Miele H 5981 Bp Manual

Oven interior
The oven interior is coated with dark
pyrolytic enamelwhich facilitates
cleaning.
This is a particularly hard enamel with
an extremely smooth surface and very
good anti-stick properties.
Manual cleaning of the oven interior
Allow the oven to cool down before
cleaning by hand.
Danger of burning!
The oven interior and the inside of
the door should be cleaned after
each use. If this is not done
subsequent soiling from baking and
roasting will become worse and
make cleaning harder. In extreme...

Pyrolytic cleaning of the oven interior
Before starting a pyrolytic cleaning
process please note the following:
Remove any coarse soiling from the
oven before you start.
Clean the inside of the door (glass).
There is a fibre-glass door seal
around the oven cavity.
This seal is particularly sensitive and
should not be cleaned unless
absolutely necessary. Rubbing can
damage it.
Remove all accessories from the
oven interior before starting the
pyrolytic cleaning process. This also
applies to the FlexiClip...

After the pyrolytic process, any
debris (e.g. ash) can easily be wiped
away.
Remember to wait until the oven has
cooled down before doing so!
Danger of burning.
Try not to wipe over the fibre-glass
seal when cleaning the oven cavity.
It is particularly sensitive and should
not be cleaned unless absolutely
necessary. Rubbing it can damage
it.
Most residues are easily wiped away
with a damp cloth.
Depending on soiling levels in the oven
there may be visible deposits on the
door and below the trim under the...

To remove the oven door
Take care when removing the door -
it weighs approx. 13.5 kg.
The oven door is connected to the oven
by hinges.
Before removing the door, the locking
clamps on both hinges have to be
released.
Open the door fully.

To release the locking clamps on the
hinges turn them upwards as far as
they will go until they are at an angle.
See illustration.

Then lift the door upwards as far as it
will go.
Do not attempt to take the door off
the hinge guides when it is in a
horizontal...

To dismantle the oven door
The oven door is made up of four
panes of glass and has vents at the top
and bottom.
When the oven is operating, air is
circulated through the door to keep the
outer pane cool.
If condensate has worked its way in
between the glass panes, the door can
be dismantled in order to clean in
between the panes.
When cleaning the glass panes
please follow the same instructions
given for cleaning the appliance
front.
Do not use abrasive cleaning
agents, sponges or brushes, as
these can...

You can now remove the inner and the
two middle panes.
Gentlylift the inner pane up and pull
out of the cover strip.

Remove the glass fibre seal.Now gently lift up the upper of the
two middle panes and remove it.

Gently lift up the lower of the two
middle panes and remove it.
Cleaning and care
66 

Clean the glass panes and other
components with a Miele E-cloth or a
clean sponge and a solution of hot
water and washing-up liquid. Wipe
dry using a soft cloth.
The fibre-glass seal is particularly
sensitive and should not be cleaned
unless absolutely necessary.
Rubbing it can damage it.
Clean the other parts with a damp
Miele E-cloth or a clean sponge and
a solution of hot water with a little
washing-up liquid. Wipe dry using a
soft cloth.
To reassemble the door:
The two middle panes are identical....

Refit the glass fibre seal.

Push the inner pane into the plastic
strip and insert it in the retainers.Flip the glass pane retainers inwards
to close them.
To refit the door

Hold the door securely at both sides
and carefully fit it back onto the hinge
guides.
Make sure that the door goes back
on straight.
Cleaning and care
68 

Open the door fully.
Flip both locking clamps back up as
far as they will go into a horizontal
position. Turn them as far as they will
go into a horizontal position.
It is essential that the clamps are
locked after refitting the door.
Otherwise the hinges could work
loose, resulting in damage to the
door.
To remove the FlexiClip
telescopic runners
Make sure the oven heating
elements are switched off and cool.
Take care not to burn yourself on
them.
Lift the FlexiClip runner up at the front
and pull it...

To remove the side runners
Make sure the oven heating
elements are switched off and cool.
Take care not to burn yourself on
them.
Pull the runners forwards out of the
holder and remove.
Reassemble them in the reverse
order, making sure all parts are
correctly fitted.
To lower the top heat/grill
element
Make sure the oven heating
elements are switched off and cool.
Take care not to burn yourself.
Pull the shelf runners out of the oven.
Unscrew the wing nuts and lower the
top heating element.
Do not use...