Optoma Hd33 B Projector User Manual

English41
Appendices
SETUP | Signal -Video Source
White Level
Allow user adjust White Level when inputting S-Video or Video/
CVBS signals.
Black Level
Allow user adjust Black Level when inputting S-Video or Video/
CVBS signals.
Saturation
Adjust a video image from black and white to fully saturated color.
Press the ◄ to decrease the amount of color in the image. `
Press the ► to increase the amount of color in the image. `
Hue
Adjust the color balance of red and green.
Press the ◄ to increase the amount...

English42
Appendices
Troubleshooting
If you experience a problem with your projector, please refer to 
the following information. If a problem persists, please contact 
your local reseller or service center.
Image Problems
  No image appears on-screen
Ensure all the cables and power connections are correctly and  `
securely connected as described in the “Installation” section.
Ensure the pins of connectors are not crooked or broken. `
Check if the projection lamp has been securely installed.  `
Please...

English43
Appendices
  Image has slanted sides:
If possible, reposition the projector so that it is centered on the  `
screen and below the bottom of the screen.
Use “Display-->V Keystone” from the OSD to make an adjust- `
ment.
  Image is reversed
Select “System-->Projection” from the OSD and adjust the  `
projection direction.
  Blurry double image
Press “3D Format” button and switch to “Off” to avoid normal\
  `
2D image is blurry double image.
  Two images, side-by-side format
Press “3D Format”...

English44
Appendices
Other Problems
  The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord  `
and wait at least 20 seconds before reconnecting power.
  Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may  `
make a loud popping sound.  If this happens, the projector 
will not turn on until the lamp module has been replaced. To 
replace the lamp, follow the procedures in the “Replacing the 
Lamp”...

English45
Appendices
Power LED on:  ™No signal; OSD menu appears and signal had been detected.
Power LED off:  ™Signal had been detected but OSD menu disappears.
HDMI 1HDMI 2VGAYPbPrYGPb BPrR
VIDEO SERVICE RS-232
12V Trigger
3D SYNCOut (5V)
POWER
HDMI 1
HDMI 2
VGAYPbPrYGPb BPrR
VIDEO SERVICE RS-232
12V Trigger
3D SYNCOut (5V)
POWER
LED Lighting Messages
NOTEMessagePower LED(Red)Power LED(Blue)Temp LED(Red)Lamp LED(Orange)
Standby State(Input power cord)Steady lightOffOffOff
Power on...

English46
Appendices
Power down timer active: ™
Lamp warning: ™
Power off: ™
On Screen Messages 

English47
Appendices
The projector automatically detects the lamp life. When the 
lamp life is nearing the end of use, you will receive a warning 
message.
When you see this message, please contact your local reseller or 
service center to change the lamp as soon as possible. Make sure 
the projector has been cooled down for at least 30 minutes before 
changing the lamp.
 Warning: If ceiling mounted, please use caution when open-
ing the lamp access panel. It is recommended to wear safety 
glasses if...

English48
Appendices
1
2
3
4
The projector can- ™not be turned on if the lamp cover has not been placed back on the projector.
Do not touch the  ™glass area of the lamp. Hand oil can cause the lamp to shatter. Use a dry cloth to clean the lamp module if it was accidentally touched.
NOTE
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the Power  
button.
2. Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4. Unscrew the two screws...

English49
Appendices
Compatibility Modes
Computer Compatibility for PC ™
SignalResolutionFrequency H. (KHz) Refresh Rate (Hz)VideoDigitalAnalog
NTSC-15.73460O--
PAL/SECAM
-15.62550O--
720 x 40031.570-OO
720 x 40037.985-OO
720 x 57650-OO
VGA
640 x 48031.560-OO
640 x 48067-OO
640 x 48037.972.8-OO
640 x 48037.575-OO
640 x 48043.385-O
SVGA
800 x 60035.256.3-OO
800 x 60037.960.3-OO
800 x 60046.975-OO
800 x 60048.172.2-OO
800 x 60053.785.1-O
XGA
1024 x 76848.460-OO
1024 x 76856.570.1-OO
1024 x 7686075-OO...

English50
Appendices
Computer Compatibility for MAC ™
ResolutionRefresh Rate (Hz)
Macbook compatibilityMacbook Pro (Intel) compatibilityPower Mac G5 compatibilityPower Mac G4 compatibility
DigitalAnalogDigitalAnalogDigitalAnalogDigitalAnalog
800 x 60060OOOO--OO
800 x 60072OOOO-OOO
800 x 60075OOOO-OOO
800 x 60085-O-O-O-O
1024 x 76860OOOO-OOO
1024 x 76870OOOO-OOO
1024 x 76875OOOO-OOO
1024 x 76885-O-O-O-O
1280 x 72060OOOO-OOO
1280 x 76860OOOO--OO
1280 x 76875-O-O-O-O
1280 x 76885-O-O---O
1280 x...