Netgear Dgn 2200 M Manual

Technical Specifications and Factory Default Settings111
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
Regulatory compliance
FCC Part 15 Class B; VCCI Class B; EN 55 022 (CISPR 22), Class B
Interface specifications LAN: 10BASE-T or 100BASE-Tx, RJ-45
WAN: ADSL, Dual RJ-11, pins 2 and 3  
T1.413, G.DMT, G.Lite   
ITU Annex A or B 
ITU G.992.5 (ADSL2+)
Table 14.  Specifications  (continued)
SpecificationDescription 

Technical Specifications and Factory Default Settings112
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
Factory Default Configuration
You can use the Restore Factory Settings button on the bottom panel of y\
our router to restore 
factory default settings. Press this button for 6 seconds. Your router w\
ill return to the factory 
configuration settings shown in the following table.
Table 15.  Factory default settings 
 
FeatureDefault behavior
Router login User login URL...

Technical Specifications and Factory Default Settings113
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
Wireless
Wireless communication Enabled
SSID name Uniquely generated for every device (NETGEAR-3G in 
older models)
Security Uniquely generated for every device (disabled in older 
models)
Broadcast SSID Enabled
Country/region United States (in North America; otherwise, varies by 
region)
RF channel Auto
Operating mode Up to 145 Mbps
Data rate Best
Output power Full
Access point Enabled...

114
B
B.   Wall-Mounting
This appendix provides instructions for wall-mounting your wireless mode\
m router.
Your router’s location can affect wireless connections. For example, \
the thickness and number of 
walls the wireless signal needs to pass through might limit its range. F\
or best results, place your 
router: •     Near an AC power outlet, close to computers you plan to connect with Eth\
ernet cables, and near locations where you use wireless computers. For best signal str\
ength, the 
router...

Wall-Mounting115
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
2. 
Install wall anchors in the holes.
Use pan head Phillips wood screws, 3.5 x 20 mm (diameter x length, Euro\
pean) or #6 
type screw, 1 inch long (U.S.). 
3.  Insert screws into the wall anchors, leaving 3/16 in. (0.5 cm) of each\
 screw exposed. 

Wall-Mounting116
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
4. 
For best wireless performance, position the wireless antennas as shown. 

117
C
C.   Notification of Compliance
NETGEAR Wireless Routers, Gateways, APs
Regulatory Compliance Information
Note: This section includes user requirements for operating this product\
 in accordance with National laws for usage 
of radio spectrum and operation of radio devices. Failure of the end-use\
r to comply with the applicable 
requirements may result in unlawful operation and adverse action against\
 the end-user by the applicable National 
regulatory authority.
Note: This products firmware...

Notification of Compliance118
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
Español [Spanish]
Por medio de la presente NETGEAR Inc. declara que el Radiolan cumple con los 
requisitos esenciales y cualesquiera otras disposiciones aplicables o ex\
igibles de la 
Directiva 1999/5/CE.
Ελληνική [Greek] ΜΕ ΤΗΝ ΠΑΡΟΥΣΑ NETGEAR Inc.  ΔΗΛΩΝΕΙ ΟΤΙ Radiolan ΣΥΜΜΟΡΦΩΝΕΤΑΙ  ΠΡΟΣ 
ΤΙΣ ΟΥΣΙΩΔΕΙΣ  ΑΠΑΙΤΗΣΕΙΣ ΚΑΙ ΤΙΣ  ΛΟΙΠΕΣ ΣΧΕΤΙΚΕΣ ΔΙΑΤΑΞΕΙΣ ΤΗΣ ΟΔΗΓΙΑΣ 
1999/5/ΕΚ.
Français [French] Par la présente NETGEAR...

Notification of Compliance119
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
This device is a 2.4 GHz wideband transmission system (transceiver), i\
ntended for use in all EU member states and 
EFTA countries, except in France and Italy where restrictive use applies\
.
In Italy the end-user should apply for a license at the national spectru\
m authorities in order to obtain authorization to 
use the device for setting up outdoor radio links and/or for supplying p\
ublic access to...

Notification of Compliance120
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
• This device and its antenna(s) must not be co-located or operation in \
conjunction with any other antenna or 
transmitter.
Canadian Department of Communications Radio Interference Regulations
This digital apparatus (TBD) does not exceed the Class B limits for ra\
dio-noise emissions from digital apparatus as set 
out in the Radio Interference Regulations of the Canadian Department of \
Communications.
This Class...