Lexmark W820n User Manual

319
The manufacturer is not responsible for any radio or television interference caused by using other than
recommended cables or by unauthorized changes or modifications to this equipment. Unauthorized
changes or modifications could void the users authority to operate this equipment.
Note:To assure compliance with FCC regulations on electromagnetic interference for a
Class A computing device, use a properly shielded and grounded cable such as
Lexmark part number 1329605. Use of a substitute cable not...

320
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna....

321
Japanese VCCI notice
The United Kingdom Telecommunications Act 1984
This apparatus is approved under the approval number NS/G/1234/J/100003 for the indirect
connections to the public telecommunications systems in the United Kingdom.
German acoustics statement
The following measurements were made in accordance with ISO 7779 and reported in conformance
with ISO 9296.
Energy Star
The EPA ENERGY STAR Computers program is a partnership effort with computer manufacturers to
promote the introduction of...

322
Laser notice
The following laser notice label may be affixed to this printer as shown:
Class 1 laser statement label
Laser notice
The printer is certified in the U.S. to conform to the requirements of DHHS 21 CFR Subchapter J for
Class I (1) laser products, and elsewhere is certified as a Class I laser product conforming to the
requirements of IEC 825.
Class I laser products are not considered to be hazardous. The printer contains internally a Class IIIb
(3b) laser that is nominally a 5 milliwatt...

323
Index
A
A4 Width (PCL Emul Menu) 234
Abort Restore (Job Menu) 220
aborting restoration of held jobs
220
Adapter, Tri-Port 61
Advanced Status (Parallel Menu)
241
Alarm Control (Setup Menu) 226
alarms 226
error messages 226
hole punch 228
setting 226
stapler 232
toner 232
Assign Type/Bin (Paper Menu)
200
Auto Continue (Setup Menu) 227
Auto CR after LF (PCL Emul Menu)
235
Auto LF after CR (PCL Emul Menu)
235
auto size sensing 30
disabling 180
enabling 180
multipurpose feeder, no support
18
special sizes...

324
fax 220
fax, canceling 220
finisher 38, 159
bins 38
cables, unplugging 161
check installation 273
disconnecting from printer 160
divertor cover, removing 164
removing 159
bin 2 160
from printer 159
from stand 163
stand, disassembling 166
staple cartridge, replacing 110
staple jam, clearing 99
staple positions 40
Finishing Menu 208
Blank Pages 208
Collation 209
Copies 209
Duplex 209
Duplex Bind 210
Hole Punch 210
Multipage Border 210
Multipage Order 211
Multipage Print 212
Multipage View 212
Offset...

325
Licensing notice 317
Lines per Page (PCL Emul Menu)
236
linking 30
bins 39
trays 30
loading 31
envelope feeder 34
multipurpose feeder 31
trays1,2,and3 23
trays 4 and 5 27
LocalTalk Addr (LocalTalk Menu)
261
LocalTalk Buffer (LocalTalk Menu)
262
LocalTalk Menu 261
Job Buffering 261
LocalTalk Addr 261
LocalTalk Buffer 262
LocalTalk Name 262
LocalTalk Port 262
LocalTalk Zone 262
NPA Hosts 263
NPA Mode 263
PCL SmartSwitch 263
PS SmartSwitch 264
LocalTalk Name (LocalTalk Menu)
262
LocalTalk port 261...

326
Held Jobs May Not Be Restored
280
Infrared 281
Insert Box M 281
Insert Print Cartridge 281
Insert Staple Cartridge 282
Insert Tray  282
Invalid Network  Code 282
Load Env Feeder 283
Load Manual 283
Load MP Feeder 284
Load Staples 284
Load Tray  285
LocalTalk  285
Maintenance 285
Menus Disabled 286
Network  286
Network , 286
Network Card Busy 286
No Jobs Found. Retry? 287
Not Ready 287
Ovrflow Bin Full 287
paper jams, understanding 63
Parallel  287
Performing Self Test 288
Power Saver 288
Priming...

327
reprinting jammed pages 228
paper jams, clearing 63
duplex unit 84
fuser area 82
multipurpose feeder 80
optional finisher 90
optional mailbox 87
tray 1 71
tray 2 73
tray 3 74
tray 4 76
tray 5 77
Paper Loading (Paper Menu) 203
Paper Menu 199
Assign Type/Bin 200
Configure Bins 200
Configure MP 201
Custom Types 201
Output Bin 202
Overflow Bin 202
Paper Loading 203
Paper Size 204
Paper Source 204
Paper Texture 205
Paper Type 206
Substitute Size 207
Universal Setup 207
paper path 63
with duplex unit...

328
font priority 240
font sample print 218
font support 195
printing PS errors 240
resident fonts 188
PostScript Menu 240
Font Priority 240
Print PS Error 240
power saver 230
configuring 230
Power Saver (Setup Menu) 230
Prime Stapler (Job Menu) 222
priming the stapler 139
Print and Hold jobs 13
Print Buffer (Job Menu) 222
print cartridge 103
installing 105
ordering 102
recycling 138
removing 103
replacing 103
Print Directory (Utilities Menu) 218
Print Fonts (Utilities Menu) 218
print job, canceling 10...