Miele F 1471 Vi Operating And Installation Instructions

							Accessing the RemoteVision
control panel
^Touch the access button psoit
turns yellow.
^Note the position of the buttonX, but
do not touch.
^Touch the access button p again so
it turns white.
Only the access button p is visible.
^Place one finger on the position of
theXbutton and hold (theXbutton
will not be visible).
^While holding down theXbutton,
press the access button p once.
Keep holding theXbutton down until
the following appears in the display
(approx. 5 seconds).
Access to the Custom settings mode is
now active for approximately 10
seconds.^Tap theXbutton until;appears in
the display.
^Touch the access button pto
confirm.
See the table on the following page for
a description of each setting in the
display.
^Use theYorXbuttons to select the
RemoteVision options.
The module has been connected to
the network when;#appears in the
display.
If;#does not appear, refer to the
Network options section of the
XKM 2000 Installation Instruction
manual.
^Press and hold the access button p
for 2 seconds to confirm the change.
^To return to the main menu, tap theX
button until a solid;-appears in the
display.
^
Press the access button pto
confirm.
^
Tap theXbutton until a;appears in
the display.
^
Touch the access button p.
You have left the Custom settings
mode.
When you are in the Custom settings
mode the door alarm is turned off
automatically. Once the door is
closed it is reactivated.
RemoteVision
81
 
						

							MasterCool control panel options for RemoteVision
Selectable
optionsDescription of function
;-Back
;2Reboot the module
;3Reset the module to factory settings
;4Enter Ad-Hoc Mode
Note:If you cannot select any option (other than;-back), the module has not
been installed correctly.
Status indicators Description of function
Flashing;~Module booting phase
Flashing;|Connection to router established, no IP address assigned
Flashing;
						

							83
 
						

							Alteration rights reserved / 3408
For the most updated manual see the Miele web site.M.-Nr. 07 155 770 / 00