Land Rover Freelander 2003my Electrical Library Rover Manual

DESCRIPTION AND OPERATION
4.16FREELANDER 03MY
When the passenger door window switch is pressed to raise the window, current flows 
across the switch (C0321) to the passenger door window lift motor (C0326) on a U then OU 
wire. Current flows across the motor (C0326) and back to the passenger door window switch 
(C0321) on an OR then R wire. The motor is provided an earth path via the passenger door 
window switch (C0321) on a B wire. The passenger door window will now move upwards 
until the switch is...

DESCRIPTION AND OPERATION
FREELANDER 03MY 4.17
The console mounted switch (C0264) is earthed on a B wire. The window will now move 
downwards until the switch is released.
When the LH rear console switch is pressed to raise the window, current flows across the 
switch (C0264) to the door mounted switch (C0732) on a GU then WU wire. The door 
mounted switch (C0732) now provides a feed to the window lift motor (C0304) on a U wire. 
Current flows across the motor (C0304) and back to the door mounted switch...

DESCRIPTION AND OPERATION
4.18FREELANDER 03MY
Tail Door Window 
General
Feed from the positive battery terminal (C0192) is supplied to fusible link 3 and fusible link 
4 of the engine compartment fuse box (C0632) on an R wire. Fusible link 4 (C0574) is 
connected to fuse 14 and fuse 31 of the passenger compartment fuse box (C0587) by an 
NW wire. Fuse 31 (C0583) provides a constant battery feed to the tail door window lift relay 
(C0043) on a PN wire. Fuse 14 (C0583) provides a constant battery feed to...

DESCRIPTION AND OPERATION
FREELANDER 03MY 4.19
Roof On Switch (3 Door Vehicles Only)
The roof on switch (C0497) is located on the RH D post, and is provided a constant battery 
feed by fuse 14 of the passenger compartment fuse box (C0583) on a P wire. The roof on 
switch is closed when the hard back is fitted, or the soft back is in the fitted position. In this 
instance current flows across the switch (C0497) to the CCU (C0428) on a PY wire.
If the hard back is removed (or the soft back is folded down)...

DESCRIPTION AND OPERATION
4.20FREELANDER 03MY
Tail Door Open Switch
The CCU (C0428) monitors the condition of the tail door exterior handle by providing a feed 
to the tail door open switch (C0615) on an N wire. When the tail door handle is operated, 
current flows across the switch (C0615) to earth on a B wire. When the CCU registers this 
earth, it delays opening the tail door and lowers the tail door window approximately 17 mm. 
The CCU (C0428) also monitors the condition of the tail door barrel...

DESCRIPTION AND OPERATION
FREELANDER 03MY 4.21
SUNROOF
DESCRIPTION
General
An electrically operated sunroof is fitted to 5 door vehicles only. The sunroof will only operate 
when the ignition switch is in the ignition position, and is controlled via a non-latching rocker 
switch mounted on the centre console. 
When the upper half of the switch is pressed and held, the sunroof will move to its tilt 
position. When the lower half of the switch is pressed and held, the sunroof will return to its 
closed...

DESCRIPTION AND OPERATION
4.22FREELANDER 03MY
Close
When the top half of the sunroof switch is depressed (with the sunroof in the fully open 
position), a feed is provided to the sunroof motor (C0614) from the switch (C0363) on an S 
wire. Current flows across the motor (C0614) and back to the switch (C0363) on a G wire. 
The switch (C0363) is earthed on a B wire. The motor will now power the sunroof back to 
the fully closed position.
Tilt
When the top half of the sunroof switch is depressed (with the...

DESCRIPTION AND OPERATION
FREELANDER 03MY 4.23
DOOR MIRRORS
DESCRIPTION
General
The electrically operated door mirrors are controlled via the multi-directional switch mounted 
on the fascia adjacent the instrument pack. Rotating the switch to the left, allows movement 
of the LH door mirror. A movement in the switch position will now be replicated by the LH 
door mirror. Rotating the switch to the right allows movement of the RH door mirror in the 
same way. The central switch position inhibits operation...

DESCRIPTION AND OPERATION
4.24FREELANDER 03MY
Down
When the door mirror switch is moved downwards, it provides a feed to the LH vertical motor 
(C0319) on an SW wire. Current flows across the motor (C0319) and back to the switch 
(C0066) on a BP then BY wire. The switch (C0066) provides the motor an earth path on a B 
wire. The motor will move the mirror downwards until the switch is released, or it reaches 
the end of its travel.
Left
When the door mirror switch is moved to the left, it provides a feed...

DESCRIPTION AND OPERATION
FREELANDER 03MY 4.25
Left
When the door mirror switch is moved to the left, it provides a feed to the RH horizontal 
mirror (C0319) on an SW wire. Current flows across the motor (C0319) and back to the 
switch (C0066) on a BN wire. The switch (C0066) provides the motor an earth path on a B 
wire. The motor will move the mirror left until the switch is released, or it reaches the end of 
its travel.
Right
When the door mirror switch is moved to the right, it provides a feed to...