Panasonic Kx Nt321 Information Manual

							Stand Usage
11 Document Version 2008-05
Stand Usa geAttaching the Stand
Place the catches (A) of the stand into hooks located in the unit. 
Gently push the stand in the direction indicated until it locks into 
place. The stand will be mounted in the high position.
Removing the Stand
Hold the stand with both hands.
Gently rotate the stand in the direction indicated until it is released.
Cabling
When using the stand, ensure that the cables are clamped as 
shown.
A
NT321M_QRG.fm  Page 11  Tuesday, January 15, 2008  4:51 PM 
						

							Stand Usage
12Document Version 2008-05
Adjusting from High to Low Position
Hold the stand with both hands as shown and gently push the stand 
in the direction indicated until it locks into the low position (B).
Adjusting from Low to High Position
Hold the stand with both hands as shown and gently pull the stand 
in the direction indicated until it locks into the high position (A).
A
NT321M_QRG.fm  Page 12  Tuesday, January 15, 2008  4:51 PM 
						

							Wall Mounting
13 Document Version 2008-05
Wall Moun ting1.Remove the stand if it is attached. For information on removing the 
stand, refer to page 11.
2.Attach the wall mounting adaptor 
as shown.
•Make sure the cables are not 
pinched by the wall mounting 
adaptor. When running the cables 
from the top of the unit, look 
through the opening in the wall 
mounting adaptor to confirm that 
the cables are not being pinched.
•Slide the wall mounting adaptor in 
the direction indicated until it locks 
into place.
3.Drive the 2 screws into the wall 
either 83 mm (3-1/4 in) or 100 
mm (3-15/16 in) apart, and 
mount the unit on the wall.
•You can find a wall mounting 
template on page 19.
•Make sure that the wall that the 
unit will be attached to is strong 
enough to support the unit 
(approx. 1.5 kg [3.31 lb]).
•Make sure the cables are securely 
fastened to the wall.
•When this unit is no longer in use, 
make sure to detach it from the 
wall.
Locking the Handset Hook
Pull down the handset hook until it locks to prevent 
the handset from falling off the handset cradle when 
the unit is mounted to a wall or set at a high angle. 
To temporarily place the handset down during a 
conversation, hook it over the top edge of the unit 
as shown.
83 mm(3-1/4 in)100 mm(3-15/16 in)
Washer
Drive the screw
to this point.
NT321M_QRG.fm  Page 13  Tuesday, January 15, 2008  4:51 PM 
						

							Important Information
14Document Version 2008-05
Im p ort an t In fo rm at i onWhen using a KX-NT321 IP-PT, keep the following conditions in 
mind.
•If the unit does not operate properly, disconnect the unit from the 
Ethernet cable and then connect again.
•If you are having problems making calls, disconnect the Ethernet cable 
and connect a known working IP-PT. If the known working IP-PT operates 
properly, have the defective IP-PT repaired by an authorized Panasonic 
factory service center. If the known working IP-PT does not operate 
properly, check the PBX and the Ethernet cable.
•Wipe the unit with a soft cloth. Do not clean the unit with abrasive 
powders or with chemical agents such as benzene or thinner.
•Use only the correct Panasonic handset.
•Do not disassemble this unit. Dangerous electrical shock could result. 
The unit must only be disassembled and repaired by qualified service 
technicians.
•If damage to the unit exposes any internal parts, immediately disconnect 
the cable or cord. If the power is supplied from the network to the IP-PT 
[Power-over-Ethernet], disconnect the Ethernet cable. Otherwise, 
disconnect the AC adaptor cord. Then return this unit to a service center.
•Never attempt to insert wires, pins, etc. into the vents or other holes of 
this unit.
Take special care to follow the safety suggestions listed below. 
Safety 
1) The unit should only be connected to a power supply of the type 
described in the Quick Reference Guide or as shown on the label on the 
unit. 
2) When left unused for a long period of time, the optional AC adaptor 
should be unplugged from the AC outlet, if you are using Power-over-
Ethernet, disconnect the Ethernet cable.
Installation
Environment
1) Do not use this unit near water, for example, near a bathtub, washbowl 
or sink. Damp basements should also be avoided.
2) Keep the unit away from heating appliances and devices that generate 
electrical noise, such as fluorescent lamps, motors and televisions. 
These noise sources can interfere with the performance of the unit. It 
also should not be placed in rooms where the temperature is less than 
5 °C (41 °F) or greater than 40 °C (104 °F). 
Allow 10 cm (3-15/16 in) clearance around the unit for proper 
ventilation.
NT321M_QRG.fm  Page 14  Tuesday, January 15, 2008  4:51 PM 
						

