Panasonic Dmc Ft1 Operating Instructions Manual

							- 161 -
Connecting to other equipment
Printing the Pictures
If you connect the camera to a printer supporting PictBridge, you can select the pictures to 
be printed out and instruct that printing be started on the camera’s LCD monitor.
Preparations:
Turn on the camera and the printer.
Remove the card before printing the pictures in the built-in memory.
Perform the print quality and other settings  at the printer before printing the pictures.
Set the mode dial to anything except [ ¨].
A USB connection cable (supplied)•Check the directions of the connectors, and plug them straight in or unplug them straight out. 
(Otherwise the connectors may be bent out of shape which will cause trouble.)
B Align the marks, and insert.
•Use a battery with sufficient battery power or the AC adaptor (optional). When using the AC 
adaptor (optional), use the multi conversion adaptor (optional). If the remaining battery power 
becomes low while the camera and the printer are connected, the status indicator blinks and 
the alarm beeps. If this happens during printing , stop printing at once. If not printing, disconnect 
the USB connection cable.
Connect the camera to a printer via the USB connection cable  A 
(supplied).
•When the camera is connected to the printer, the cable disconnect prohibit icon [ å] 
appears. Do not disconnect the USB cable while [ å] is displayed.
Press  3/4 to select [PictBridge(PTP)], and then 
press [MENU/SET].USB MODE
SELECT SET
PLEASE SELECT 
THE USB MODE
PictBridge(PTP)PC 
						

							Connecting to other equipment
- 162 -
Note
•Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
•Turn the camera off before connecting or disconnecting the AC adaptor (optional).•Before inserting or removing a card, turn the camera off, and disconnect the USB connection 
cable.
•You cannot switch between the built-in memory and the card while the camera is connected to 
the printer. Disconnect the USB connection cable, insert (or remove) the card and then connect 
the USB connection cabl e to the printer again.
•The pictures recorded in clipboard mode, copy them onto a card  (P121), and then print them 
out.
•HDMI connection is disabled and connection with the USB connection cable will take priority 
when you connect the USB connection cable while the HDMI mini cable is connected  (P148).
Selecting a single picture and printing it
Press  2/1 to select the picture and then press 
[MENU/SET].
•The message disappears in about 2 seconds.
Press  3 to select [PRINT START] and then press 
[MENU/SET].
•Refer to  P164 for the items which can be set before starting to 
print the pictures.
•Press [MENU/SET] to cancel printing halfway.•Disconnect the USB connecti on cable after printing.
PictBridge
MULTI PRINT
100-0001
100-0001
PLEASE SELECT
THE PICTURE TO PRINT
SELECTPRINT
12
OFF
1
CANCEL SELECT SET
PRINT START
PRINT WITH DATE
NUM. OF PRINTS
PAPER SIZE
PAGE LAYOUT
SINGLE SELECT 
						

							- 163 -
Connecting to other equipment
¢Only when [FAVORITE] is at [ON] and when there are pictures set as favourites.  (P140)
Selecting multiple pictures and printing them
Press  3.
Press  3/4 to select an item and then press [MENU/
SET].
•If the print check screen has appeared, select [YES], and print 
the pictures.
ItemDescription of settings
[MULTI SELECT] Multiple pictures are printed at one time.
•Press 
3/4/ 2/1 to select the pictures, and then When [DISPLAY] is 
pressed, [é] appears on the pictures to be printed. (When [DISPLAY] is 
pressed again, the setting is cancelled.)
•After the pictures have been selected, press [MENU/SET].
[SELECT ALL] Prints all the stored pictures.
[PRINT SET 
(DPOF)] Prints the pictures set in [PRINT SET] only. 
(P141)
[FAVORITE]
¢Prints the pictures set as favourites only.  (P140)
Press 3 to select [PRINT START] and then press 
[MENU/SET].
•Refer to  P164 for the items which can be set before starting to 
print the pictures.
•Press [MENU/SET] to cancel printing.•Disconnect the USB connecti on cable after printing.
MULTI SELECT
SELECT ALL 
PRINT SET (DPOF) 
FAVORITEPictBridge
CANCEL SELECT SET
OFF
1PRINT START PRINT WITH DATE
NUM. OF PRINTS
PAPER SIZE
PAGE LAYOUT
MULTI SELECT
CANCEL
SELECT SET 
						

