Home
>
Multi-Tech Systems
>
Communications System
>
Multi-Tech Systems Mvp-2400/2410/3010, Mvp-210/410/810 Voice/ip Gateways User Guide
Multi-Tech Systems Mvp-2400/2410/3010, Mvp-210/410/810 Voice/ip Gateways User Guide
Here you can view all the pages of manual Multi-Tech Systems Mvp-2400/2410/3010, Mvp-210/410/810 Voice/ip Gateways User Guide. The Multi-Tech Systems manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 291
MultiVOIP User Guide T1 PhoneBook Configuration 291 Add/Edit Outbound Phone Book: Field Definitions (cont’d) Field Name Values Description H.323 fields Use Gatekeepr Y/NIndicates whether or not gatekeeper is used. H.323 IDThe H.323 ID assigned to the destination MultiVOIP. Only valid if “Use Gatekeeper” is enabled for this entry. Gateway PrefixThis number becomes registered with the GateKeeper. Call requests sent to the gatekeeper and preceded by this prefix will be routed to the VOIP gateway. Q.931...
Page 292
E1 Phonebook Configuration MultiVOIP User Guide 292 Add/Edit Outbound Phone Book: Field Definitions (cont’d) Field Name Values Description SIP Fields Use Proxy Y/N Select if proxy server is used. Transport ProtocolTCP or UDPVoip administrator must choose between UDP and TCP transmission protocols. UDP is a high-speed, low-overhead connectionless protocol where data is transmitted without acknowledgment, guaranteed delivery, or guaranteed packet sequence integrity. TCP is slower connection-oriented...
Page 293
MultiVOIP User Guide T1 PhoneBook Configuration 293 Advanced button-- Gives access to secondary screen where an Alternate IP Route can be specified for backup or redundancy of signal paths. See discussion on next page. Clicking on the Advanced button brings up the Alternate Routing secondary screen. This feature provides an alternate path for calls if the primary IP network cannot carry the traffic. Often in cases of failure, call traffic is temporarily diverted into the PSTN. However, this feature...
Page 294
E1 Phonebook Configuration MultiVOIP User Guide 294 Alternate Routing Field Definitions Field NameValues Description Alternate IP Addressn.n.n.n where n= 0-255Alternate destination for outbound data traffic in case of excessive delay in data transmission. Round Trip Delaymilliseconds The Round Trip Delay is the criterion for judging when a data pathway is considered blocked. When the delay exceeds the threshold specified here, the data stream will be diverted to the alternate destination specified as...
Page 295
MultiVOIP User Guide T1 PhoneBook Configuration 295 4. Select PhoneBook Modify and then select Inbound PhoneBook/List Entries.
Page 296
E1 Phonebook Configuration MultiVOIP User Guide 296 5. The Add/Edit Inbound PhoneBook screen appears. Enter Inbound PhoneBook data for your MVP3010. The fields of the Add/Edit Inbound PhoneBook screen are described in the table below. Add/Edit Inbound Phone Book: Field Definitions Field NameValues Description Remove Prefixdialed digits portion of dialed number to be removed before completing call to destination (often a local PBX) Add Prefixdialed digits digits to be added before completing call to...
Page 297
MultiVOIP User Guide T1 PhoneBook Configuration 297 Add/Edit Inbound Phone Book: Field Definitions (cont’d) Field Name Values Description Description -- Describes the facility or geographical location at which the call originated. Call Forward Parameters Enable Y/N Click the check-box to enable the call-forwarding feature. Forward ConditionUncondit.; Busy No Resp.Unconditional. When selected, all calls received will be forwarded. Busy. When selected, calls will be forwarded when station is busy. No...
Page 298
E1 Phonebook Configuration MultiVOIP User Guide 298 6. When your Outbound and Inbound PhoneBook entries are completed, click on Save Setup in the sidebar menu to save your configuration. You can change your configuration at any time as needed for your system. Remember that the initial MVP3010 setup must be done locally using the MultiVOIP program. However, after the initial configuration is complete, all of the MVP3010 units in the VOIP system can be configured, re-configured, and updated from one...
Page 299
MultiVOIP User Guide T1 PhoneBook Configuration 299 Lille Reims Strasbourg Paris: Area 01 Rouen Nantes Lyon Marseille Toulouse Bordeaux France Country Code: 33
Page 300
E1 Phonebook Configuration MultiVOIP User Guide 300 010 Rotterdam 020 Amsterdam 050 Groningen 040 Eindhoven 0118 Middelburg038 Zwolle 058 Leeuwarden 053 Enschede 070 The Hague Haarlem 023 0294 Weesp Beverwijk 0251 Den Helder 0223 0299 Purmerend Aalsmeer0297 Texel 0222 043 Maastricht The Netherlands Country Code: 31 026 Arnhem