							Important Information
15 Document Version 2008-05
Placement 
1) Do not place heavy objects on top of this unit.
2) Care should be taken so that objects do not fall onto, and liquids are not 
spilled into, the unit. Do not subject this unit to excessive smoke, dust, 
moisture, mechanical vibration, shock or direct sunlight. 
3) Place the unit on a flat surface.
WARNING:TO PREVENT POSSIBLE FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE 
THIS UNIT TO RAIN OR MOISTURE.
THIS HANDSET EARPIECE IS MAGNETIZED AND MAY RETAIN SMALL 
FERROUS OBJECTS.
DISCONNECT THIS UNIT FROM POWER OUTLET/THE ETHERNET 
CABLE IF IT EMITS SMOKE, AN ABNORMAL SMELL OR MAKES 
UNUSUAL NOISE. THESE CONDITIONS CAN CAUSE FIRE OR 
ELECTRIC SHOCK. CONFIRM THAT SMOKE HAS STOPPED AND 
CONTACT AN AUTHORIZED SERVICE CENTER. 
IMPORTANT NOTICE:•Under power failure conditions, the IP-PT may not operate. Please 
ensure that a separate telephone, not dependent on local power, is 
available for use in remote sites in case of emergency.
•For information regarding network setup of the IP-PT such as IP 
addresses, please refer to the Installation Manual for the Panasonic PBX.
•If an error message is shown on your display, consult your dealer or the 
network administrator.
•The firmware of the KX-NT321 is protected by copyright laws and 
international treaty provisions, and all other applicable laws. It cannot be 
reverse engineered, decompiled or disassembled.
When you ship the product:Carefully pack and send it prepaid, adequately insured and preferably in the 
original carton. Attach a postage-paid letter, detailing the symptom to the 
outside of the carton.
DO NOT send the product to the Executive or Regional Sales offices. They 
are NOT equipped to make repairs.
Product service:Panasonic factory service centers for this product are listed in the service 
center directory.
Consult your authorized Panasonic dealer for detailed instructions.
NT321M_QRG.fm  Page 15  Tuesday, January 15, 2008  4:51 PM 
						

							Important Information
16Document Version 2008-05
Important Safety Instructions
When using this unit, basic safety precautions, including those below, should 
always be followed to reduce the risk of fire, electric shock and injury to 
persons.
1.Read and understand all instructions.
2.Follow all warnings and instructions marked on this unit.3.Unplug this unit from the AC outlet before cleaning. Do not use liquid or 
aerosol cleaners. Clean with a damp cloth.
4.Do not use the unit near water, for example, near a bathtub, kitchen sink, 
or laundry tub, in a wet basement, or near a swimming pool.
5.Place this unit on a flat surface. Serious damage and/or injury may result 
if the unit falls.
6.The unit should never be placed near or over a radiator or other heat 
source.
7.This unit should be operated only from the type of power source indicated 
on the unit label. If you are not sure of the type of power supply to your 
home, consult your dealer or local power company.
8.Do not allow anything to rest on the power cord. Do not locate this unit 
where the cord may be stepped on or tripped on.
9.To reduce the risk of fire or electric shock, do not overload AC outlets and 
extension cords.
10.Do not insert objects of any kind into this unit through openings, as they 
may touch dangerous voltage points or short out parts that could result in 
a risk of fire or electric shock. Never spill liquid of any kind on the unit.
11.To reduce the risk of electric shock, do not disassemble this unit. Only 
qualified personnel should service this unit. Opening or removing covers 
may expose you to dangerous voltages or other risks. Incorrect 
reassembly can cause electric shock.
12.Unplug this unit from the AC outlet and have the unit serviced by qualified 
service personnel in the following cases:
A.When the power supply cord or plug is damaged or frayed.
B.If liquid has been spilled on the unit.
C.If the unit has been exposed to rain or water.
D.If the unit does not work normally by following the manual. Adjust only 
controls covered by the manual. Improper adjustment may require 
repair by an authorized service center.
E.If the unit has been dropped, or damaged.
F.If the unit’s performance deteriorates.
13.Avoid using a telephone (other than a cordless type) during an electrical 
storm. There is a remote risk of electric shock from lightning.
14.Do not use the telephone in the vicinity of a gas leak to report the leak.
SAVE THESE INSTRUCTIONS
NT321M_QRG.fm  Page 16  Tuesday, January 15, 2008  4:51 PM 
						