							Connecting to other equipment
- 164 -
Select and set the items both on the screen in step 2 of the 
“Selecting a single picture and printing it” and in step 3 of the 
“Selecting multiple pictures and printing them” procedures.
•
When you want to print pictures in a paper size or a layout which is not 
supported by the camera, set [PAPER SIZE] or [PAGE LAYOUT] to [ {] 
and then set the paper size or the layout on the printer. (For details, 
refer to the operating instructions of the printer.)
•When [PRINT SET (DPOF)] has been selected, the 
[PRINT WITH DATE] and [NUM. OF PRINTS] items are not displayed.
•If the printer does not support date printing, the date cannot be printed on the picture.•Since the printer’s settings may take precedence over the print with date setting, check the 
printer’s print with date setting as well.
•When printing images with a text stamp, please remember to set print with date to [OFF] or the 
date will print on top.
NoteWhen asking the photo shop to print the pictures•By stamping the date using [TEXT STAMP]  (P134) or setting date printing at the time of the 
[PRINT SET]  (P141) setting before going to a photo shop, the dates can be printed at the photo 
shop.
You can set the number of prints up to 999.
Print Settings
[PRINT WITH DATE]
ItemDescription of settings
[OFF] Date is not printed.
[ON] Date is printed.
[NUM. OF PRINTS]
OFF
1
CANCEL SELECT EXIT
PRINT START
PRINT WITH DATE
NUM. OF PRINTS PAPER SIZE
PAGE LAYOUT
MULTI SELECT 
						

							- 165 -
Connecting to other equipment
•Paper sizes not supported by the printer will not be displayed.
[PAPER SIZE]
ItemDescription of settings
{  Settings on the printer are prioritised.
[L/3.5 qk5q]
89 mmk127 mm
[2L/5 qk7q] 127 mmk178 mm
[POSTCARD] 100 mmk148 mm
[16:9] 101.6 mmk180.6 mm
[A4] 210 mmk297 mm
[A3] 297 mmk420 mm
[10 k15cm] 100 mmk150 mm
[4 qk6 q] 101.6 mmk152.4 mm
[8 qk10 q] 203.2 mmk254 mm
[LETTER] 216 mmk279.4 mm
[CARD SIZE] 54 mmk85.6 mm 
						

							Connecting to other equipment
- 166 -
•An item cannot be selected if the printer does not support the page layout.
∫Layout printing
When printing a picture several times on 1 sheet of paper
For example, if you want to print the same picture 4 times on 1 sheet of paper, set 
[PAGE LAYOUT] to [ ä] and then set [NUM. OF PRINTS] to 4 for the picture that you 
want to print. 
When printing different pictures on 1 sheet of paper
For example, if you want to print 4 di fferent pictures on 1 sheet of paper, set 
[PAGE LAYOUT] to [ ä] and then set [NUM. OF PRINTS] to 1 for each of the 4 pictures.
Note
•
The camera is receiving an error message from the printer when the [ ¥] indication lights 
orange during printing. After finishing printing, make sure there are no problems with the 
printer.
•If the number of prints is high, the pictures may be printed several times. In this case, the 
remaining number of prints indicated may differ from the number set.
[PAGE LAYOUT] (Layouts for printing that can be set with this unit)
ItemDescription of settings
{  Settings on the printer are prioritised.
á   1 picture with no frame on 1 page
â   1 picture with a frame on 1 page
ã   2 pictures on 1 page
ä   4 pictures on 1 page 
						

							- 167 -
Others
OthersScreen Display
∫In recording
Recording in normal picture mode [ !] (Initial setting)
1 Recording mode
2 Flash mode  (P56)
3 AF area  (P45)
4 Focus  (P45)
5 Picture size  (P100)
6 Quality  (P101)
7 Battery indication  (P17)
8 Number of recordable pictures  (P189)
9 Built-in memory  (P22)
: Card (P22)  (displayed only during 
recording)
10 Recording state
11 ISO sensitivity (P103)
12 Shutter speed  (P45)
13 Aperture value  (P45)
14 Quick AF  (P110)
: Continuous AF  (P88, 110)
15 Optical image stabilizer (P114) / : Jitter alert (P46)
16 REC MODE (P85) /Recording quality (P85)
F3.3F3.3F3.31/301/301/30ISOISO 100 100ISO 100
 
