Miele Kfn 14947 Sdeed Operating And Installation Instructions

~The manufacturer cannot be held
liable for damage caused by a faulty
connection to the mains water supply.
~Connection to the mains water
supply and any repairs to the ice cube
maker must only be carried out by a
suitably qualified and competent
person.
~The ice cube maker is not suitable
for connection to a hot water supply.
~In countries where there are areas
which may be subject to infestation by
cockroaches or other vermin, pay
particular attention to keeping the
appliance and its surroundings in a...

~Do not use sharp edged objects to
–remove frost and ice,
–separate frozen foods and remove
ice trays.
They will damage the evaporator,
causing irreversible damage to the
appliance.
~Never place electric heaters or
candles in the appliance to defrost it.
These can damage the plastic parts.
~Do not use defrosting sprays or
de-icers, as they might contain
substances which could damage the
plastic parts or which could cause a
build-up of gases and pose a danger to
health.
~Do not use any oils or grease on...

Normal energy
consumptionIncreased energy
consumption
Installation siteIn a ventilated room. In an enclosed, unventilated room.
Protected from direct sunlight. In direct sunlight.
Not situated near to a heat source
(radiator, oven).Situated near to a heat source
(radiator, oven).
Where the ideal ambient room
temperature is approx. 20°C.Where there is a high ambient
room temperature.
Temperature setting with
a thermostat which is
approximate
(set in stages).With a medium setting of 2 to 3. With a high...

Before using for the first time
The stainless steel external and internal
surfaces of the appliance have a layer
of protective foil to prevent scratching
during transportation.
^Do not remove this foil until the
appliance has been installed or built
in.
^After removing the protective foil,
treat stainless steel surfaces with a
suitable stainless steel conditioning
agent (available from
www.miele-shop.com).
Important: Stainless steel
conditioner gives long lasting
protection, and helps to prevent...

To enable the temperature to get
sufficiently cold inside the
appliance, allow the appliance to
run for a few hours before placing
food in it.
Do not place food in the freezer
section until the temperature is at
least -18°C.
This sensor is used to switch between
the refrigerator and freezer sections.
If you want to select the freezer section
(to check the temperature, for
example),
^
touch the sensor for selecting the
freezer/refrigerator section until the
Freezer symbol lights up yellow.
Depending on...

^Select the section of the appliance
which you wish to switch off.
The Refrigerator or the Freezer
symbol will light up yellow.
^Touch the On/Off sensor until the
Refrigerator or the Freezer symbol
goes out.
The section you selected is now
switched off while the other section
remains switched on.
To switch a section back on again:
^
Select the section which you want to
switch on. The relevant symbol will
light up yellow.
^
Touch the On/Off sensor until the
temperature display lights up, or
^
Switch the...

Settings mode
Certain settings on the appliance can
only be selected in the settings mode.
How to select the settings mode and
how to change the settings is
described in the relevant section of
these instructions.
Overview of functions that can be
selected in the settings mode:
To enter or leave the settings
modec
To switch the sensor tone
on/off
(see Switching on and off)b
To confirm that the active
charcoal filters have been
changed (see Active charcoal
filters)^
To switch the safety lock on/off
(see...

The old setting lights up, and your
newly selected setting flashes.
^Touch the On/Off sensor to confirm
the new setting.
^Touch thesensor repeatedly untilc
appears in the display.
^Touch the On/Off sensor.
You have now left the settings mode.
Activating or deactivating the safety
lock
The safety lock can be activated to
prevent the appliance being switched
off inadvertently.
^Touch and leave your finger on the
sensor.
^
At the same time, briefly touch the
On/Off sensor (without letting go of...

It is very important to set the correct
temperature for storing food in the
appliance. Micro-organisms will cause
food which is not stored at the correct
temperature to deteriorate rapidly.
Temperature influences the growth rate
of these micro-organisms. Reducing
the temperature reduces their growth
rate.
The temperature in the appliance will
rise:
–the more often the door is opened
and the longer it is kept open,
– the more food that is stored in it,
– the warmer the food is which is being
put into it,...

Setting the temperature
The temperatures in the refrigerator
section/PrefectFresh zone and freezer
section are set independently of one
another.
^Select the refrigerator or the freezer
section.
The Refrigerator symbol or the
Freezer symbol will light up yellow.
^You can now use the arrow sensors
on either side of the temperature
display to set the temperature you
require.
By touching the
sensor: the temperature will get
colder
sensor: the temperature will get
warmer.
The temperature being set will...