NEC Neax2000 Ivs Circuit Card Manual

ND-45504 (E) CHAPTER 4
Page 129
Revision 2.0
PN-2ODTA (ODT)
PN-2ODTA (ODT)
1. Locations of Lamps, Switches and Connectors
PN-2ODTA (ODT) Card
2. Lamp Indications
3. Switch Settings
This card has no switches.
Lamp Indications
LAMP NAME COLOR FUNCTION
BL0, 1 Red• Remains lit when the corresponding circuit is in use.
• Flashes at 60 IPM when the corresponding circuit is in the make-busy state or the system
data for this card is not assigned.
CN1 BL1
BL0 

CHAPTER 4 ND-45504 (E)
Page 130
Revision 2.0
PN-8RSTA (PBR)
PN-8RSTA (PBR)
1. Locations of Lamps, Switches and Connectors
PN-8RSTA (PBR) Card
2. Lamp Indications
This card has no indicator lamps.
3. Switch Settings
This card has no switches. 

ND-45504 (E) CHAPTER 4
Page 131
Revision 2.0
PN-TNTA (TNT)
PN-TNTA (TNT)
1. Location of Lamps, Switches and Connectors
PN-TNTA (TNT) Card
2. Lamp Indications
This card has no lamps.
SW
JACK1
JACK0 

CHAPTER 4 ND-45504 (E)
Page 132
Revision 2.0
PN-TNTA (TNT)
3. Switch Settings
Switch Settings
SWITCH NAMESWITCH 
NUMBERSETTING 
POSITIONFUNCTION CHECK
SW
(Piano Key SW)
1, 2Volume adjustment for No. 0 circuit
3, 4Volume adjustment for No. 1 circuit
ON 4
3
2
1
OFF
SWITCH NUMBER
VOLUME
12
OFF OFF –10 dB
ON OFF –7 dB
OFF ON –4 dB
ON ON –1 dB
SWITCH NUMBER
VOLUME
34
OFF OFF –10 dB
ON OFF –7 dB
OFF ON –4 dB
ON ON –1 dB 

ND-45504 (E) CHAPTER 4
Page 133
Revision 2.0
PN-2CSIA (CSI)
PN-2CSIA (CSI)
1. Locations of Lamps, Swtiches, and Connectors.
PN-2CSIA (CSI) Card
2. Lamp Indications
Lamp Indications
LAMP NAME COLOR FUNCTION
OPE Green Lights when the corresponding circuit is in use.
LB Red Lights when a loop-back is in progress.
B13 Red Not used (Flash [60IPM])
B12 RedB channel status
ON  : B2 channel of the No. 1 circuit is in use.
OFF : B2 channel of the No. 1 circuit is in idle.
Flash (60 IPM) : ZT is not connected to...

CHAPTER 4 ND-45504 (E)
Page 134
Revision 2.0
PN-2CSIA (CSI)
3. Switch Settings
The figure in the SWITCH NAME column and the position in    in the SETTING POSITION col-
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
Note:Set the groove on the switch knob to the intended switch position.
B10 RedB channel status
ON  : B0 channel of the No. 1 circuit is in use.
OFF  : B0 channel of the No. 1...