Lexmark C 950 Service Manual

Repair information 4-167
  5058-030
Go Back Previous
Next
14.Remove the five screws (A) from the toner dispense motor.
15.Disconnect the four toner dispense motor cables (B).
A
B 

4-168  Service Manual 5058-030  
Go Back Previous
Next
16.Disconnect the four cable clamps (C) from the motor and remove the cable harness.
17.Disconnect the four cables (D) from the front side of the printer. 
C 

Repair information 4-169
  5058-030
Go Back Previous
Next
18.From the rear side of the printer, disengage the toner dispense motor and remove.
Toner smart chip PCB removal
1.Remove the top cover. See “Printer top cover removal” on page 4-12.
2.Remove the cable (A) from the toner smart chip PCB that will be removed. 

4-170  Service Manual 5058-030  
Go Back Previous
Next
3.Detach the toner smart chip PCB and remove.
Touch screen (SFP) removal
1.Remove the operator panel front cover. See “Operator panel front cover (SFP)” on page 4-8.
2.Remove the operator panel. See “Operator panel assembly (SFP) removal” on page 4-126.
3.Remove the operator panel PCBA. See “Operator panel PCBA (SFP) removal” on page 4-127.
4.Remove the four screws (A) securing the plastic frame to the assembly. 

Repair information 4-171
  5058-030
Go Back Previous
Next
5.Remove the plastic frame and the metal shield.
6.Remove the touch screen.
Transfer belt assembly removal
1.Open the printer front door.
2.Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-175. 

4-172  Service Manual 5058-030  
Go Back Previous
Next
3.Rotate the transfer belt lever counterclockwise to the unlock position.
4.Open the printhead retract door.
Warning:  After the photoconductor units are removed, ensure that they are properly covered so that they are 
not exposed to light.
5.Remove the four photoconductor units.
6.Remove the transfer belt lever. See “Transfer belt lever removal” on page 4-177.
7.Open the printer left duplex door assembly.
8.Remove the fuser. See “Fuser assembly...

Repair information 4-173
  5058-030
Go Back Previous
Next
10.Remove the rear plastic support strap.
11.Rotate the front plastic support strap 90 degrees and release it from the machine.
12.Remove the screw (B) securing the rear belt retaining bracket. 

4-174  Service Manual 5058-030  
Go Back Previous
Next
13.Remove the rear belt retaining bracket.
14.Remove the screw (C) securing the front belt retaining bracket.
15.Remove the front belt retaining bracket. 

Repair information 4-175
  5058-030
Go Back Previous
Next
16.Pull the belt release latch to disengage the transfer belt assembly.
Warning:  When removing the transfer belt assembly from the machine, do not touch the belt surface or 
damage will occur.
Warning:  When removing the transfer belt assembly, make sure the belt’s surface does not come into contact 
with the printer left duplex door assembly.
17.Carefully remove the transfer belt assembly from the machine.
Transfer belt cleaner removal
1.Open...

4-176  Service Manual 5058-030  
Go Back Previous
Next
3.Unscrew the knob (A).
4.Pull out the transfer belt cleaner and remove.
A