Namco Final Furlong 2 Conversion Instructions
Here you can view all the pages of manual Namco Final Furlong 2 Conversion Instructions . The Namco manuals for Games are available online for free. You can easily download all the documents as PDF.
Page 1
FINAL FURLONG 2 CONVERSION INSTRUCTIONS
Page 2
It is most important that the game is tested and any problems rectified before any conversion work is started. Please make a note of all setting values so that the new Game PCB can be set accordingly. Warning: Ensure that the game is switched off and disconnected from the mains supply before any conversion work is started. Caution: Ensure adequate space is available to able to remove the header safely. Note: Take care when removing items not to lose any screws and washers as they may be required for...
Page 3
PRELIMINARY Removing the Ride Assembly 1. Raise the twelve adjustable feet, (4 on the monitor cabinet and 4 on each ride base assy), (Slacken the lock nuts with a spanner first.) 2. Remove 8off security screws (M5x12) and remove both Base Front Cover Plates. 3. Remove 4off hex head screws (M10x35), with flat and spring washers, retaining the ride base to the monitor cabinet.
Page 4
4. Pull the ride assembly away from the monitor cabinet only sufficient to reach the connectors. ( Take care not to stretch the wiring harness.) 5. Disconnect the connectors and move the ride assembly completely away from the monitor cabinet. Removing the Header Assembly The header assembly is high and has a forward centre of gravity, so it is important that at least two people are used to remove or fit the Header Assembly. 1. Remove 2off pozi head screws (M4x12), with flat and spring washers, and...
Page 5
3. Remove 2off pozi head screws (M5x16), with flat and spring washers. 4. Slide the header assembly forward so that it disengages with the retaining bracket. 5. Remove the Header Assembly
Page 6
RIDE ASSEMBLY DECALS 1. Remove the Horse Rear Decals (both sides of the horse). 2. Fit the new Horse Rear Decals (both sides of the horse). 3. Fit the new decals to the rear of the Ride Base. Replace (Both sides) New Decals
Page 7
HEADER ASSEMBLY 1. Remove the ten security screws (M5x16) and remove the header acrylic. (This part is no longer required). 2. Remove 2off pozi head screw (M4x12) and remove the Top Bracket. (This part is no longer required). Pozihead screw (M4x12)
Page 8
3. Fit the new top brackets with 4off torx security screws (M5x12 black), supplied. 4. Fit the new Header Acrylic with 10off torx security screw (M5x16 chrome), supplied. 5. Refit the Header Assembly. 6. Reconnect the connector. 7. Refit the Connector Cover Plate. Torx security screw (M5x12 black) Torx security screw (M5x16 chrome) Torx security screw (M5x16 chrome) Torx security screw (M5x16 chrome)
Page 9
MONITOR CABINET Replacing the Decals 1. Remove all the old decals, except the Monitor Middle Lower Decal. 2. Fit the new decals as shown below. Remove RemoveRemove (both sides) DO NOT REMOVE Remove New NewNew (both sides) New New New
Page 10
Fitting the New Front Vac-Form 1. Fit the new Vac-Form Bracket with 2off torx security screw (M5x16 black), supplied. 2. Fit the new Vac-Form with 4off Torx security screw (M5x16 black), supplied. Torx security screw (M5x16 black) Torx security screw (M5x16 black)