Miele Seb 2173 Manual

							Upright vacuumsConnecting the SEB 217 to an upright vacuum cleaner.
en - Connecting the Powerbrush
11 
						

							Canister vacuums
The connection procedure will vary
depending upon which vacuum,
electric hose, suction wand and
powerbrush model you purchased.
Please find the combination of
components you have on the following
pages and use those instructions to
connect the powerbrush to your
vacuum cleaner.
en - Connecting the Powerbrush
12 
						

							Combination 1 - SEB 213 and SES 100 or SES 105
en - Connecting the Powerbrush
13 
						

							Combination 2 - SEB 213-2 and SES 113
en - Connecting the Powerbrush
14 
						

							Combination 3 - SEB 217-2, SET 220 and SES 118
en - Connecting the Powerbrush
15 
						

							Combination 4 - SEB 217-3, SET 220 and SES 116
en - Connecting the Powerbrush
16 
						

							Combination 5 - SEB 217-3, SET 220 and SES 117
en - Connecting the Powerbrush
17 
						

							Combination 6 - SEB 217-3, SET 220 and SES 119
en - Connecting the Powerbrush
18 
						

							Combination 7 - SEB 217-3, SET 220 and SES 130
en - Connecting the Powerbrush
19 
						

							Recommended use
Observe the cleaning instructions of
the floor manufacturer.
The Powerbrush is particularly suitable
for cleaning and restoring crushed
carpet pile of wall to wall carpeting and
floor coverings subject to hard wear,
especially in high traffic areas.
To clean hard flooring, it is better to use
the floor brush.
Do not use the powerbrush on:
– Floors with a variable or uneven
surface. The brush could come into
contact with the floor and cause
damage.
– High quality, hand knotted rugs, for
example Berber or Persian rugs, as
well as extremely long piled area
rugs and carpets. There is a danger
of the threads being pulled out. Turn
the powerbrush off to vacuum these
types of floor coverings and use only
suction.
Turning on the Powerbrush
SEB 217 with an upright vacuum
cleaner
The Powerbrush will start automatically
when the vacuum cleaner is turned on.
SEB 213 and SEB 217
The powerbrush can only be turned on
if the vacuum cleaner is also on. The
switch that controls the power brush
can be found on the hose handle.
Using the Powerbrush
To achieve the best results, slowly
pass the Powerbrush back and forth
over the carpet.
Operation
Indicator light
The electrobrush warning light has a
double function.
It lights
–yellow, when the brush is in use
– red, if the brush roller is blocked.
This can occur if enough threads
wrap around it or if a large or long
object has been vacuumed up.
Turn off the vacuum cleaner and
unplug the power cord.
Remove the object preventing the
roller from turning (see the
Maintenance and Care section).

Wait approximately 2-3 minutes for
this safety feature to reset before
turning the vacuum cleaner back on.
en - Operation
20