Panasonic Cw Xc181ea Cw Xc241ea Repair Manual

11.3.7. Insert the Air Filter.
11.4.1. Remove the Front Intake Grille.
 
    • 
• •  • Raise the Front Intake Grille by approximately 90°. Slide it
to the left to unhinge then pull outwards.
11.4.2. Remove the Air Filter.
 
    • 
• •  • Lift the air filter by the holder and pull outwards.
11.3.8. Attach the Front IntakeGrille.
 
    • 
• •  • Slide the Front Intake Grille slightly to the right to attach it,
then push down to secure it.
11.4.3. Remove the Front Grille.
 1. Press inward on the Cabine t...

 3. Install the Drain Pan at the right corner of the Cabine t with
2 screws.
12.1. Cleaning the Unit.
Clean the Cabine t, Front Grille with a mild soap or detergent
and lukewarm water.
12.2. Cleaning the Front Intake
Grille.
Gently wash with water and a sponge. (Do not use a scrubbing
brush or other hard cleanin g aids).
 4. Conne ct the drain hose to the outlet of Drain Pan bottom.
 5. Slide the Chassis back into the Cabine t.
Note: Drain hose or tubing can be purchased locally to satisfy
your...

 1. Remove the Front Intake Grille (refer to page 20).
 2. Remove the Air Filter (refer to page 20).
 3. Remove the Front Grille (refer to page 20).
 4. Remove the 3 screws from the Control Board (Front).
Releas e the earth wire (Yellow-Green) screw.
 5. Releas e the sensor thermostat from the holder sensor.
 6. Slide the Control Board (Main) outfrom the chassis.
 7. Press left and right side tab to release the Control Board
(Front).
 8. Electronic Controller (Indicator Complete) is attached inside
the...

14.2.1. CW-XC181EA.
14.2.1.1. Cooling Characteristics Vs.
Outdoor Temperature.14.2.2. CW-XC241EA.
14.2.2.1. Cooling Characteristics Vs.
Outdoor Temperature.
14 Technical Data
14.1. Thermostat Characteristics.
14.2. Operation Characteristics.
24
CW-XC18 1EA / CW-XC24 1EA 

15 Electronic Circuit / Main
16 Electronic Circuit / Indicator Complete
25
CW-XC18 1EA / CW-XC2 

17 Electronic Circuit Diagram
17.1. Electronic Circuit Diagram (Main Unit).
26
CW-XC18 1EA / CW-XC24 1EA 

27
CW-XC18 1EA / CW-XC2 

Before using the circuit diagram, read the following carefully.
 
    • 
• •  • Voltage measurement
Voltage has been measured with a digital tester when the
fan is set at high fan speed under the following conditions
without setting the timer.
Use them for servicing.
Voltage indication is in red.
Intake air
temperatureTemperatu re
settingDischarge air
temperaturePipe
temperature
Cooling27°C16°C17°C15°C
 
    • 
• •  • Indications for resistance
 
    − 
− −  − a. K...KΩ
b. W...WATT
c. M...MΩ
d. Not...

18 Exploded View
(Note)
 
    • 
• •  • The above exploded view is for the purpose of parts disassembly and replacement.
 
    • 
• •  • The non-numbered parts are not kept as standard service parts.
29
CW-XC18 1EA / CW-XC2 

19 Replacement Part List
Ref. No.Part Name & DescriptionQty.CW-XC181EACW-XC241EA100Base Pan Complete1CWD52K1023ACWD52K1047A101Bulkhead Complete1CWD531007CWD53K1007102Air Guide - Propeller Fan1CWD311010CWD311011103Bracket - Fan Motor1CWD54091CWD54142106Top Plate1CWD64C1007CWD64C1008109Drain Tray - Evaporator1CWH401013