							Important Information
17 Document Version 2008-05
FCC Information
F.C.C. REQUIREMENTS AND RELEVANT INFORMATIONThis equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation.
This equipment generates, uses, and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following 
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
CAUTION:To assure continued compliance with FCC rules, do not make any 
unauthorized changes or modifications to this equipment would void the 
user’s authority to operate this device.
When programming emergency numbers and/or making test calls to 
emergency numbers:
1) Remain on the line and briefly explain to the dispatcher the reason for the 
call before hanging up.
2) Perform such activities in the off peak hours, such as early morning hours 
or late evenings.
FCC Declaration of ConformityTrade Name: Panasonic
Model Number: KX-NT321
Responsible Party: Panasonic Corporation of North America
One Panasonic Way
Secaucus, NJ 07094 U.S.A.
Telephone No.: 1-800-211-PANA (7262)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not 
cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation.
NT321M_QRG.fm  Page 17  Tuesday, January 15, 2008  4:51 PM 
						

							Important Information
18Document Version 2008-05
Customer Information
This equipment complies with Part 68 of the FCC rules and the requirements 
adopted by the ACTA. On the bottom of the cabinet of this equipment is a 
label that contains, among other information, the following product identifier:  
US: ACJKXNANKX-NT321
 If requested, this number must be provided to the telephone company.
If trouble is experienced with this equipment KX-NT321, for repair or warranty 
information, please contact:
Panasonic Service and Technology Company-BTS Center
415 Horizon Drive Bldg. 300 Ste. 350-B
Suwanee, GA 30024-3186
If the equipment is causing harm to the telephone network, the telephone 
company may request that you disconnect the equipment until the problem is 
resolved.
Hearing Aid Compatibility:This telephone provides magnetic coupling for hearing aids.
NT321M_QRG.fm  Page 18  Tuesday, January 15, 2008  4:51 PM 
						

							Wall Mounting Template
19 Document Version 2008-05
Wall Mountin g Te mpla te
83 mm (3-1/4 in)  100 mm (3-15/16 in)
for base unit
One screw here
One screw at either point
WALL MOUNTING TEMPLATE
1. Drive the screws into the wall as indicated.
2. Hook the unit onto the screw heads.
Note:
Make sure to set the print size to correspond with 
the size of this page. If the dimensions of the paper 
output still deviate slightly from the measurements 
indicated here, use the measurements indicated 
here.
NT321M_QRG.fm  Page 19  Tuesday, January 15, 2008  4:51 PM 
						

							PSQX4664ZA-UU     KK0508YH0 (M) (Ver 0.02) Panasonic Consumer Electronics Company,
Division of Panasonic Corporation of North America
One Panasonic Way Secaucus, New Jersey 07094
Panasonic Puerto Rico, Inc.San Gabriel Industrial Park Ave. 65 de Infantería, Km. 9.5
Carolina, Puerto Rico 00985
http://www.panasonic.com/csd
Copyright:This material is copyrighted by Panasonic Communications Co., Ltd., and 
may be reproduced for internal use only. All other reproduction, in whole or in 
part, is prohibited without the written consent of Panasonic Communications 
Co., Ltd.
© 2008 Panasonic Communications Co., Ltd. All Rights Reserved.
NT321M_QRG.fm  Page 20  Tuesday, January 15, 2008  4:51 PM