Home > Miele > > Miele M 8260-2 Manual

Miele M 8260-2 Manual

Here you can view all the pages of manual Miele M 8260-2 Manual. The Miele manuals for are available online for free. You can easily download all the documents as PDF.

Page 41

To avoid damaging the outer
surfaces of your appliance, do not
use:
–cleaning agents containing soda,
ammonia, acids or chlorides,
–cleaning agents containing
descaling agents,
–abrasive cleaning agents, e.g.
powder cleaners and cream
cleaners,
–solvent-based cleaning agents,
–stainless steel cleaners,
– dishwasher detergent,
– oven sprays,
– glass cleaning agents,
– hard, abrasive sponges and
brushes, e.g. pot scourers,
– dirt erasers,
– sharp metal scrapers.Accessories supplied
Boiling rod
The boiling...

Page 42

Repairs may only be carried out by
a suitably qualified and competent
person in accordance with national
and local safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
Some minor problems can be corrected
without contacting Miele.
Please note: A call-out charge will be
applied to unnecessary service visits
where the problem could have been
rectified as described in these
operating instructions.
What to do...

Page 43

. . . the microwave operation works
but not the lighting.
^You can then operate the appliance
as normal, but not the lighting.
Contact Miele if you need to replace
the lighting.
. . . strange noises are heard when
the microwave oven is being used.
Check whether,
^the food is covered with aluminium
foil.
If so, remove it.
^Sparks are being created by the use
of crockery with a metallic finish. See
notes on suitable types of containers.
. . . the time of day in the display is
not accurate.
If there has...

Page 44

In the event of any faults which you
cannot remedy yourself, or if the
appliance is under warranty, please
contact:
–your Miele Chartered Agent
or
–Miele.
You will find the telephone number
and address of your nearest office
on the back cover of this manual.
When contacting your Chartered Agent
or Miele, please quote the model and
serial number of your appliance. This
information is given on the data plate,
which is located on the inside of the
appliance front.
Warranty
The warranty for this appliance is...

Page 45

Before connecting the appliance,
ensure that it has not been
damaged in any way. Do not use a
damaged appliance.
The appliance is supplied with a mains
cable and moulded plug ready for
connection to an AC single phase
220-240 V 50 Hz supply.
Fuse protection is to be conducted as
follows: Connection to an earthed
power socket, protected with 10 A-L
automat or fuse 10 A.
Connection must only be made via a
suitable switched socket. The electrical
system must comply with VDE0100.
The appliance should be...

Page 46

When building in the appliance,
ensure that the vents at the front of
the appliance are not hindered.
Make sure that there is a gap of at
least 2.5 mm between the sides of
the appliance and adjoining furniture
doors and at least 4 mm above the
appliance.
The appliance is designed to be built
into a tall unit and is also suitable for
underbench installation.
The installation of the microwave oven
below a cooktop or above a plate
warming drawer is not permitted.
Building-in dimensions
Underbench
To...

Page 47

Tall unit
Building-in kit
The following items are supplied in the
accessory pack for installing the
appliance:
Installation
The appliance must be built in
before it can be used. Otherwise it
poses an electric shock hazard.
There are three spacers in the
accessory pack: one for the right-hand
side (R) and two for the left-hand side
(L), depending on whether the housing
unit wall is 16 or 19 mm thick.
^Attach the correct left-hand spacer
applicable to the thickness of the
housing unit wall to one of the...

Page 48

^To secure the spacers and hooks,
place a screw in one of the front two
holes and another in the middle of
the long hole at the back.
The long hole allows for adjustment if
necessary, and the two additional
holes are in case additional screws
are required.
^
Slide the appliance into the housing
unit, and pull the cable with the plug*
through the back of the unit.
* Plug shown is for illustration
purposes only.^Secure the appliance at the front by
lifting it over the hooks and lowering it
into position....

Page 49

49 

Page 50

50 
Start reading Miele M 8260-2 Manual
All Miele manuals