Home
>
Lucent Technologies
>
Communications System
>
Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Administration For Network Connectivity Instructions Manual
Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Administration For Network Connectivity Instructions Manual
Here you can view all the pages of manual Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Administration For Network Connectivity Instructions Manual. The Lucent Technologies manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 51
31Administration for Network Connectivity555-233-504 — Issue 1 — April 2000 CID: 77730 2 H.323 Trunks This chapter describes how to set up and perform initial administration of IP Trunks between DEFINITY ECS switches and between DEFINITY and non-DEFINITY switches that support the H.323 V2 signaling protocols. The IP trunk connections described in this chapter use the TN802B circuit pack in the MEDPRO mode. See Appendix F for administration of trunk connections that use the TN802 or TN802B in the IP...
Page 52
Overview 2 H.323 Trunks Administration for Network Connectivity CID: 77730 555-233-504 — Issue 1 — April 2000 32 IP-Connected Trunks IP-connected trunks allow trunk groups to be defined as ISDN-PRI-equivalent tie lines between switches over an IP network. Trunks using IP connectivity provide cost-reduction and simplified management. Benefits include a reduction in long distance voice and fax expenses, facilitation of global communications, full-function networks with data and voice convergence, and...
Page 53
H.323 Trunk Administration 33 Administration for Network Connectivity 555-233-504— Issue 1 — April 2000 CID: 77730 2 H.323 Trunks H.323 Trunk Administration This section describes the administration steps needed to setup H.323 trunks. The first subsection covers the enabling administration that needs to be in place before the trunk administration can be done. The second subsection gives a summary of the H.323 trunk administration and the last subsection gives the detailed steps. The screens used for...
Page 54
H.323 Trunk Administration 2 H.323 Trunks Administration for Network Connectivity CID: 77730 555-233-504 — Issue 1 — April 2000 34 Maintenance-Related System ParametersFour parameters on the Maintenance-Related System Parameters screen set threshold values for network performance: page 4 • Roundtrip Propagation Delay (sec) High: 800_ Low: 400_ •Packet Loss (%) High: 40__ Low: 15__ •Ping Test Interval (sec): 20 •Pings per Measurement Interval: 10 These parameters have no effect unless the bypass...
Page 55
H.323 Trunk Administration 35 Administration for Network Connectivity 555-233-504— Issue 1 — April 2000 CID: 77730 2 H.323 Trunks You can also use the Audio IP port number range field to specify a block of port numbers to be used for audio connections. Then, if your network is equipped with the appropriate data filtering devices, audio data can be segregated from other data traffic to improve quality of service. Open the screen with the change command (ch ip-p) and set the following fields: •Codec...
Page 56
H.323 Trunk Administration 2 H.323 Trunks Administration for Network Connectivity CID: 77730 555-233-504 — Issue 1 — April 2000 36 H.323 Trunk Administration — Task Summary After the enabling administration is complete, you can administer the H.323 IP trunks. The screens and fields that need to be administered are listed below. NOTE: This is only a list of screens and the fields that need to be administered. The values that need to be entered in these fields are described in the next section. Node...
Page 57
H.323 Trunk Administration 37 Administration for Network Connectivity 555-233-504— Issue 1 — April 2000 CID: 77730 2 H.323 Trunks Signaling GroupEach H.323 trunk must be assigned to a signaling group. Enter values in these fields: page 1 ~ Group Type ~Trunk Group for Channel Selection ~Near-end Node Name ~Near-end Listen Port ~Far-end Node Name (Optional) ~Far-end Listen Port (Optional ~LRQ Required? ~Calls Share IP Signaling Connection? ~Bypass If IP Threshold Exceeded? Page 2 — Administered NCA TSC...
Page 58
H.323 Trunk Administration 2 H.323 Trunks Administration for Network Connectivity CID: 77730 555-233-504 — Issue 1 — April 2000 38 IP Media ParametersEach DEFINITY switch in an IP network has one IP Media Parameters screen. Use this screen to enter: ~the types of codecs (for audio processing) available on this switch ~the preferred order of use of the codec types ~the range of port numbers available for audio connections Network RegionsThe Region field on the IP Interfaces screen allows you to set up...
Page 59
H.323 Trunk Administration 39 Administration for Network Connectivity 555-233-504— Issue 1 — April 2000 CID: 77730 2 H.323 Trunks Begin Task 1 Steps > Open Node Names screen — enter ch node-n > Go to page 2 of the screen > Enter values. > Submit the screen End change node-names Page 2 of 6 NODE NAMES Name IP Address Name IP Address clan-a1 ______ 192.168.10_.31_ ___________ ___.___.___.___ clan-a2 ______ 192.168.20_.31_ ___________ ___.___.___.___ default 0 .0 .0 .0 ___________ ___.___.___.___...
Page 60
H.323 Trunk Administration 2 H.323 Trunks Administration for Network Connectivity CID: 77730 555-233-504 — Issue 1 — April 2000 40 Task 2 — Define IP Interfaces The IP interface for each C-LAN and MedPro board on the switch must be defined on the IP Interfaces form. Each DEFINITY switch in an IP network has one IP Interfaces form. Begin Task 2 Steps > Open IP Interfaces form — enter ch ip-i > Enter values change ip-interfaces Page 1 of 2 IP Interfaces Inter-region IP connectivity allowed? n...