Panasonic Aj Lt85 Operating Instructions Manual

[7] Automatic Editing Control Section
qSPLIT button
For split editing, press this so that the button LED lights,
and then set the edit IN point to be split. Refer to set-up
menu item No.311 (SPLIT EDIT).
wLAST EDIT (CLEAR) button
LAST EDIT:This button accesses the previously pre-
viewed contents. (It alternately accesses two sets of con-
tents whose preview has been completed.)
CLEAR (SHIFT+LAST EDIT):These buttons delete the
registered event. The ÒdÓ display appears for EDL.
eÐ (BS) Minus trim button...

uIN button (for both VTR1 and VTR2)
Press this button while holding down the ENTRY button
to register the IN point of the player or recorder.
Press it alone to check the IN point. While it is held down,
the IN point appears on the display. To display the editing
duration, press the IN and OUT buttons together.
ÒÐ Ð:Ð Ð:Ð Ð:Ð ÐÓ is displayed when the edit IN and OUT
points are not registered.
iOUT button (for both VTR1 and VTR2)
Press this button while holding down the ENTRY button
to register the OUT...

[8] Side Panel Section (for both 
VTR1 and VTR2)
Signals conveyed via an internal connection cannot be
adjusted.
qVIDEO LEVEL control
This is used to adjust the video level of the VTRÕs video
output.
wSET UP control
This is used to adjust the set-up level of the VTRÕs video
output signals.
eHUE control
This is used to adjust the hue of the VTRÕs video output
signals.
rCHROMA LEVEL control
This is used to adjust the chroma level of the VTRÕs video
output signals.
tSYSTEM controls
H:This is used to adjust...

qDC IN socket (XLR 4P)
DC power input socket.
The AC adaptor AJ-B75 (optional accessory) must be
used to supply the power. The unitÕs operation cannot be
guaranteed if any other power supply is used instead.
wVIDEO IN connector (BNC)
The analog composite signal is supplied to this connector.
eVIDEO/Y OUT connector (BNC) (VTR2 only)
The analog composite signals are output from this con-
nector.  
The Y (luminance) signal is output when CMPNT has
been set for set-up menu item No.806 (V OUT SEL).
rPB...

Pull the lever and release the lock.
Do not take hold of the lever and use it to open the laptop.
Close the laptop while pushing the bottom of the lever, as
shown in the figure on the left.
!Push the bottom of the lever.
@Push up the lever.
Notes:
1.
2.
OPENING AND CLOSING THE LAPTOP
15
Opening and closing the laptop
HEADPHONES
0 (HEADPHONES
VTR1
VTR2
HEADPHONES
HEADPHONES
Take care not to catch your fingers in the cover while
opening or closing it.
Take care not to use this unit on bedding or a carpet. 

Description
This is exclusively designed for use in consumer-use cassette camera/recorder
units. It can be used with the laptop for playback only if the AJ-CS750P
cassette adaptor (option) is obtained.
If a consumer-use cassette tape is to be used, it must first be loaded into the
AJ-CS750P adaptor (optional accessory).
Use of Panasonic consumer DV cassette tapes is recommended.
Ensure that inserting such a tape directly without using the cassette adaptor
may cause trouble.
Recording/playback tape with a...

Connections for transmission
SYSTEM CONNECTIONS
17
System connections
Microwave
transmitter
VIDEO OUT
 connector
(OPERATION MODE switch: SEPARATE)DC IN
DC OUT
AC adaptor
AJ-B75 (option) AUDIO OUT
CH1/CH2
connector REF
VIDEO IN
connector
Reference signal
AC adaptorVTR 1 VTR 2 

System applications
nBackup recording using 2 VTRs
1. Recording the same signal on 2VTRs
SYSTEM CONNECTIONS
18
VIDEO IN VIDEO IN
VTR1 VTR2
Switch settings:
OPERATION MODE
VTR1 IN SEL
TC MODE: SEPARATE
: V2 V+A
: VTR1;
: VTR2;User preference (P-REC, P-FREE)
VTR1 TC
(Time codes synchronized on both
VTRs)
Switch settings:
OPERATION MODE
VTR1 IN SEL
TC MODE: SEPARATE
: V1 IN
: VTR1;
: VTR2;User preference (P-REC, P-FREE)
VTR1 TC
(Time codes synchronized on both
VTRs)
AJ-LT85
VIDEO IN
VTR1 VTR2
AJ-LT85
2....

System applications
nUsing the unit with an external effector or controller switch settings
SYSTEM CONNECTIONS
19
System connections
Switch setting
OPERATION MODE
PLAY DELAY
Refer to the items regarding the various editing controller
settings (included) for  more information.
EXT

VTR1; 
  VTR2;0
4 VIDEO IN PB VIDEO
OUT
VTR1 VTR2
AJ-LT85 Effector
Editing controller
REF
REF
9P 9P
REF

¥ VTR1 cannot be used as the editing recorder.
¥ Slow motion editing is not supported. 

SYSTEM CONNECTIONS
20
System applications
nUsing two VTRs as source units for AB roll editing

Slow motion editing is not supported.
VIDEO OUT PB VIDEO
OUT
VTR1 VTR2
AJ-LT85RECORDER
Editing controllerSwitcher
REF
REF REF
REF
9P 9P
Switch setting
OPERATION MODE
PLAY DELAYRefer to the items regarding the various
editing controller settings (included) for
more information.

SEPARATE

VTR1; 
  VTR2;0
0