Miele F 1811 Vi Operating And Installation Instructions

^Mark gapXon the inside of the
furniture front.
^Similarly, locate and mark the
midpointYon the furniture front.
^Remove the fixing frame from the
appliance door and position it
corresponding to the markings on the
furniture front.
^
Pre-drill the holes.
^
Screw the fixing frame to the furniture
front, using at least one screw for
each fixing point.
^
Secure the fixing frame to the top of
the furniture front, using at least 10
screws:–The fixing frame has several different
types of holes to take account...

Securing and aligning the
furniture door
^Insert the angle trim as far as it will
go into the spaces in the frame, as
shown.
^
Open the appliance door and hang
the furniture front on its frame onto
the threaded bolts, as shownp^Press the angle trim on both sides
into the white plastic frame, and
screw them down securely.
^Screw the nutsqloosely onto the
threaded bolts - but do not tighten
yet.
^Close the appliance door and check
the distance between the door and
neighbouring furniture doors.
^Align the...

Fitting the fixing brackets
The fixing brackets are used to secure
the furniture front to the bottom of the
appliance door.
^Open the appliance door as far as it
will go.
^Loosen the screws (1).
^Position the fixing bracket on the
appliance door (2) and pre-drill a
hole in the furniture front.
^
Screw the fixing bracket securely to
the furniture front (3).
^
Now tighten the screws (4).
^
Fit the cover to the fixing bracket (5).
The number of fixing brackets required
will depend on the material and width...

^Now attach the covers onto the
retaining clips on both sides.
In the case of side-by-side
installation, the cover strips are only
required on the outer side.
^
Fit the cover to the light contact
switch so that it clicks into place as
shown.
Fitting the plinth facing
Do not cover the vents in the plinth.
This could result in damage to the
appliance.
^Trim the plinth facing to the required
length and height (cut along the
lower edge of the plinth facing where
it touches the floor).
^
Secure the plinth to...

Fitting the air separator
The air separator at the bottom of the
ventilation grille separates air entering
the appliance from that leaving it.
It also stops warm air flowing into the
appliance, which would cause a short
circuit.
^If necessary the three parts of the air
separator can be shortened to the
correct height.
^
Replace the foam parts in the sides.^Screw the air separator into the
middle of the inside of the furniture
front, as shown.
Installation
75
 

Alteration rights reserved / 4211
F 1811 Vi, F 1911 ViM.-Nr. 09 169 140 / 00