Lexmark Optra S 1250 Manual

285Output Expanders
Output Expanders
Installing Options
If you follow these steps to install a output expander on top of
another one, the mounting slots on the output expander look as
shown: 

Output Expanders286
Output Expanders
Installing Options
4Locate the four tabs on the output expander tray and
the four slots on the output expander.
There are two of
each on each side.
5Hold the output expander tray on both sides and tilt
the front toward you. Slide the lower tabs on the tray
fully into the lower slots on the output expander.
Slots
Tabs 

287Output Expanders
Output Expanders
Installing Options
6Rotate the output expander tray upward from the front
and slide
the upper tabs on the tray into the upper
slots on the output expander
.The tabs click in place.
Note:At this point, you may attach another output expander to
the output expander you just installed. To do this, complete
step 3 on page 284 again, but install the mounting brackets
of the second expander into the mounting slots on the first
output expander you installed. Complete step 4...

Output Expanders288
Output Expanders
Installing Options
7Align the tabs on the left side of the top cover with the
left side of the opening at the top of the output expander.
The tabs must go underneath the left side cover of the
output expander.
8Push the right side of the top cover down until it
snaps into place on the output expander.
Note:Verify that the output expander is installed
properly. See “Verifying the Installation of Options”
on page 325.
9Turn the printer power On (|).
Tabs
Top Cover 

289Output Expanders
Output Expanders
Installing Options
Removing an Output Expander Tray
To remove the output expander tray:
1Hold the edge of the tray and lift it up so the lower tabs
come out of the slots on the output expander. 

Output Expanders290
Output Expanders
Installing Options
2Pull the tray straight out toward you to remove the upper
tabs from the output expander slots. 

291Output Expanders
Output Expanders
Installing Options
Changing Output Bin Settings
You can select output bin functions from the operator panel or
from your software application, if it supports output bin selection.
If the software setting differs from the operator panel setting, the
software setting overrides the panel setting.
For example, if you selectBin 2from the operator panel, but the
software specifies the printer standard bin, the printer prints to the
printer standard bin. If you selectBin...

Output Expanders292
Output Expanders
Installing Options
TheLinksetting allows for bin linking. Bin linking causes all the
output bins (standard bin and output options) to be linked
together as though they are one large bin. The printer fills the
Standard Bin first. When it is full, the printer starts filling the first
output option. As each output option is filled, the printer switches
to the next installed output option. When the standard bin and all
output options are full, the printer issues theRemove...

MemoryandOptionCards
Chapter
Memory and Option Cards293
Installing Options
Memory and
Option Cards
16
You can purchase optional memory and option cards for your
printer to enhance its performance. Follow the instructions in this
chapter to install them on your printer system board.
Accessing the Printer System Board
Complete the following steps before you install a printer memory
option, flash memory option, or an option card. Instructions for
installing and using the options follow these steps.
1Turn...

Memory and Option Cards294
MemoryandOptionCards
Installing Options
3Press down and pull on the side door latches to release
the door.
4Remove the side door, and lay it aside.