Miele F 1471 Vi Operating And Installation Instructions
Have a look at the manual Miele F 1471 Vi Operating And Installation Instructions online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 171 Miele manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Filter Performance Data Sheet 41 To a capacity of 739.68 gallons (2800 liters). * Based on the use of Cryptosporium parvum oocysts Performance Data Sheet For Filter Model 07134220 System tested and certified by NSF International in Model 07134220 against NSF/ANSI Standard 53 for the reduction of Cysts and Turbidity and against Standard 42 for the reduction of Chlorine Taste and Odor; Nominal Particulate Class I. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42 and 53. For estimated costs of replacement elements please visit your local appliance dealer or parts distributor. IMPORTANT: Must be installed and operated in accordance with application guidelines. Failure to do so may void warranty. Change filter at least every 6 months. Flush new cartridge for 3 minutes. Substance Average Influent Challenge Product Average Maximum Permissible Max. Min. % NSF Influent Concentration Water % Product Water Effluent Reduction Test Concentration mg/L Concentration Reduction Concentration Cysts* 166500 Minimum 50,000/L 1 99.99 99.95 1 99.99 516458-05 Turbidity 10.7 11 + 1 NTU 0.31 97.09 0.5 NTU 0.49 95.42 516456-05 Particulate Class I Particle size: At least 10,000 > 0.5 to < 1 um 5700000 particles/ml 30583 99.52 > 85% 69000 98.9 511079-03 Chlorine taste and odor 1.9 2.0 mg/L ± 10% 0.05 97.3 > 50% 0.06 96.84 511081-03 Note that while the testing was performed under standard laboratory conditions, actual performance may vary. WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. CAUTION: To avoid property damage due to water leakage, you MUST read and follow these operating instructions before installation and use of this product. Using Replacement Cartridge 07134220 Application Guidelines/Water Supply Parameters Water pressure 30- 120 psi (207 - 827 kPa) Water temperature* 33°F - 100°F (0.6°C - 38°C) Service flow 0.75 gpm (2.83 lpm) NSF is a registered trademark of NSF International. CUNO is a trademark of 3M Company used under license. © 2007 3M Company. All rights reserved.
With the aid of the following guide minor problems can be corrected without a ser - vice call. Repairs should only be carried out by a qualified and trained person in strict accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage and may void the warranty. Problems with temperature Issue Possible fault Solution The freezer does not get cold.The machine is not turned on.Check whether the appliance is switched on at the main switch. The access button must be lit up. The machine is not plugged in.Check that the plug is correctly inserted in the power outlet. Check that the fuse has not tripped.Reset the circuit breaker. The temperature is set incorrectly.Check the display. The temperature is too low.Select a warmer temperature.See Selecting the correct temperature. The SuperCool function is still on.SuperCool automatically shuts off after 52 hours. The door is not closed. Check that the door has been closed properly. A large amount of food is being frozen at the same time.This makes the compressor run longer, causing the temperature to fall automatically. The freezer is too warm.The room temperature is lower than the ambient temperature for which the appliance is designed.Raise the temperature of the room. Operating the appliance in a room that is too cold will cause the cooling system to switch off for too long, causing the freezer section to become too warm. Frequently asked questions 42
General problems Issue Possible fault Solution Water is flowing out of the appliance.Close the shut-off valve immediately. Check whether the water pipe in the appliance is defective.Contact Miele Technical Service. Check whether the water pressure is too low.Contact a plumber. Check whether the correct water valve has been installed.Self-tapping valves and 3/16 (4.76 mm) saddle valves reduce the water pressure and can block the pipe. The door will not open.This is not a fault. The suction caused by opening and closing the door too many times in succession prevents it from opening.Wait a few minutes, then try again. It should now open without force. The compressor kicks on very frequently and for too long.The ventilation slits are covered or dusty.Clean with a vacuum or brush. The door has been opened too frequently, or a large amount of unfrozen food has been put in at once for freezing.Once the freezer gets down to the set temperature the compressor will turn off. The door is not closed. Check that the door has been closed properly. Frequently asked questions 43
Alarm / Indicator warnings Issue Possible fault Solution The alarm is going off.The appliance door(s) have been open for longer than 5 minutes.Close the door. The alarm is ringing and the alarm indicator is flashing.The door is not closed. Once the alarm condition has been corrected, the alarm will turn off and the alarm indicator will stop flashing. The temperature indicator will indicate the highest temperature reached during the alarm. Check that food has not defrosted. A large amount of fresh food is being frozen at the same time. There has been a power failure. The filter display is red.This is a warning that the water filter needs to be changed soon.Order replacement filters from Miele. The filter display is flashing red.The water filter needs to be changed.See Replacing the water filter. The Lock indicator flashes in the display.The drip tray of the Ice/Water Dispenser is full.Empty the drip tray by soaking up the water with a sponge or dish cloth. Frequently asked questions 44
