• The handset has lost communication with the base 
unit. Walk closer to the base unit and try again or 
re-register the...

Useful Information
For assistance, please call: 1-800-211-PANA(7262)47
Troubleshooting
If the handset display shows error messages, see “If the Following Appear on 
Your Display...” (p. 46) for the Cause & Remedy.
Problem Cause & Remedy
“No link to base. Move 
closer to base, try 
again.” is displayed and an 
alarm tone sounds.• You are too far from the base unit. Walk 
closer to the base unit.
• Confirm the base unit’s AC adaptor is 
plugged in.
• Raise the base unit antenna.
• If the above remedies do...

Troubleshooting
48
You cannot redial. • If the last number dialed was more than 
48 digits long, the number will not be redialed 
correctly.
You cannot make long 
distance calls.• Please make sure you have long distance 
service.
• Check if Caller IQ is on. Turn Caller IQ off 
(p. 50).
The handset does not display 
the caller’s name and/or 
phone number.• You need to subscribe to Caller ID.
• Other telephone equipment may be 
interfering with your phone. Disconnect it and 
try again.
• Other electrical...

For assistance, please call: 1-800-211-PANA(7262)49
Troubleshooting
Useful Information
openLCR Service for Caller IQ
The CHARGE indicator does 
not go out after the battery has 
been charged.• This is normal.
The Ringer/Message Alert 
indicator flashes slowly when 
the handset is not ringing and 
in use.• The Message Alert is turned on and new 
messages in your voice mailbox have been 
recorded. Turn the Message Alert off (p. 17) 
or listen to the new messages (p. 36).
You cannot have a 
conversation...

50
openLCR Service for Caller IQ
This unit is compatible with services provided by openLCR.
Important:
• If you have any questions regarding the openLCR service, call openLCR’s 
customer service department at 1-866-openLCR(1-866-673-6527).
• NEITHER PANASONIC COMMUNICATIONS CO., LTD. (PCC) NOR 
MATSUSHITA ELECTRIC CORPORATION OF AMERICA (MECA) IS IN ANY 
WAY AFFILIATED WITH, OR RESPONSIBLE FOR THE ACTS OR OMISSIONS 
OF, OPENLCR.COM, INC. (OPENLCR). NEITHER PCC NOR MECA NOR ANY 
OF THEIR EMPLOYEES OR...