Panasonic Cd Player Receiver Cq Dfx301 Operating Instructions

							This unit is equipped with a removable face plate. Removing
this face plate makes the radio totally inoperable.
Place Removable Face Plate
into Case
qSwitch off the power of the unit.
wRemove the removable face plate. (aPage 20)
eGently press the bottom of the case and open the cover.
Place the face plate into the case and take it with you
when you leave the car.
Install Removable Face Plate
qFit the face plate with its right or left hole on one of the
pins provided on the main unit.
wFit the other hole on the other pin applying slight pres-
sure.
eMove the face plate up and down a few times to make
sure it is secure.  Then close the front panel and press
down the right side of the face plate until it clicks into
place.
Panel Removal Alarm
This alarm sounds to warn you not to forget to remove the
panel before leaving your car.
qPress and hold [SEL]to change to display control
mode. (“PATTERN” is displayed.) (aPage 8)
wPress [SEL].  “LED On” or “LED OFF” is displayed.
ePress []TUNE]or [[TUNE]to turn the Panel
Removal Alarm on or off. (LED ON or OFF)
Anti-Theft System
Cautions:
¡This face plate is not water-proof. Do not expose it to water or excessive moisture.
¡Do not remove the face plate while driving your car.
¡Do not place the face plate on the dashboard or nearby areas where the temperature rises to high levels.
DisplayPanel Removal
Alarm
ON
OFF
21CQ-DFX301N
16
E
N
G
L
I
S
H
rRemovable Face Plate Case
VOLSEL
SUB·W
OPEN
SOURCEPTYPWRMONO/LOC
TA TUNETRACKBAND
LOUDDISC 
AUTO·PREMOTE
CD RECEIVER WITH CHANGER CONTROL
CQ-DFX301N
EONEPTYECTCTR
EPEA
TSCAN RANDOMREGDISPAF123 4R
SCAN REP56 
						

							AB
22CQ-DFX301N
17
E
N
G
L
I
S
H
Cable Wiring Diagram
Example :Connection with CD changer CX-DP88N (Option)
Electrical Connections
Antenna
ePower
   Connector y ISO Antenna
Adapter
(White)
(Gray) (Green)
(Violet)
A
CD Receiver
CQ-DFX301N
R(Red) L(White)
Preamp Out Connector (Rear)
CD Changer Input Connector
(L)(White)
(R)(Red)
(If needed)CD Changer
Control 
Connector
Extension Cord 
 (DIN/BATT/RCA/GND)(Black)
CD Changer 
CX-DP88N
(Yellow)
Fuse (3A)
B (Brown)
(Violet w/black stripe)(Gray w/black stripe) (White w/black stripe) (Green w/black stripe)
Changer Control DIN Cord
RCA Cord
Speakers
Rear Left – Rear Left +
Front Left – Front Left +
Front Right – Front Right +
Rear Right – Rear Right + 
						

							* Telephone Mute
The sound from the speakers cannot be heard while the tele-
phone conversation is in progress.
** Navi Mute
The sound from the speakers cannot be heard while the naviga-
tion guide is on.
Cautions:
¡Check the connectors provided on your car (see note on page
4 and 5) before connecting the system.
¡This unit is designed for use in a car having a 12-volt negative
ground battery system.
¡To prevent damage to the unit, be sure to follow the connection
diagram below.
¡Strip about 5 mm of the lead ends for connection (only non-
ISO connector cords).
¡Do not insert the power connector into the unit until the wiring
is completed.
¡Be sure to insulate any exposed wires to prevent short circuit-
ing with the car chassis.  Bundle all cables, and prevent cable
terminals from touching any metal parts.
¡This unit can be connected to an optional CD changer (CX-
DP9061/DP9060EN, CX-DP88N, CX-DP801/DP803EN or CX-
DP601EN) and optional extension cord.
¡For details consult your nearest authorized Panasonic Dealer.
¡For connection to a CD changer, refer to the operating instruc-
tions of the CD changer (CX-DP9061/DP9060EN, CX-DP88N,
CX-DP801/DP803EN or CX-DP601EN).
C1 :(Orange)
Telephone Mute Lead (*)
Connect to the car telephone mute lead.
Note:The telephone mute lead is only for connection to the radio
mute lead.  Output other than telephone will not be muted
Navi Mute Lead (**)
To the Navi Mute lead of the Panasonic car navigation system.
A8 : Ground Lead(Black)
To a clean, bare metallic part of the car chassis
A7 : Power Lead (ACC or IGN)(Red)
To ACC power, +12 V DC
A4 : Battery Lead(Yellow)
To the car battery, continuous +12 V DC
A5 :(Dark blue)
Motor Antenna Relay Control Lead
(To Motor Antenna) (Max. 500mA)
This lead is not intended for use with a switch actuated power anten-
na.
Amp·Relay Control Power Lead
This lead is for connection to a Panasonic power amplifier.
(Yellow) (Red) (Black) (Orange)
A (Black)
(Dark blue)(Dark blue)
Resistor(1kΩ)
BATTERY 15A
ACC
A5
Fuse(15A)
Ground Lead
To a clean, bare metallic 
part of the car chassis
Battery Lead
To the car battery,
continuous +12V DC
B
23CQ-DFX301N
18
E
N
G
L
I
S
H 
						

