MSI Hetis 865gv-e Manual

							System Assembly
3-13 Insert the HDD tray into the chassis and
close the lever to lock the HDD tray in
place.
Using SATA HDD
Here shows how the cables should be
connected to the SATA HDD.Connect the SATA cable, HDD power
cord and HDD cable. 
						

							Chapter 3
3-14 7. Installing Optical Drive and Card Reader
Insert the optical drive into the drives
cage.
Screw the optical drive to Position I.
Use 4 screws to secure the optical drive. 
						

							System Assembly
3-15 Slide the drives cage back into the
chassis.Connect the optical drive cable and
power cord.Connect the system power cord.Screw the drives cage to the chassis. 
						

							Chapter 3
3-16 Replace the front bezel.Unscrew the cover shield.
Take out the cover shield.Take out the shield marked          if an
optical drive is installed.
Take out both shields if an optical drive
and a card reader are installed. 
						

							System Assembly
3-17 Press with force to secure the front bezel
to the chassis. 
						

							Chapter 3
3-18 Insert the card reader from the rear into
the drives cage.
Screw the card reader to the drives cage
following the indicated order.Note: Card reader is an optional device.  If you do not intend to install a card
reader, please skip the following procedures. 
						

							System Assembly
3-19 Slide the drives cage back into the
chassis.
Screw the drives cage to the chassis and
replace the front bezel.Unscrew the cover shield and then take
it out. Connect the power cord of the card
reader. 
						

							Chapter 3
3-20Remember to fasten the screws on
the rear panel. 8. Replacing Chassis Cover
Replace the chassis cover.Put the barebone on the footstand. 
						

							Chapter 3. BIOS Setup4 BIOS Setup
This chapter provides information on the BIOS Setup pro-
gram and allows you to configure  the system for optimum use.
You may need to run the Setup program when: An error message appears on the screen during the system m
booting up, and requests you to run SETUP. You want to change the default settings for customized
features. 
						

							4-2 Chapter 4
Power on the computer and the system will start POST (Power On Self
Test) process.  When the message below appears on the screen, press 
key to enter Setup.
DEL:SetupF11:Boot MenuF12:Network bootTAB:Logo
If the message disappears before you respond and you still wish to enter
Setup, restart the system by turning it OFF and On or pressing the RESET
button.  You may also restart the system by simultaneously pressing ,
, and  keys.
Selecting the First Boot Device
You are allowed to select the 1st boot device without entering the BIOS
setup utility by pressing .  When the same message as listed above
appears on the screen, press  to trigger the boot menu.
The POST messages might pass by too quickly for you to respond in
time.  If so, restart the system and press  after around 2 or 3 seconds to
activate the boot menu similar to the following.
The boot menu will list all the bootable devices. Select the one you want
to boot from by using arrow keys and then pressing .  The system will
boot from the selected device.  The selection will not make changes to the
settings in the BIOS setup utility, so next time when you power on the system,
it will still use the original first boot device to boot up.Select First Boot Device
Floppy: 1st Floppy
IDE-0: IBM-DTLA-307038
CD-ROM: ATAPI CD-ROM DRIVE 40X M
[Up/Dn] Select[RETURN] Boot[ESC] cancel4.1 Entering Setup