Miele Kfn 14947 Sdeed Operating And Installation Instructions

Refrigerator section and
PerfectFresh zone
Condensate and frost can build up on
the back wall of the refrigerator section
and the PerfectFresh zone whilst in use.
You do not need to remove this, as it
will defrost and evaporate automatically
with the warmth generated by the
appliance.
The condensate is drained away via a
channel and drain hole into an
evaporation system at the back of the
appliance.
Ensure that the condensate channel
and drain hole are kept clean and
are never blocked so that
condensate...

A range of Miele cleaning and
conditioning agents is available from
the Miele UK Spare Parts Department
or via the internet at
www.miele-shop.com.
Do not use cleaning agents
containing abrasive substances
such as sand, soda, acids, chlorides
or chemical solvents. Some scouring
agents claim to be non-abrasive.
These are also unsuitable as they
can cause matt areas to appear.
For stainless steel surfaces, use a
suitable stainless steel conditioning
agent.
Do not let water get into the
electronic unit or...

It is important to do this every time
the stainless steel surfaces are
cleaned, as the stainless steel
conditioner protects the surfaces
and helps prevent re-soiling.
Cleaning the ice cube tray
The ice cubes are formed in a tray
before they are dropped down into the
drawer.
This tray should be cleaned regularly to
remove any stale ice or water.
^Connect the appliance to the
electricity supply.
^Open the top left drawer a little.
^Press the On/Off button on the ice
cube maker. The indicator light will...

If you have used a solution of water
and washing-up liquid to clean it,
discard the ice cubes from the first
three ice cube making processes,
as they are not suitable for
consumption.
Ventilation gaps
^The ventilation gaps should be
cleaned regularly with a brush or
vacuum cleaner. A build-up of dust
will increase the energy consumption
of the appliance.
Door seal
Do not use any oils or grease on the
door seals as these will cause the
seals to deteriorate and become
porous over time.
The door seals...

The active charcoal filters should be
changed approx. every 6 months.
When the Change active charcoal filter
indicator lights up red, the active
charcoal filters need to be changed.
To change the active charcoal
filters
^Pull the active charcoal filter holder
upwards to remove it from the shelf.
^
Take out the two filters and fit the new
filters into the holder with the
protruding cloth edge facing
downwards.
^
Place the holder in the middle of the
raised edge at the back of the shelf,
so that it clicks...

If you have delayed changing the
active charcoal filters and the indicator
is not lit up, you will need to reset the
counter when you replace the active
charcoal filters via the settings mode.
^Touch and leave your finger on the
sensor.
^At the same time, briefly touch the
On/Off sensor (without letting go of
thesensor).
^Leave your finger on thesensor for
another 5 seconds untilcappears in
the display.
^Touch thesensor repeatedly until
^appears in the display.
^
Touch the On/Off sensor.
^
Touch...

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in strict accordance with
current local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if...
. . . the refrigerator section or freezer
section does not get cold.
^Check whether the relevant section is
switched on. The temperature display
must be lit up.
^Check that the plug is...

. . . the frozen food is thawing
because the freezer section is too
warm.
^Is the room temperature lower than
the ambient temperature for which
the appliance is designed?
If so, raise the temperature of the
room.
Operating in a room which is too cold
will cause the cooling system to switch
off for too long, causing the freezer
section to become too warm.
. . . food has frozen together.
Use a blunt instrument, e.g. a spoon
handle or plastic scraper, to prise it
apart carefully.
. . . the alarm sounds and...

...dn appears in the temperature
display.
The demonstration function is activated.
^Call the Service Department.
. . . you cannot switch the ice cube
maker on.
^Check whether the appliance is
connected to the electricity supply.
. . . the ice cube maker is not
producing any ice cubes.
^Was the water inlet pipe purged of air
by a qualified and competent person
before the appliance was used for
the first time?
^Check whether the ice cube maker is
switched on.
^Check whether the freezer section is
switched...

^Unclip the front cover.
^Remove the glass panel.
^Unscrew the lamp and replace it with
a new one.
Lamp specification:
220 - 240 V, max. 25 W, E 14 fitting.
^
Slide the glass panel back in again.
^
Insert the cover and clip it into
position.
. . . the floor of the refrigerator is wet.
The condensate drain hole is blocked.
^
Clean the condensate channel and
drain hole.
If you still cannot remedy the fault
having followed these suggestions,
please contact the Miele Service
Department.
To prevent...