Panasonic Hdc Sd60 Operating Instructions

21VQT2M51
Preparation
Setup
1
Power supply
∫About batteries that you can use with this unit
The battery that can be used with this unit is VW-VBK180/VW-VBK360.
≥This unit has a function to distinguish the batteries that can be used, and the 
batteries (VW-VBK180/VW-VBK360) that are compatible with this function. (The 
batteries that are not compatible with this function cannot be used.)
It has been found that counterfeit battery packs which look very similar to the genuine 
product are made available to...

22VQT2M51
≥Press the power button to turn off the power. ( l28)
Install the battery by inserting it in the direction shown in the figure.
Inserting/removing the battery

Removing the batteryBe sure to hold down the power button until 
the status indicator goes off. Then remove 
the battery while supporting the unit to 
prevent it from dropping.
Move the battery release lever in the 
direction indicated by the arrow and 
remove the battery when unlocked.
0ã0â0õ0õ0æ0ó0ú
A Insert the battery until it...

23VQT2M51
Important:
≥Use the supplied AC adaptor. Do not use the AC adaptor of another device.
≥ Do not use the AC cable with any other equipment as it is designed only for this unit. 
Also, do not use the AC cable from other equipment with this unit.
≥ The battery can also be charged using a battery charger (VW-BC10PP; optional).
≥ The battery will not be charged if the power is turned on.
A DC input terminal
1Connect the AC adaptor to the DC input terminal.
2Connect the AC cable to the AC adaptor,...

24VQT2M51
∫Charging/Recording time
≥Temperature: 25 oC (77 oF)/humidity: 60%
Charging and recording time
HDC-SD60
Battery model 
number
[Voltage/Capacity  (minimum)]Charging timeRecording modeMaximum 
continuous 
recordable timeActual 
recordable 
time
Supplied battery/
VW-VBK180 (optional)
[3.6 V/1790 mAh] 2h50minHA/HG/HX 1 h 45 min
55 min
HE 1 h 50 min
VW-VBK360 
(optional)
[3.6 V/3580 mAh] 4h50minHA
3 h 35 min
1h50min
HG 3 h 40 min
HX/HE 3h40min 1h55min
HDC-TM55/HDC-TM60
Battery model  number...

25VQT2M51
≥These times are approximations.
≥ The indicated charging time is for when the battery has been discharged completely. 
Charging time and recordable time vary depending on the usage conditions such as 
high/low temperature.
≥The actual recordable time refers to the recordable time when repeatedly starting/stopping 
recording, turning the unit on/off, moving the zoom lever etc.
≥ The batteries heat up after use or charging. This is not a malfunction.
HDC-HS60
Battery model 
number...

26VQT2M51
Preparation
Setup
2
Recording to a card
The unit can record still pictures or motion pictures to an SD card, built-in memory or HDD. 
To record to an SD card, read the following.
Use SD cards conforming to Class 4 or higher of the SD Speed Class Rating* for 
motion picture recording.
* The SD Speed Class Rating is the speed standard for successive writes.
≥ 4 GB or more Memory Cards that do not 
have the SDHC logo or 48 GB or more 
Memory Cards that do not have the SDXC 
logo are not based on...

27VQT2M51
Caution:Check that the access lamp has gone off.
1Open the LCD monitor.
2Open the SD card cover and 
insert (remove) the SD card 
into (from) the card slot B.
≥Face the label side  C in the direction 
shown in the illustration and press it 
straight in as far as it will go.
≥ Press the center of the SD card and then 
pull it straight out.
3Securely close the SD card cover.
≥Securely close it until it clicks.
≥Do not touch the terminals on the back of 
the SD card.
≥ Do not apply strong shocks,...

28VQT2M51
Preparation
Setup
3
Turning the unit on/off
You can turn the power on and off using the power button or by opening and closing the LCD 
monitor.
Press the power button to turn on the power.
AThe status indicator lights on.
Power is turned on when the LCD monitor is opened, and power is turned off when it is 
closed.
During normal use, opening and closing of the LCD monitor can be conveniently used 
to turn the power on/off.
∫ To turn on the power
A The status indicator lights on.
∫To turn off...

29VQT2M51
Preparation
Setup
4
Selecting a mode
Change the mode to recording or playback.
Operate the mode switch to change the mode to  ,  or .
Motion Picture Recording Mode (l34)
Still Picture Recording Mode ( l36)
Playback Mode ( l40, 78)
HDCSD60_TM60_HS60-P_PC-VQT2M51_eng.book  29 ページ  ２０１０年１月１８日　月曜日　午前１１時３３分 

30VQT2M51
Preparation
Setup
5
Adjusting LCD monitor
You can operate by directly touching the 
LCD monitor (touch screen) with your finger.
It is easier to use the stylus pen (supplied) 
for detailed operation or if it is hard to 
operate with your fingers.
∫Touch
Touch and release the touch screen to select 
icon or picture.
≥Touch the center of the icon.
≥ Touching the touch screen will not operate 
while you are touching another part of the 
touch screen.
∫ About the operation icons
///:
These icons...