Panasonic Kx-T123211d Remote Programming Manual

DSS Console 2-Flexible DSS Button
Parameter no.010203040506
0708
! 02 ButtoniiiiI 03 Button ! 04 Button I 05 Button I 06 Button I 07 Button i 08 Button
-----------L-----------L-----------+--------------~-----------~-----------~-----------~-----------
I 10II
I11I12-----------‘-----------! 13I 14I 15I
I16rr----------- ------_____Tt-----------t-----------~-----------~-----------
I
I18; 19; 201 21; 22; 23;...

SupplementOn-site 
/ remote administration has 5 modes excluding an unsetting
mode and prompt shows the current mode.
(prompt); > . .
; E> ..
; s> ‘.
; P> .’; 
R>; D> .(Setting mode command)
unsetting mode
Edit mode. . . . . . . . . . . .
Show mode. . . . . . . . . .
Dump mode . . . . . .System Working Report mode
Diagnostic mode. . . . . . . .
Mode 
/ Style Exit. . . . .
. . .EDT
. .
SHW. .
DMP
. . .RPT
. . .DIG.
END 
-Mode Styleremove command
0“END” is used to remove a command.
0“; >” is indicated just...

To edit/show, you must enter the command to edit/show after each
mode are set.
The commands are as follows.-I
System01s.. .
13s, 90s
Outside Line
lC...7C
Extension
lE, 2E
-IDSS ConsolelD...3DIDoorphone
lP, 2P
-iClear99A, 99S, 99C, 99E, 99P, 99D
0 Main Command consists of numeral and alphabet. The alphabet
means as follows.
S 
- SystemE - ExtensionD - DSS Console
c 
- coP - Doorphone
0 The above commands consists of parameter (except 99A-99D).
0 Enable edit mode to edit the setting contents by repairing...

Supplement (cont.)When enter Disposal Execute Command, the ways are done as
E The entering ways are different by the case that there is a
follows.Subcommand, there is no Subcommand and edit or show at a
q
n
q
n
nMain Command = M
Subcommand = S
Param:eter 1= PlParameter n= Pn are explained as this.
Alphabet of Main Command can be entered with large and small
character.The punctuation of Command and Parameter is done with 
“/“.The maximum character number enable to enter with one
Command are 78 digits and...

W Omission of Parameter (Edit Mode)
In case there are parameter which need not to change, enter only
‘I/” to the location of parameter.
Example;Only terminal no. 3 is set to Extension number
setting Command 
01s as default value.
OlS///A/l
LJack number 03
L
LJacknumber 02
Jacknumber 01
4 Edit with parameter number Assignment
When you want to edit one parameter only, enable to edit the
parameter by assigning the parameter number.
Example;If you want to edit only Toll Restriction of System
Speed Dialing 03...