NEC Dsx 34b Manual

DSX Software Manual  Introduction◆1
Introduction
Introduction
Using the DSX Software Manual
Using the DSX Software Manual
How the Manual is Organized
This manual describes the features and programming of the DSX telephone \
system. It is divided into eight 
chapters as follows:
❥Introduction
This is the chapter you are reading now. It provides information about the DSX system’s default feature 
setup and basic startup programming. You’ll also  find handy charts for system codes and capacities, as 
well...

Default Feature Setup
2◆ Introduction DSX Software Manual
Default Feature Setup
Default Features
Default Features for Lines
1.
All lines are loop start DTMF.
• Use  3101-01: Line Type  (page 809) to change this assignment.
2.In DSX-80/160, lines 1-12 ring on line keys 1-12 for extensions 300-315.
• All other extensions are lamp only for lines 1-12.
• Lines 13-64 do not appear on line keys.
3.In DSX40, lines 1-8 ring on line keys 1-8.
• Lines 5-8 require the Line Expansion Board.
4.To customize line...

Default Feature Setup
DSX Software ManualIntroduction◆3
Introduction
Initial Startup Programming
1.From any display telephone:
- Press 
INTERCOM + Dial #*#*
- Enter the system password + HOLD
2.
The system passwords are: -
632379 (NECDSX) for Installer (level 3)
-
9999 for System Administrator 2 (level 2)
-
0000 for System Administrator 1 (level 1)
3.See  System Programming Password Protection  (page 336) for more.
1.In 3101-01: Line Type  (page 809), assign the correct circuit type for each line....

Default Feature Setup
4◆ Introduction DSX Software Manual
Checking your System’s Software Level
How to Check your System’s Software Level
To check your system’s software level: 1.
Press INTERCOM.
2.Dial #*#*.
• The system software level shows on the  first line of your display.
• You see:
 DSX-nn vxx.xx.xx
3.
Press SPEAKER to exit. 

Charts
DSX Software ManualIntroduction◆5
Introduction
Charts
DSX Dial Codes by Feature (Page 1 of 2)
For this featureDial this codeWhen you are
Barge In (Intrusion) 4Barging-In on a co-worker’s call
Call Forwarding
INTERCOM + *30Canceling Call Forwarding at an 
extension
INTERCOM + *32 + Extension or 0 
(for the operator) Enabling Call Forwarding Busy/No 
Answer
INTERCOM + *33Setting up Call Forwarding Off 
Premise
INTERCOM + *34 + Extension or 0 
(for the operator) Enabling Call Forwarding All Calls...

Charts
6◆ Introduction DSX Software Manual
Monitor / Silent Monitor6Setting up Monitor after calling a busy 
co-worker
Night Service / Night Ring
** + UNA code (01-04) Answering a call ringing UNA at 
night
PagingINTERCOM + *1 + Page zone (1-7 or 
0 for All Call) Making an internal Paging announce-
ment
Park
INTERCOM + * + System Park Orbit 
(60-69) Parking or retrieving a call from Sys-
tem Park Orbit
INTERCOM + ** + Extension (e.g., 
301) Using Personal Park to Park or 
retrieve a call at a co-workers...

Charts
DSX Software ManualIntroduction◆7
IntroductionSystem Number Plan/Capacities  (Page 1 of 2)
DSX40DSX80/160
System Options
Classes of Service 1-15
(COS 1 normally reserved for attendants)
Conference 32 simultaneous users in Conference (total of all Conferences system-wi\
de)
8 simultaneous Conferences maximum
8 parties maximum in any one Conference
Extension Hunting (UCD) Master 
Numbers 8
Extension Hunting Groups 8 (1-8)
Group Call Pickup Groups 8 (1-8, 0 = unassigned)
Privacy Release Groups 16...

Charts
8◆ Introduction DSX Software Manual
Analog Door Boxes, Built-In20
Analog Door Boxes, Total The maximum number of DSX Analog Door Boxes you can install is determined by 
the number of 2PGDAD Modules, which in turn is limited only by the availability 
of 16ESIU station ports.
DSS Consoles 4
The System Load Factor may limit the total number that you can install. Refer to 
the system’s  Hardware Manual
.
Telephone Extension Numbers 300-325 300-427
Telephone Station Numbers 34 (1-34) 128 (1-128)
Total...

Telephone Illustrations
DSX Software ManualIntroduction◆9
Introduction
Telephone Illustrations
22-Button Display Telephone
ABC
JKL
TUV
VOLUME
GHI
PQRS DEF
TRANSFER
FLASH
REDIAL MUTE
SPEAKER INTERCOMCLEAR
CHECK
V-MAILDND
CONF
HOLD
MNO
WXYZ
In DSX-40:
Keys 1-8 are line keys.
Keys 9-12 are undefined.
In DSX-80/160:
Keys 1-12 are line keys.
For Attendants:
Key 12 is the
Operator Call key.
Thu June 8       11:52 AM
Pat Smith            x301   
Menu  Dir  VM:00 CL:00
   
1093100 - 2
Speed Dial
Bin keys...

Telephone Illustrations
10◆Introduction DSX Software Manual
34-Button Display Telephone
ABC
JKL
TUV
VOLUME
GHI
PQRS DEF
TRANSFER
FLASH
REDIAL MUTE
SPEAKER INTERCOMCLEAR
CHECK
V-MAILDND
CONF
HOLD
MNO
WXYZ
1093100 - 1
In DSX-40:
Keys 1-8 are line keys.
Keys 9-24 are undefined.
In DSX-80/160:
Keys 1-12 are line keys.
Keys 13-24 are undefined.
For Attendants:
Key 24 is the
Operator Call key.
Speed Dial Bin keys
Feature keys
Soft keys Alpanumeric Display Ring/Message Lamp
Microphone
Fixed Function keys
Thu...