Miele Kfn 8995 Seed Operating And Installation Instructions

~Do not use defrosting sprays or
de-icers, as they might contain
substances which could damage the
plastic parts or which could cause a
build-up of gases and pose a danger to
health.
~Do not use any oils or grease on the
door seal, as these will cause the seal
to deteriorate and become porous over
time.
~Do not store cooking oil in the
refrigerator door. Traces of oil can
cause stress cracks in the plastic
components in the door.
~Do not attempt to remove the
lighting covers inside the refrigerator
door....

Disposal of your old appliance
~Before disposing of an old
appliance, first make the door latch or
lock unusable.
This will prevent children from
accidentally locking themselves in and
endangering their lives.
~Disconnect it from the power, cut off
the cable near the appliance and
render any plug unusable.
~Be careful not to damage any part of
the pipework while awaiting disposal,
e.g., by
– puncturing the refrigerant channels
in the evaporator.
– bending any pipework.
– scratching the surface coating....

Normal energy consumption Increased energy consumption
Installation siteIn a well ventilated room. In an enclosed, poorly ventilated
room.
Protected from direct sunlight. In direct sunlight.
Away from heat sources (radiator,
stove/oven).Near heat sources (radiator,
stove/oven).
When the room temperature is
ideal (approx. 20 °C (68 F)).When the room temperature is
high.
Temperature setting (dial)At a medium setting of 2 to 3. At a high setting: The lower the
temperature in the appliance, the
more energy...

Before using for the first time
The stainless steel surfaces and trim
are covered in a protective sheeting for
transport.
^Do not remove the sheeting until the
appliance has been installed in its
final location. To peel the sheeting
off, start at one of the upper corners.
^Next, coat the stainless steel
surfaces with a special stainless steel
product (which is available through
customer service).
^Clean the inside of the appliance and
the accessories with warm water and
some mild soap. Dry with a soft...

Safety lock
The safety lock can be activated to
prevent the appliance from being
switched off inadvertently.
Activating and deactivating the
safety lock
^Hold down the superfreeze button for
approx. 5 seconds.
The indicator light for the superfreeze
button flashes and the temperature
display shows
;.
^Now press the superfreeze button
again.
The display will show
;.
^
Now, by pressing the set temperature
buttons, you can choose between
;
0and;1:
0Safety lock is deactivated,
1: Safety lock is activated.
^...

The display on the outside of the
appliance door
- shows the current temperatures of the
refrigerator and freezer sections,
- shows if the SuperCool or
SuperFreeze functions are switched on,
and
- tells you if there is a problem with the
appliance.
Thetop halfof the display shows the
temperature of the refrigerator
section, while thelower halfshowsthe
temperature of the freezer section.
When you first switch the appliance on,
and both doors are shut, aWelcome
screen will appear after a short time.
This...

If the refrigerator door is not opened,
the process will be cancelled after
approx. 10 minutes, and the original
contrast setting will be restored.
To exit the setting mode:
^On the control panel inside the
appliance, press the On/Off button
for the freezer section.
If you do not do this, the electronics
will automatically switch over to
normal operation after a few minutes.
Door display
17
 

Displays
The door display can show the following symbols:
Symbol Meaning
+°CTemperature display over 0° C.
-°CTemperature display under 0° C.
--The temperatures in the appliance have not yet reached the
temperature ranges that can be displayed.
$The appliance is locked.
LThe set temperature has not yet been reached. The inside of the
appliance is still cooling down.
SUPERIf SUPER shows in the top half of the display, this means that the
SuperCool function is switched on.
If SUPER shows in the lower half...

It is very important to set the correct
temperature for storing food in the
appliance. Micro-organisms will cause
food that is not stored at the correct
temperature to deteriorate rapidly. The
temperature influences the growth rate
of these micro-organisms. Reducing
the temperature slows their growth rate.
The temperature in the appliance will
rise:
–the more often the door is opened
and the longer it is kept open,
– if too much food is stored in it at
once,
– the warmer the food being placed in
it,
–...

You can make changes to the
temperature displays behind the door
by pressing the buttons as follows:
–When first pressed, thelast
temperature selectedflashes.
–Each subsequent press of the button
adjusts the temperature shown in
1 °C increments.
–Holding the button in adjusts the
temperature continually.
Approx. 5 seconds after letting go of
the button, thecurrenttemperature of
the refrigerator or freezer section is
automatically shown.
If you have adjusted the temperature,
wait for approx. 6 hours if...