Panasonic Kx T1460 Operating Instructions Manual

Listening to the recorded messages froma remote telephone
rTOLL SAVER
The number of rings that it takes for the unit to answer tells you if
there are any new messages.
Answer on the 2nd ring .. ....At least one new message
Answer on the 4th ring . . . . . . .No new messages
To save the toll charge, hang up immediately when you hear the 3rd ring.
o Note that remote control operations is only possible with a tone telephone
(touch tone telephone).
REMOTE CODE (2 digits)
Be sure to remember your remote
code...

Recording a message from a remote telephoneResetting the ICM tape for future messages
After playing back the recorded
messages, you can recoro your
own message, on the same call
I When replay is finished, wait for the three beeps to mark the end of the
last message and then wait about 10 seconds for another two beeps to
indicate the taoe is readv to record.
Leave your message.
3 beeps 2 beep
Hang up when finished.
lf you rewind the tape and new
messages are recorded from the
beginning of the tape, old...

Recording a new OGM (outgoins Messase)Monitoring sounds where the unit is located (Room Monitor)
l plan to
get home
on May 3rd...
You can change the content of
your OGM (Outgorng Message)
tape from a remote telephone.
You can listen to
(monitor) the sounds
in the room where
the unit is installed
for about 30 seconds.
1
Dial your telephone number.
1
Dial your telephone ,f,,;-\number. ,/ ,ni. iroir, \
+w
Exampte
llwxVi
I r1_g I
Press your code number(for example. 19)
while the OGM is playing.
One beep...

l forgot to
turn it on!
Turning the answering function on andoff from a remote telephone
You can turn on the answering
function from a remote teleohone
Dial your telephone /:1-\
numl5er. 6i 
Rtno rino )
+Q \q/
\5
ffi*j*#F@Let the telephone ring
and the unit will
automatically
switch on and
begin to play the
OGM.
Press your code number
while the OGM is playing.
One beep sounds
for each message
recorded, up to
a maximum of
eight.Hang up while the OGM is playing.
The unit will stay on and record any other...

Recording a memo messageScreening calls
You can record a memo message
at home. lt will be heard by
anyone who listens to the recorded
messaoes.
lm out
shopprng.
lll be home
about 5:00.
1
Press the
button until the
beep is heard.
The lN/USE indicator
beoins to flash.
Record your message.
Speak from a distance of about 8 inches
away from the microphone.
You can listen to incoming
messages as they are being
recorded.
lf you lift up the handset to talk to
the caller during recording,
recording will stop at...

t
Troubleshooting guide
ProblemCause & Remedy
oThe unit does not work when I press any
buttons.
ol cannot remove the cassette from the
unit.
Plug in the AC adaptor then switch
rne power on.
The unit has been set to the Answer mode,
but no Incoming Message is recorded.
olhe OGM or ICM cassette tape is
cut or is not inserted.
Replace the cassette tape with a
new one.
oThe OGM is recorded improperly.
Record a new OGM.
The unit does not function. However, the
beep sounds 6 times and the ANSWER/
CALLS...