Panasonic Hdc Sd5 Operating Instructions

21VQT1H62
Before using
Rotate the lens hood 
counter-clockwise A to remove it. In 
order to attach it, place into slot B, 
and then rotate it clockwise C.
≥When fitting the tele conversion lens 
(VW-T3714H; optional) or the wide conversion 
lens (VW-W3707H; optional), first remove the 
lens hood.
(Refer to the operating instructions for the tele 
conversion lens or the wide conversion lens.)
The tripod receptacle is a hole used to mount a 
tripod for the unit. Use of Panasonic’s VW-CT45 
(optional)...

22VQT1H62
Before using
2Adjust the angle of the LCD 
monitor as desired.
≥It can be rotated 180° towards the lens A and 
90° towards the opposite direction B.
≥The brightness and color level of the LCD 
monitor can be adjusted. (l40)
≥The unit may be damaged or fail if the LCD 
monitor is forcibly opened or rotated.
≥Check that the terminal cover is closed before 
closing the LCD monitor.
≥Close the LCD monitor properly.
Using the remote control
1 Photoshot button [ ]*
2 On-screen display button [EXT...

23VQT1H62
Before using
ªInstall a button-type battery
Install the supplied button-type battery in the 
remote control before using it.
1While pressing the stopper A, 
pull out the battery holder.
2Set the button-type battery with 
its (i) mark facing upward and 
then put the battery holder back 
in place.
Concerning the button-type battery
≥When the button-type battery runs down, 
replace it with a new battery (part number: 
CR2025). The battery should normally last 
about 1 year, however this depends on...

Before using
24VQT1H62
Cards that you can use with this unit
* The recording may suddenly stop during motion picture recording depending on the SD card you use. 
(l44)
ªHandling precautions
≥Do not expose the terminals of the card to water, debris, dirt or dust.
≥Do not place in the following areas:
jIn direct sunlight.
jIn very dusty or humid areas.
jNear a heater.
jLocations susceptible to significant difference in temperature (condensation can occur).
jWhere static electricity or electromagnetic waves...

Before using
25VQT1H62
ªAbout SD cards that you can use for motion picture recording
We recommend using SD Memory cards and SDHC Memory cards conforming to Class 2 or higher of 
the SD Speed Class Rating or the following SD cards made by Panasonic for motion picture recording.
*1 No longer made.
*2 Available from Sep. 2007
≥Operation in motion picture recording is not guaranteed with an SD card memory from 32 MB to 8 GB 
except the cards above. (The recording may suddenly stop during motion picture...

26VQT1H62
Setup
Setup
Charging the battery
When this unit is purchased, the battery is not 
charged. Charge the battery before using this 
unit.
≥Connect the battery to an AC adaptor to 
recharge it.
≥Refer to page 28 concerning batteries that 
can be used with this unit.
1Connect the AC cable to the AC 
adaptor and the AC outlet.
≥Remove the DC cable beforehand.
2Put the battery on the battery 
mount by aligning the mark, and 
then securely plug it in.
≥The output plug of the AC cable is not 
completely...

27VQT1H62
Setup
Inserting/removing the battery
1
While sliding the SD CARD/
BATTERY OPEN lever A, move 
the SD card/battery cover and 
open it.
2Insert the battery until it clicks 
while paying attention to the 
direction of the battery.
BPush the center of the battery until it locks.
3Close the SD card/battery cover.
≥Securely close it until it clicks.
1Open the SD card/battery cover.
2Remove the battery.
≥Move A in the direction of the arrow to unlock 
it and then remove the battery.
3Close the SD...

Setup
28VQT1H62
Charging and recording time
ªAbout batteries that you can use for this unit
The Panasonic battery that can be used with this unit is VW-VBG130/VW-VBG260/VW-VBG6.
VW-VBG130/VW-VBG260/VW-VBG6 come with a function to check whether the battery and unit can 
be safely used together.
≥The battery pack holder kit VW-VH04 (optional) is necessary if using VW-VBG260/VW-VBG6.
≥Batteries made by other companies which have been certified by Panasonic may be used with this 
unit, but we offer no...

Setup
29VQT1H62
≥The recordable times will vary depending on the status of use. These times are approximations.
≥The recordable time will become shorter in the following case:
jWhen you use this unit with the LCD monitor lit up by pressing the POWER LCD EXTRA button.
≥The batteries heat up after use or charging. This unit will also heat up while being used. This is not a 
malfunction.
≥Be aware that the operating time of the battery will become shorter in low temperatures. We 
recommend charging a spare...

30VQT1H62
Setup
Connecting to the AC outlet
1
Connect the AC cable to the AC 
adaptor and the AC outlet.
2Connect the DC cable to the AC 
adaptor.
3While sliding the SD CARD/
BATTERY OPEN lever A, move 
the SD card/battery cover and 
open it.
4Open the battery cable cover.
5Attach the DC cable.
BPush the center until it locks.
6Close the SD card/battery cover.
≥Securely close it until it clicks.
≥Pass the DC cable through the SD card/battery 
cover as shown in the illustration.
≥Do not use the AC cable...