Miele Kfns 3917 Sde Ed Operating And Installation Instructions

The StayFresh zone is divided into two
areas:
–Thedry compartmenthas a relative
humidity level of approx. 45 %.
–Thehumidity controlled
compartmenthas a control for
setting the humidity level between
45 % and 90 %. Slide the control to
the humidity level you require.
The humidity level will also be affected
by the moisture content of the food
being stored and how often the
compartment is opened.
Low humidity level,
^To set a humidity level of approx.
45 %, slide the control for the
humidity controlled...

Storing food correctly
Store food covered or packaged. This
will prevent food smells or tastes from
affecting other foods, and prevent food
from drying out and also any
cross-contamination of bacteria. The
growth of bacteria, such as salmonella,
can be avoided by setting the correct
temperature and maintaining good
standards of hygiene.
Fruit and vegetables
Fruit and vegetables can be stored
loose in the vegetable containers.
However, you should bear in mind that
some types of vegetables give off a...

Moving the shelves
The shelves can be adjusted according
to the height of the food.
^Pull the shelf forward as far as it will
go; then lift it upwards to remove it.
^With the rear barrier facing upwards,
place the shelf at the required
position.
The rear barrier must face upwards to
prevent food from touching the back
of the appliance and freezing to it.
Split shelf
In order to accommodate tall items in
the appliance, one of the shelves is
divided. The front section can be
pushed under the rear section....

Refrigerator section and
StayFresh zone
Condensate and frost can build up on
the back wall of the refrigerator section
and the StayFresh zone whilst in use.
These are automatically removed and
defrosted by the appliance.
The condensate is drained away via a
channel and drain hole into an
evaporation system at the back of the
appliance.
Ensure that the condensate channel
and drain hole are kept clean and
are never blocked so that
condensate can flow away without
hindrance.
Automatic defrost
24
 

Never use cleaning agents
containing abrasive substances
such as sand, soda, acids or
chemical solvents.
Non-abrasive cleaning agents are
also unsuitable as they can cause
matt areas to appear.
Stainless steel surfaces should be
cleaned with a proprietary stainless
steel cleaner following the
manufacturer’s instructions on the
packaging.
Make sure that no water can
penetrate into the electronic unit or
into the light.
Do not let water get into the
drainage channel and drain hole
when cleaning.
Do not use...

Ventilation gaps
^The ventilation gaps should be
cleaned on a regular basis with a
brush or vacuum cleaner. A build up
of dust will increase the energy
consumption of the appliance.
Door seal
Do not use any oils or grease on the
door seal as these will cause the
seal to deteriorate and become
porous over time.
The door seal should be cleaned
regularly with clean water and then
wiped dry with a soft cloth.
Metal grille at the back of the
appliance
The metal grille at the back of the
appliance (heat...

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in accordance with local and
national safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
Some minor problems can be corrected
without contacting the Miele Service
Department.
What to do if . . .
. . . the appliance does not get cold.
^Check whether the appliance has
been switched on. The temperature...

. . . the floor of the refrigerator
section or the StayFresh zone is wet.
The drain hole is blocked.
^Clean the condensate channel and
drain hole.
. . . the interior lighting in the
refrigerator section is not working.
^Was the door left open for too long?
The lighting switches itself off
automatically after approx. 15
minutes.
If the door has not been left open for
this length of time the interior lighting is
defective.
To change it follow the instructions
below. The lighting component
required (cool...

Normal noises What causes them
Brrrrr...Humming noise made by the motor (compressor). This noise can
get louder for brief periods when the motor is switching on.
Blubb, blubb....A gurgling noise can be heard when coolant is circulating
through the pipes.
Click....Clicking sounds are made when the thermostat switches the
motor on and off.
Sssrrrrr....On multi-zone and frost-free appliances you can sometimes just
hear the movement of air circulating inside the appliance.
Remember that the noise of the...

In the event of a fault which you cannot
correct yourself, or if the appliance is
under guarantee, please contact:
–your Miele Dealer
or
–the Miele Service Department (see
back cover for address).
When contacting your Dealer or the
Service Department, please quote the
model and serial number of your
appliance. This information is given on
the data plate.
Please note that telephone calls may
be monitored and recorded for
training purposes.
After sales service
30