Problems with the ice/water dispenser Issue Possible fault Solution The ice maker will not switch on.The appliance is not plugged in.Check that the appliance is connected to the power supply. The ice maker is not producing any ice.When the appliance is turned on for the very first time, it can take up to 10 hours for the first ice cubes to drop out of the ice cube maker and collect in the container. The appliance is not turned on.Check that the appliance is switched on. The water supply line was not primed (purged of air) before the appliance was used for the first time.Contact Miele. Check if: – the Ice/Water dispenser is switched on. – the water supply line is open. – there are ice cubes stuck together and blocking the exit. – the ice cube container is in the right position. – the freezer compartment temperature is too high. – the water pressure is too low. The water pressure must be between 25 and 120 psi (1.72-8.25 bar).See Ice/Water Dispenser and/or Plumbing for more information. Check whether the correct water valve has been installed.Self-tapping valves and 3/16 (4.76 mm) saddle valves reduce the water pressure and can block the pipe. Frequently asked questions 45
Problems with the ice/water dispenser Issue Possible fault Solution The ice cubes are small.Other domestic appliances that use water are in operation.Avoid using such items as a dishwasher, washing machine or shower at the same time. Check whether the water filter needs changing.See Water filter for more information. Check the water pressure. The water pressure must be between 25 and 120 psi (1.72-8.25 bar).Consult a plumber. Check whether the correct water valve has been installed.Self-tapping valves and 3/16 (4.76 mm) saddle valves reduce the water pressure and can block the pipe. The Ice/Water has an unpleasant odor/flavor.When ice is stored for an extended period it may absorb odors, which affects the taste.Use the ice maker more frequently. Check if the ice cube container is dirty.Clean the container. Unsealed packages in the freezer will transfer odor/flavor particles to the ice cubes.Check that food has been packed in airtight containers. The Ice/Water dispenser is not producing ice or water.The Safety Lock is activated. See Ice/Water Dispenser - Safety Lock. Frequently asked questions 46
Problems with the ice/water dispenser Issue Possible fault Solution The ice maker is not producing enough ice or the ice cubes are misshapen.Check the water pressure. The water pressure must be between 25 and 120 psi (1.72-8.25 bar).Contact a plumber. Check that the freezer temperature is not too low.See Selecting the correct temperature. Change the water filter. See Water filter. The Ice/Water dispenser does not appear to be runningThe appliance is not plugged in.Check that the appliance is connected to the power supply. Check that the freezer is connected to the water supply.See Plumbing. The freezer temperature is too high.See Setting the temperature. Ice is forming in the supply hose to the ice maker.Check the water pressure. The water pressure must be between 25 and 120 psi (1.72-8.25 bar).Contact a plumber. Check whether the freezer compartment temperature is too high.See Selecting the correct temperature. A noise is heard periodically from the Ice/Water Dispenser.The Anti-clumping feature is activated.See Anti-clumping for more information or to deactivate. Frequently asked questions 47
In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting the Technical Service Department, please quote the model and serial number of your appliance given on the data plate inside the appliance.MieleCare (USA only) MieleCare, our Extended Service Contract program; gives you the assurance of knowing that your appliance investment is covered by 5 years of worry-free ownership. MieleCareis the only Extended Service Contract in the industry that guarantees repairs by a Miele Authorized Service Provider using genuine Miele parts. Only genuine Miele parts installed by factory-trained professionals can guarantee the safety, reliability and longevity of your Miele appliance. Please note that unless expressly approved in writing by the Miele Ser- vice department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. Our goal is to prevent unauthorized (and untrained) service personnel from working on your Miele products, possibly doing further damage to them, you and/or your home. To learn more aboutMieleCare Extended Service Contracts, please contact your appliance dealer or visit us online at: http://miele.com/mielecare After sales service 48
Installation instructions To prevent accidents and machine damage read these instructions before installation or use.
Disposal of packing materials The cardboard box and packing materials are biodegradable and recyclable. Please recycle. Ensure that any plastic wrappings, bags, etc., are disposed of safely and kept out of the reach of babies and young children. Danger of suffocation! Disposal of an old appliance Old appliances contain materials that can be recycled. Please contact your local recycling center about the possibility of recycling these materials. Before discarding an old appliance, disconnect it from the gas and electrical supply and cut off the power cord to prevent it from becoming a hazard. Caring for the environment 50