Miele K 5122 Ui Operating And Installation Instructions

							Fitting the plinth facing
To ensure trouble-free operation of
the appliance it is essential to fit the
original Miele ventilation grille.
Remove ventilation grilleby
pressing the clips in the openings
upwardsand simultaneously
pulling the grille forwards.
The plinth facingcan be fitted
without being altered in the following
situations:
It can be fitted unchanged if the
following dimensions are present:
Building-under
height
A
[mm]Plinth facing
height
b
[mm]
820 100
870 150
The height of the plinth facing has to
be altered in the following
circumtances:
If the building-under heightA = 820
mmand the plinth facing heightbis
greater than 100 mma cut-out has to
be made in the plinth facing.
This also applies to a building-under
heightA = 870 mmand plinth facing
heightb greater than 150 mm.
Building-under
height A [mm]Dimension H
[mm]
820
870100
150
Installing the appliance
31
 
						

							Position the plinth facing along the
run of kitchen units.

Mark the protruding sectionAon the
ventilation grille consolewith a
pencil, then take the plinth facing
off again.

Cut protruding sectionAoff the
ventilation grille console.If the front slat on the facing does not
align with the front edge of the plinth
facing, cut off another slat.
Use pliers to remove the vertical ribs
.

Shorten the ventilation grille supports
by dimension A
(= ventilation grille console
overhang).

Secure the plinth facing to the run of
kitchen units.

Push the ventilation grille onto the
console.
Installing the appliance
32
 
						

							Fitting a furniture door
If there are no pre-drilled holes in the
furniture door, holes have to be drilled
as shown on the following drawing:
Drilling positions on framed doorsRemove screwsfrom the
underside of the appliance door.
Use the screws to secure both
bracketsto the underside of the
appliance door. The brackets must
be flush with the exterior of the
appliance door.
Shorten the brackets if necessary.
Installing the appliance
33
 
						

							Unscrew adjuster stripfrom the
appliance door and use the screws
supplied to secure it to the furniture
door.
Loosen the adjusting screwson
the appliance door until there is a
gap of 4.0 mm (see detail).

Use the adjusting strip to hang the
furniture door onto adjusting screws
.

Secure the furniture door at the top
using screws.

Secure the furniture door at the
bottom using the screws supplied
fitted through the bracket. Use the
washerssupplied.
Aligning the furniture door
Align the furniture door with
neighbouring furniture doors:
–
Height adjustment Yis made by
turning the upper adjusting screw.
–
Side adjustments Xare made by
moving the furniture door to the left
or right.
–
Depth adjustments Zare made by
gently shifting the furniture door
forwards or backwards.

First tighten the top adjusting screws
and, then the lower screws.

Finally replace coversand.
Installing the appliance
34
 
						

							35
 
						

							Alteration rights reserved / 2611
K 5122 UiM.-Nr. 09 087 400 / 00