Home
>
Land Rover
>
Automobile
>
Land Rover Defender 1999 2002my Workshop Supplement Body Repair 3rd Edition Rover Manual
Land Rover Defender 1999 2002my Workshop Supplement Body Repair 3rd Edition Rover Manual
Here you can view all the pages of manual Land Rover Defender 1999 2002my Workshop Supplement Body Repair 3rd Edition Rover Manual. The Land Rover manuals for Automobile are available online for free. You can easily download all the documents as PDF.
Page 21
01INTRODUCTION 14 INFORMATION READING THIS SUPPLEMENT This Supplement is divided into sections shown on the contents page, alongside a range of icons, familiar to service technicians. Relevant information is contained within each of these sections. These are further divided into the following sub-sections which appear at the foot of each page :- Description and operation. Adjustment. Repair. Overhaul. To avoid repeating information through the sections, where part of the repair operation impacts on...
Page 22
04 - GENERAL SPECIFICATION DATA CONTENTS Page INFORMATION ENGINE - Td5 1...................................................................................................... FUEL SYSTEM - Td5 3........................................................................................... COOLING SYSTEM - Td5 3.................................................................................... CLUTCH - Td5 3........................................................................................................
Page 24
GENERAL SPECIFICATION DATA 1 INFORMATION ENGINE - Td5 Type 2.5 litre in-line direct injection Diesel, turbocharged................................................................................. and intercooled Number of cylinders 5 in-line, No. 1 cylinder at front of engine......................................................... Bore 84.450 mm (3.3248 in)................................................................................. Stroke 88.950 mm (3.5020...
Page 25
04GENERAL SPECIFICATION DATA 2 INFORMATION Gudgeon pins Type Fully floating, offset towards piston thrust side.................................................................................. Piston rings Type Upper compression Barrel edge, chrome plated................................................. Lower compression Taper faced................................................. Oil control Bevelled ring with spring................................................................ New ring to groove...
Page 26
GENERAL SPECIFICATION DATA 3 INFORMATION FUEL SYSTEM - Td5 Type Direct injection from pressure regulated supply with................................................................................. cooled return flow Pressure regulator setting 4 bar (58 lbf.in 2) ................................................ Pump Electric two stage submersible................................................................................ Pump output Low pressure 30 l/h (6.6 gal/h) at 0.5 bar (7.25 lbf.in 2)...
Page 27
04GENERAL SPECIFICATION DATA 4 INFORMATION TRANSMISSION - Td5 Main gearbox Type R380 Single helical constant mesh....................................................................... Speeds 5 forward, 1 reverse, all synchromesh............................................................................. Transfer box Type LT230TE Two speed reduction on main gearbox output. Front................................................................. and rear drive permanently engaged via a lockable...
Page 28
GENERAL SPECIFICATION DATA 5 INFORMATION STEERING Power steering box Make/type Adwest Varamatic - worm and roller box........................................................................ Ratio Variable: straight ahead 19.3:1 on lock 14.3:1................................................................................. Steering wheel turns, lock-to-lock 3.375.................................... Steering pump Make/type Hobourn-Eaton series...
Page 29
04GENERAL SPECIFICATION DATA 6 INFORMATION SUSPENSION Type Coil springs controlled by telescopic dampers front................................................................................. and rear. Front Transverse location of axle by Panhard rod, and fore................................................................................. and aft location by two radius arms. Anti-roll bar fitted as standard on 90 models with 265/75 tyres and 130 models. Rear Fore and aft movement inhibited by two...
Page 30
GENERAL SPECIFICATION DATA 7 INFORMATION SHOCK ABSORBERS Type Telescopic, double-acting non-adjustable................................................................................. Bore diameter 35.47mm................................................................... BRAKES Front brake Caliper AP Lockheed, four opposed pistons.............................................................................. Operation Hydraulic, self...