Miele K 9212 I Operating And Installation Instructions

Before building the appliance in, you
will need to decide on which side the
door is to be hinged. If left hand door
hinging is required, follow the
instructions below.
To change the door hinging, you will
need various sizes ofTorx
screwdriversand aslotted
screwdriver.
Appliance door
^Open the appliance door.
^
Pull off coversaandb.
^
Unscrew hinge pinc.
^
Tilt the door, and lift it off.
^
Unscrew hinge plated, and replace
it on the opposite side using the
same screws.
^
Remove lower hinge pinetogether...

Freezer compartment door
^Lower the cover on hinge platea.
^Unscrew hinge plateb, and remove
freezer compartment doorc
together with the hinge plate.
^Unscrew door catchd.
^
Screw door catchdinto place on the
opposite side, having turned it by
180 °.
^
Fit the freezer compartment doorc
in position at the tope, then tighten
the hinge plate securelyb.
^
Close the cover on hinge platea.
^
Plug the holes with stoppersf.
Changing the door hinging
42
 

All building-in instructions given are
for aright hand hingedappliance.
If you have converted the appliance
to left hand hinging you will need to
adapt these instructions accordingly.
Building into a peninsular run
When built into a peninsular run, the
rear of the building in niche must be
fitted with a kitchen furniture panel.
Aligning the housing unit
Before installing the appliance, the
housing unit must be carefully aligned
using a spirit level. The housing unit
corners must be at right angles, as...

Building in the appliance
^Remove covera.
^Secure bracketbwith screwsc
(4.8 x 16 mm).
^
Push the appliance into the
building-in niche, leaving a gap of
approx. 4 mm.
Take care not to trap the mains cable.
^
Push in the appliance until the front
edges of bracketband hinge plates
dandeare flush with the front
edge of the housing.^Align the appliance height from above
on both sides using adjusting screw
f.
^Plug the gap between the appliance
and the furniture wall on the door
opening side with sealing...

Securing the appliance and
fitting the furniture door
^Push the appliance against the
housing wall on the side on which the
door opens so that the sealing strip is
pressed into the housing wallh.
^
Secure the appliance at the top with
screwi(4 x 19 mm) into bracketb,
pushing the appliance against the
furniture wall as you do so, then
secure it at the bottom with screwsj
(4 x 36 mm) through the adjusting
screws in the hinge plates on the
housing.
^
Tighten all the screws.
^
If necessary, align cover...

46
 

47
 

Alteration rights reserved / 4906
K 9212 i, K 9412 iM.-Nr. 06 993 890 / 00
en-GB