							24CQ-DFX301N
19
E
N
G
L
I
S
HSpeaker Connections
Caution:Please follow the instructions given below.  Failure to do so will cause damage to the unit and speakers.
Fuse
Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or connecting the unit
directly without a fuse, could cause fire or damage to the unit.
If the replacement fuse fails, contact your nearest authorized Panasonic Service Center.
Maintenance
Your product is designed and manufactured to ensure the minimum of maintenance. Use a soft cloth for routine exterior
cleaning. Never use benzine, thinner, or other solvents.
L
R
- 
- 
- - 
- - 
- - 
- 
- +
+
++
++
+
++ +- +
- +
- +- +- +
- +- +- +
L
R
L
R
L
R


(White)
(White
w/black stripe)
Chassis
(Gray 
w/black stripe)(Gray)
Chassis
¡Use ungrounded speaker only.
¡The maximum speaker output should be 45 W or more.  (If used with
the optional power amplifier, the speaker output should be higher than
the maximum amplifier output.)
¡The speaker impedance should be 4 - 8 Ω.
¡This unit uses the BTCL circuit, so each speaker should be connected
separately using parallel vinyl insulated cords.
¡The speaker cords and the power amplifier unit should be kept away
(about 30 cm apart) from the antenna and antenna extension cord.
¡Never connect the speaker cord to
the body of the car.¡Do not use a 3-wire type speaker
system having a common earth
lead.¡Do not connect more than one
speaker to one set of speaker
leads. 
						

							25CQ-DFX301N
20
E
N
G
L
I
S
H
GeneralFM Stereo Radio
Specifications
Frequency Range : 87.5 - 108 MHz
Usable Sensitivity : 6 dB/µV(S/N 30 dB)
Stereo Separation : 35 dB (at 1 kHz)
Frequency Range : 531 - 1,602 kHz
Usable Sensitivity : 28 dB/µV (S/N 20 dB)
Frequency Range : 153 - 279 kHz
Usable Sensitivity : 32 dB/µV (S/N 20 dB)
Sampling Frequency : 8 times oversampling
DA Converter : MASH•1 bit/4 DAC System
Error Correction System : Panasonic Super Decoding
Algorithm
Pick-Up Type : Astigma 3-beam
Light Source : Semiconductor laser
Wavelength : 780 nm
Frequency Response : 20 Hz - 20 kHz (±1 dB)
Signal to Noise Ratio : 96 dB
Total Harmonic Distortion : 0.01 % (1 kHz)
Wow and Flutter : Below measurable limits
Channel Separation : 75 dB
CD Player
LW Radio
MW Radio
Power Supply : DC 12 V (11 V - 16 V), Test
Voltage 14.4 V, Negative
Ground
Tone Controls : Bass; ±12 dB at 100 Hz
Treble; ±12 dB at 10 kHz
Current Consumption : Less than 2.5 A (CD mode,
0.5 W 4-Speaker)
Maximum Power Output : 45 W x 4 (at 4 Ω) 
Power Output : 22 W x 4 
(DIN45 324, at 4 Ω) 
Speaker Impedance : 4 - 8 Ω
Pre-Amp Output Voltage : 2 V (CD mode)
Pre-Amp Output Impedance : 600 Ω
Dimensions (Main Unit) : 178(W) x 50(H) x 
150(D) mm
Weight (Main Unit) : 1.6 kg
Note:Specifications and design are subject to modification without notice due to improvements. 
						

							Matsushita Communication Deutschland GmbH
Lahnstraße 5
Industriegebiet Süd
24539 Neumünster, F.R. Germany
YEFM283650  SAH0201-0        Printed in Hungary
Matsushita Electric Industrial Co., Ltd.
Central P.O. Box 288, Osaka 542-8588, Japan