Land Rover Borg Warner 44 62 Transfer Box Overhaul Rover Manual
Here you can view all the pages of manual Land Rover Borg Warner 44 62 Transfer Box Overhaul Rover Manual. The Land Rover manuals for Automobile are available online for free. You can easily download all the documents as PDF.
Page 31
TRANSFER BOX OVERHAUL17 DIFFERENTIAL UNIT Service repair no - 41.20.13/01 Remove 1.Remove drive chain. See this section. 2.Remove differential unit from rear output shaft. Refit 1.Fit differential unit to rear output shaft. 2.Fit drive chain. See this section. DIFFERENTIAL BEARINGS Service repair no - 41.20.17/01 Remove 1.Remove differential unit from transfer box. See this section. 2.Using a suitable puller, remove 2 bearings from differential unit. Refit 1.Ensure bearing and differential mating faces...
Page 32
TRANSFER BOX 18 OVERHAUL REAR OUTPUT SHAFT Service repair no - 41.20.18/01 Remove 1.Remove differential unit. See this section. 2.Remove rear output shaft from rear casing. Refit 1.Fit rear output shaft to rear casing. 2.Fit differential unit. See this section. REAR OUTPUT SHAFT BEARING Service repair no - 41.20.19/01 Remove 1.Remove rear output shaft. See this section. 2.Remove dust shroud from transfer box rear casing. 3.Using a flat bladed screwdriver free of rough edges, ease oil seal from rear...
Page 33
TRANSFER BOX OVERHAUL19 Refit 1.Clean bearing and rear casing mating surfaces. 2.Press bearing into rear casing. 3.Fit circlip retaining bearing in rear casing. 4.Clean sealing area of rear casing and running surface of drive flange. Ensure all traces of rubber are removed. CAUTION: Do not use a metal scraper as this may damage sealing surfaces. 5.Lubricate sealing surfaces of seal with clean gearbox oil. 6.Using LRT-41-013, fit oil seal to transfer gearbox rear casing. 7.Fit dust shroud to transfer box...
Page 34
TRANSFER BOX 20 OVERHAUL INTERMEDIATE SHAFT REAR BEARING Service repair no - 41.20.21/01 Remove 1.Remove intermediate shaft drive gear. See this section. 2.Remove 2 magnets from rear casing. 3.Release oil strainer clip from rear casing. 4.Expand snap ring retaining intermediate shaft rear bearing to rear casing. 5.Remove intermediate shaft, oil pump and strainer assembly from rear casing. 6.Remove circlip retaining intermediate shaft bearing to intermediate shaft. 7.Using a suitable puller, remove...
Page 35
TRANSFER BOX OVERHAUL21 INTERMEDIATE SHAFT Service repair no - 41.20.20/01 Remove 1.Remove oil pump. See this section. 2.Remove circlip from intermediate shaft. Refit 1.Fit circlip to intermediate shaft. 2.Fit oil pump. See this section.
Page 36
TRANSFER BOX DATA, TORQUE & TOOLS1 TORQUE SETTINGS Output shaft drive flange nut 220 Nm. (162 lbf.ft)................... Front gearcase to rear gearcase bolts 35 Nm. (26 lbf.ft)............ VCU housing to gearcase bolts 35 Nm. (26 lbf.ft)................. Speed sensor 30 Nm. (22 lbf.ft).............................. Drain/Refill plugs 25 Nm. (18 lbf.ft)............................ Temperature sensor 15 Nm. (11 lbf.ft)......................... Ratio control motor to gearcase bolts 10 Nm. (7...