Miele F 1811 Vi Operating And Installation Instructions

Electrical connection U.K.
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
local and national safety regulations
(BS 7671 in the UK).
The appliance is supplied with a mains
cable and moulded plug ready for
connection to an a.c. single phase
220-240 V 50 Hz supply.
Please ensure that the connection data
quoted on the data plate match the
household mains supply.
Connection should be made via a
suitable switched socket which is easily...

Location
This appliance should be installed in a
dry, well-ventilated room. It should not
be installed where it is exposed to
direct sunlight or directly adjacent to a
heat-producing appliance such as an
oven or a radiator. The room
temperature should not go above or
below the climate range for which the
appliance is designed. The higher the
ambient temperature of the room, the
more energy the appliance requires to
operate.
If installation near a heat source is
unavoidable, observe the following...

Safe operation of the appliance is
only assured if it has been installed
and connected in accordance with
these operating and installation
instructions.
Warning!
This appliance is very heavy and
can tip forwards when the door is
open. Keep the door shut until the
appliance has been built in and
secured within the building-in niche
in accordance with these
instructions.
Due to the size and weight of the
appliance, installation must be
carried out by two people.
The weight of the appliance when
empty is:
F...

Floor
To ensure the safe installation of the
appliance and to guarantee its correct
functioning, the floor to the niche where
the appliance is to be installed must be
smooth and even.
It must be made from strong, rigid
material.
The appliance is extremely heavy when
fully loaded, and for this reason it is
imperative that the floor it stands on is
able to bear its weight. If necessary, the
advice of an architect or structural
engineer should be sought.
When fully loaded, the approx. weight
of the...

Side-by-side installation
This appliance may be installed
side-by-side with another suitable
refrigerator or freezer.
A side-by-side installation kit,
available from Miele, is required.
Ask your dealer which appliances
are suitable for side-by-side
installation with this appliance.
See the instructions supplied with
the side-by-side installation kit for
how to fix the appliances together.
Joining the two appliances together
with the side-by-side installation kit
If the appliances are to be installed
next...

Appliance door dimensions (opening angle 115°)
AB CD
F 1811 Vi829 mm Door front (max. 38 mm)* Door handle* 363 mm
F 1911 Vi982 mm Door front (max. 38 mm)* Door handle* 428 mm
* The dimensions for the door fronts and handles will vary according to the
individual kitchen.
Miele recommends using the full door opening angle of 115° for this freezer.
Installation advice
56
 

Niche width
A
F 1811 Vi762 – 765 mm
F 1911 Vi915 – 918 mm
Building-in dimensions
57
 

Laying the electrical cabling
and the pipework for the mains
water supplyDoor front dimensions
AB
F 1811 Vi2029 mm 756 mm
F 1911 Vi2029 mm 908 mm
Building-in dimensions
58
 

Due to the size and weight of the
appliance, it is essential that
installation is carried out by two
people.
Tools and accessories
required
–Cordless screwdriver
–Torx screwdriver
–Hammer drill
–Drill bits in various sizes, depending
on materials
– Hammer
– 8 mm socket wrench
– Adhesive tape
– Pipe wrench
– Spirit level
– Try-square
To secure the housing unit to a wall
behind:
–
suitable wall plugs/fixing screws for
the type and material of the wall.Other
–Step ladder
–Sack barrow
–Wooden beams (min. 75...

Stainless steel fronts
Stainless steel fronts and stainless steel
look plinth grilles are available from
your dealer or the Miele Spare Parts
Department.
Weight of the door front
Before fitting the door front, ensure that
the weight of the fronts does not
exceed the maximum permitted:
Appliance Max.
weight
of door front in kg
F 1811 Vi 48
F 1911 Vi 36
Fitting a door front which is heavier
than the maximum permitted could
damage the hinges.
Building into a peninsular run
When built into a peninsular run,...