Nortel Business Communications Manager Ata2 Instructions Manual




P0941629 
	


	
Priority Call


Allows you to interrupt an internal call in progress on a digital telephone, or make 
a voice call to a digital telephone on Voice Call Deny or Do Not Disturb. The 
session in progress is automatically put on hold.
Note:Priority Call must be enabled in Business Communications Manager 
System Administration.
Privacy Control


Prevents another telephone that shares your line from joining your current...




	


	P0941629
Saved Number Redial



Allows you to save an external number while you are on a call or while the called 
telephone is ringing. To automatically redial the saved number:
1. Press 

.
Send Message


Allows you to leave a message on a co-worker’s telephone.
To cancel send message, press 

Ser vice Mode
In service mode the ATA 2 telephone can be assigned as the control telephone for 
one or more lines, or as the night...




P0941629 
	


	
Tr a n s f e r
Allows you to transfer a call. To transfer a call you must have an available intercom 
line.
Blind Transfer
1. Press 

. 
2. Press the transfer destination number.
3. Replace the handset.
Transfer using announce
1. Press 

 (intercom dial tone is heard).
2. Press the transfer destination number.
3. Announce the call to the receiving party (optional).
4. Replace the handset.
Transfer using Conference
1....

\b\f


\b	

\f
	\f\f P0941629
Trunk Answer from any Telephone

\f\f
Allows you to pick up a ringing external call on a line that has been placed into any 
service mode.
Voice Call

  
Allows you to make a voice announcement or begin a conversation through the 
speaker of a digital telephone without making the other telephone ring.
Voice Messaging
Press the Business Communications Manager extension, or 


  . 
Allows you to access your...

P0941629 
	


	
Data Communication
This section supplies additional information for using Business Communications 
Manager Analog Terminal Adapter 2 with data communication devices.
Set Tones to OFF 
ATA 2 must have tones OFF so tones do not interfere with data transmissions.
The following progress tones are not heard when ATA 2 is in the tones OFF mode:
• Held Line Reminder
• Call Waiting
• Ring Again 
To turn tones OFF:
Lift the handset and press 
...



	


	

	


	P0941629 

P0941629 
	


	
Troubleshooting for Data Applications
If you are having trouble, check the following before calling a repair person:
1. Make sure the data parameters (parity, baud) are set correctly.
2. Make sure Business Communications Manager Analog Terminal Adapter 2 is 
in the tones OFF mode. See Tones
 on page 12.
3. Make sure you are dialing out on the proper line. The proper line is either an 
intercom or external line. See Alternate Line
 on page...

			
	
  
	

	


	P0941629