Miele G 832 Sc Manual

Additional features
Top Solo (18)
Using Top Solo will save water and
energy.
This program is recommended when
there is only a small load to clean. Top
Solo can be selected with all pro-
grams.
With this feature, water is directed only
to the top and middle spray arms in the
dishwasher. This means that the water
jets are only aimed at items in the up-
per basket and the cutlery tray.
The middle spray arm also directs wa-
ter downwards, so lightly soiled plates
or platters can be placed in the lower...

Extended drying
If desired drying results are not consis
-
tently achieved, the turbothermic cool
-
ing fan can be programmed to run an
extra 14 minutes at the end of each
program.
The Extended drying feature can also
be activated to prevent condensation
from collecting on the steam deflector.
Turning extended drying on/off
^Make sure the dishwasher is turned
off.
^Press and hold the Start/Stop (17)
button and at the same time turn the
dishwasher on using the On/Off but-
ton.
Release the Start/Stop...

With the aid of the following guide, minor problems can be fixed without a service
call.
,Repairs should only be carried out by a qualified and trained person in ac
-
cordance with local and national safety regulations. Unauthorized repairs could
cause personal injury or machine damage.
What if … Possible fault Fix
the dishwasher does not
start?The door is not properly
closed.Close the door firmly.
The machine is not
plugged in.Insert the plug.
The fuse is defective or
the breaker has tripped.Reset the...

What if … Possible fault Fix
the Drain indicator
flashes and the program
stops?The triple filter in the wash
cabinet is clogged.Clean the filter, see main
-
tenance instructions.
The drain pump or the
non-return valve may be
blocked.Clean the drain pump and
the non-return valve, see
maintenance instructions.
The drain hose is kinked. Remove the kink.
the End, Start/Stop
and Top Solo indica
-
tors flash at the same
time at the end of a pro
-
gram?There may be a technical
fault.–Press the Start/Stop...

What if … Possible fault Fix
there is a knocking
noise in the wash cabi
-
net?The spray arm is hitting an
item in the basket.Interrupt the program, re
-
arrange items blocking
the spray arms.
there is a rattling noise?Items are not secure in
the wash cabinet.Interrupt the program and
rearrange loose pieces.
there is a knocking
noise in the water
pipes?This may be caused by
the installation or the di
-
ameter of pipe.This has no effect on the
dishwasher. If in doubt
contact a plumber.
the dishes are not...

What if … Possible fault Fix
tea or lipstick stains
have not been com
-
pletely removed?The wash temperature of
the selected program was
too low.Select a program with a
higher temperature.
Not enough detergent
was used.Use more detergent.
white residue is visible
on cutlery and dishes,
clouding occurs on
glassware and film can
be wiped off?Not enough rinse aid was
used.Increase the dosage,
see Before using for the
first time.
The salt reservoir is
empty.Add reactivation salt,
see Before using for the...

What if … Possible fault Fix
plastic items are discol
-
ored?Natural dyes e. g. from
vegetables may be the
cause. Not enough deter
-
gent was used to break
down natural dyes.Use more detergent, see
Adding detergent.
Discoloration is perma
-
nent.
there are rust stains on
cutlery?The salt reservoir cap was
not screwed on properly.Reseat and screw the cap
on firmly.
The affected items are not
corrosion resistant.There is no remedy.
Only wash dishwasher
safe cutlery.
detergent is left in the
dispenser at...

In the event of a fault which you cannot
correct yourself please contact:
–Your Miele Dealer
or
–The Miele Technical Service Depart
-
ment.
USA 1-800-999-1360
[email protected]
CDN 1-800-565-6435
[email protected]
When contacting the Miele Technical
Service Department, please quote the
model and serial number of your appli-
ance.
These can be found on the data plate
on the upper inside edge of the dish-
washer door.Program update function - PC
The Program Correction (PC) allows a
technician to update...

To transport the dishwasher, e. g. when
moving to a new home, note the follow
-
ing:
–Empty the dishwasher.
–Secure any loose parts, e. g. hoses,
cables, cutlery baskets.
–Transport the dishwasher in the up
-
right position.
If unavoidable it may be transported
on its back.
Do not transport it on its side or on
the door. Residual water in the ma
-
chine could leak and cause electrical
damage.
Transport
39 

40