Miele K 5122 Ui Operating And Installation Instructions
Here you can view all the pages of manual Miele K 5122 Ui Operating And Installation Instructions. The Miele manuals for Fridge freezer are available online for free. You can easily download all the documents as PDF.
Page 31
![Page 31
Fitting the plinth facing
To ensure trouble-free operation of
the appliance it is essential to fit the
original Miele ventilation grille.
Remove ventilation grilleby
pressing the clips in the openings
upwardsand simultaneously
pulling the grille forwards.
The plinth facingcan be fitted
without being altered in the following
situations:
It can be fitted unchanged if the
following dimensions are present:
Building-under
height
A
[mm]Plinth facing
height
b
[mm]
820 100
870 150
The height of the plinth...](http://img.usermanuals.tech/thumb/51/57463/w300_miele_k_5122_ui-operating-and-installation-instructions-30.png "Page 31
Fitting the plinth facing
To ensure trouble-free operation of
the appliance it is essential to fit the
original Miele ventilation grille.
Remove ventilation grilleby
pressing the clips in the openings
upwardsand simultaneously
pulling the grille forwards.
The plinth facingcan be fitted
without being altered in the following
situations:
It can be fitted unchanged if the
following dimensions are present:
Building-under
height
A
[mm]Plinth facing
height
b
[mm]
820 100
870 150
The height of the plinth...")
Fitting the plinth facing To ensure trouble-free operation of the appliance it is essential to fit the original Miele ventilation grille. Remove ventilation grilleby pressing the clips in the openings upwardsand simultaneously pulling the grille forwards. The plinth facingcan be fitted without being altered in the following situations: It can be fitted unchanged if the following dimensions are present: Building-under height A [mm]Plinth facing height b [mm] 820 100 870 150 The height of the plinth...
Page 32
Position the plinth facing along the run of kitchen units. Mark the protruding sectionAon the ventilation grille consolewith a pencil, then take the plinth facing off again. Cut protruding sectionAoff the ventilation grille console.If the front slat on the facing does not align with the front edge of the plinth facing, cut off another slat. Use pliers to remove the vertical ribs . Shorten the ventilation grille supports by dimension A (= ventilation grille console overhang). Secure the...
Page 33
Fitting a furniture door If there are no pre-drilled holes in the furniture door, holes have to be drilled as shown on the following drawing: Drilling positions on framed doorsRemove screwsfrom the underside of the appliance door. Use the screws to secure both bracketsto the underside of the appliance door. The brackets must be flush with the exterior of the appliance door. Shorten the brackets if necessary. Installing the appliance 33
Page 34
Unscrew adjuster stripfrom the appliance door and use the screws supplied to secure it to the furniture door. Loosen the adjusting screwson the appliance door until there is a gap of 4.0 mm (see detail). Use the adjusting strip to hang the furniture door onto adjusting screws . Secure the furniture door at the top using screws. Secure the furniture door at the bottom using the screws supplied fitted through the bracket. Use the washerssupplied. Aligning the furniture door Align the...
Page 35
35
Page 36
Alteration rights reserved / 2611 K 5122 UiM.-Nr. 09 087 400 / 00