Land Rover Defender 1999 2002my Workshop Supplement Body Repair 2nd Edition Rover Manual

19FUEL SYSTEM
12
REPAIR FUEL TANK
Service repair no - 19.55.01
Remove
1.Drain fuel tank.See Adjustment.
2.Raise rear of vehicle.
WARNING: Support on safety stands.
Vehicles fitted with tow bar
3.Remove 2 bolts securing support bars to drop
plate.
4.Loosen 2 nuts securing support bars to chassis.All Vehicles
5.Remove 2 nuts securing fuel tank support to rear
chassis member.
6.Remove 2 bolts securing fuel tank support plate
to chassis member.
7.Release clip securing filler hose and release
hose from filler...

FUEL SYSTEM
13
REPAIR
8.Disconnect vent hose from clips on rear chassis
member.
9.Support weight of fuel tank.
10.With assistance, lower fuel tank and remove
support plate.
11.Disconnect multiplug from fuel pump.
12.Noting their fitted position, disconnect 4 fuel
hoses from fuel pump.
13.Release clip and disconnect filler neck breather
from fuel tank.
14.With assistance, lower and remove fuel tank.
15.Remove 2 scrivits securing heat shield remove
heat shield.
16.Release clip securing breather hose to...

19FUEL SYSTEM
14
REPAIR Refit
19.Clean fuel pump and mating face.
20.Fit new fuel pump sealing ring.
21.Fit fuel pump and secure with locking ring.
22.Fit breather hose and secure clip.
23.Position heat shield and secure with scrivits.
24.With assistance position fuel tank and support
plate.
25.Connect fuel hoses and multiplug to fuel pump.
26.Connect filler neck breather and secure clip.
27.Position vent hose and secure to chassis clips.
28.Raise fuel tank to its fitted position.
29.Fit nuts and bolts...

FUEL SYSTEM
15
REPAIR 

26 - COOLING SYSTEM
CONTENTS
Page
DESCRIPTION AND OPERATION
COOLING SYSTEM COMPONENT LAYOUT 2.....................................................
COOLING SYSTEM COOLANT FLOW 4...............................................................
GENERAL 5............................................................................................................
OPERATION 11......................................................................................................
ADJUSTMENT
DRAIN AND REFILL...

COOLING SYSTEM
1
DESCRIPTION AND OPERATION This page is intentionally left blank 

26COOLING SYSTEM
2
DESCRIPTION AND OPERATION COOLING SYSTEM COMPONENT LAYOUT 

COOLING SYSTEM
3
DESCRIPTION AND OPERATION
NOTE: Inset A shows differences for Pre
EU3 models
1.Pressure cap
2.Overflow pipe
3.Heater return hose
4.Heater matrix
5.Heater inlet hose
6.Oil cooler return pipe - EU3 models
7.Connecting hose
8.Oil cooler housing assembly
9.Heater inlet pipe
10.Connecting hose
11.Outlet housing
12.Engine Coolant Temperature (ECT) sensor
13.Bleed screw
14.Radiator top hose
15.Radiator - upper
16.Intercooler
17.Gearbox oil cooler
18.Radiator - lower
19.Viscous fan
20.Drain...