						

							Others
- 168 -
∫In recording (after settings)
17 AF Tracking  (P109)
: AF macro mode  (P61)
: Macro zoom mode  (P61)
18 White balance  (P104)
19 ISO sensitivity (P103) maximum ISO sensitivity level  (P102)
20 Colour mode  (P113)
21 Available recording time  (P81):
22 Spot AF area  (P107)
23 Name
¢1  (P73)
24 Histogram  (P55)
25 Travel date  (P95)
26 Elapsed recording time  (P81)
AF tracking operation (P42 , 109)
: Intelligent ISO (P102)
27 Current date and time/ “: Travel destination setting¢2 (P98)
: Zoom/Extra optical zoom (P47) /Digital zoom (P47, 113)
28 Minimum shutter speed
29 Age
¢1  (P73)
Location¢ 2 (P95)
30 Exposure compensation  (P64)
31 Power LCD  (P31)/
„ : Auto Power LCD  (P31)
32 Intelligent Exposure  ( P 111 )
33 Burst  (P112)/ : Auto bracket  (P65)/B: Audio recording  (P115)
34 AF assist lamp (P116) /
: AF Lock (P80)
35 Number of days that have passed since the travel date  (P95)
36 Self-timer mode  (P63)
37 WIND CUT (P89)
38 LED light  (P90)
¢
1 This is displayed for about 5 seconds when this unit is turned on in [BABY1]/[BABY2] or 
[PET] in scene mode.
¢2 This is displayed for about 5 seconds when the camera is turned on, after setting the clock and after switching from playback mode to recording mode.
R8m30s
WT1XW 
						

							- 169 -
Others
∫In playback
1 Playback mode  (P49)
2 Protected picture  (P143)
3 Favourites  (P140)
: Zoom mark  (P120)
4 Stamped with text indication (P134)
5 Picture size  (P100)
6 Quality  (P101)
7 Battery indication  (P17)
8 Folder/File number  (P159)
Built-in memory  (P22)
Elapsed playback time  (P129):
9 Picture number/Total pictures
10 Motion picture recording time  (P129):
11 Histogram  (P55)
12 Exposure compensation  (P64)
13 Recording information  (P54)
14 Favourites settings  (P140)
15 Recorded date and time/Travel destination setting (P98) /Name (P73)/Location  (P95)/
Title  (P132)
16 Age  (P73)
17 Number of days that have passed since the travel date  (P95)
18 Power LCD  (P31)
19 Number of prints  (P141)
20 Audio playback (P129) : Motion picture playback  (P129)/Rec quality  (P85)
Cable disconnection warning icon  (P161)
1
11/6 1/6
1/6
10:00  1.DEC.2009
10:00  1.DEC.2009
10:00  1.DEC.2009
8m30s
8m30s 
						

							Others
- 170 -
Cautions for Use
•This camera has a waterproof/dustproof function equivalent to IP58. It is possible to take 
pictures in 3.0 m depth for 60 minutes.¢1
¢1 This means that the camera can be used underwater for specified time in specified pressure 
in accordance with the handling method established by Panasonic. This does not guarantee 
no destruction, no malfunction, or waterproofing in all conditions.
•Supplied accessories are not waterproof.•The camera has cleared a drop test from a height of 1.5 m onto 5 cm thick plywood, which is 
compliant with “MIL-STD 810F Method 516.5-Shock”¢2
¢2 This does not guarantee no destruction, no malfunction, or waterproofing in all conditions.Waterproofing is not guaranteed if the unit is subj ect to an impact as a result of being hit or 
dropped etc.
When an impact is applied to the camera, it is  recommended to consult the dealer or your 
nearest Service Centre, and perform a check up (subject to a fee) to see if the 
waterproofing has been retained properly.
For more detail, refer to “(Important) About the waterproof/dustproof and anti-shock 
performance of the camera”  (P7).
(Important) About the waterproof/dustproof and anti-shock performance 
of the camera