Miele Kwt4154ug1 Manual

Door seal
Do not use any oils or grease on the
door seal as these will cause the
seal to deteriorate and become
porous over time.
The door seal should be cleaned
regularly with clean water, then wiped
dry with a soft cloth.
Active charcoal filter
Replace the active charcoal filters with
new ones once a year. These are
available from Miele.
^
Turn the filters 90° clockwise or
counter-clockwise.
^
Remove the filters.
^
Insert the new filters with the handle
in the vertical position.
^
Turn the filters 90°...

Repairs should only be carried out
by a qualified and trained person in
strict accordance with local and
national safety regulations.
Unauthorized repairs could cause
personal injury or machine damage
and may void the warranty.
With the aid of the following guide
minor problems can be corrected
without a service call.
What to do if...
. . . the appliance does not get cool.
^Check whether the appliance has
been turned on. The temperature
display must be lit up.
^Check that the plug is correctly
inserted...

. . . the interior light is not working.
Contact MieleCare.
If, after following these suggestions,
you still cannot remedy the fault,
please contact MieleCare.
To prevent unnecessary loss of
temperature it is advisable not to
open the door while waiting for the
appliance to be serviced.
Problem-solving guide
23 

Normal noises What causes them?
Brrrrr...Humming noise made by the motor (compressor). This noise
may get louder for brief periods, whenever the motor kicks in.
Blubb, blubb....A gurgling noise can be heard when coolant is circulating
through the pipes.
Click....Clicking sounds occur whenever the thermostat switches the
motor on or off.
Sssrrrrr....In multi-zone and frost-free appliances, the movement of air
circulating through the appliance can sometimes just barely be
heard.
Please bear in mind that a...

In the event of a fault which you cannot
easily fix yourself, please contact the
Miele Technical Service Department at
the address on the back of this booklet.
When contacting the Technical Service
Department, please quote the model
and serial number of your appliance
given on the data plate inside the
appliance.
After sales service
25 

26 

Installation instructions
To prevent accidents
and machine damage
read these instructions
before
installation or use. 

,Avoid the risk of electrical shock
- Plug into a grounded 3-prong
outlet.
- Do not move the ground plug.
- Do not use an adapter.
- Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or electrical
shock.
Improper connection of the
equipment grounding conductor
may result in electric shock. If you
are in any doubt as to whether the
appliance has been properly
grounded, have the appliance
checked by a qualified electrician or
service technician.
Installation,...

This appliance must be built in;
otherwise it could tip over.
To ensure that the appliance
functions correctly in tropical
climates where the ambient
temperature exceeds 38°C and air
humidity levels exceed 70%, the
appliance MUST be used in a
climate-controlled room.
Location
The appliance should be installed in a
dry, well-ventilated room.
The room temperature should not go
above or below the climate range for
which the appliance is designed.
The higher the ambient temperature of
the room, the more...

The appliance is supplied right-hand
hinged. If left-hand door hinging is
required, follow the instructions below.
^Close the door, and unscrew the top
hinge pin from the doora.
^Unscrew the door staybfrom
underneath the door.
^Tip the door forward slightlyc, and
lift it up and offd.^Unscrew the top hinge platee, turn
it around, and refit it on the opposite
side.
^Unscrew the lower hinge platef.
^Remove the hinge ping, and
replace it in the hinge plate from
underneath. Ensure that the spacer
on which the...