Kyocera TASKalfa 250ci User Manual

 
OPERATION GUIDEix
Caution / Warning Labels
Caution / Warning labels have been attached to the machine at the following locations for safety purposes. Be 
sufficiently careful to avoi d fire or electric shock when removing a paper jam or when replacing toner.
Do not touch the support area for the 
document processor as there is a 
danger that your fingers or other 
objects may become caught or 
pinched, and this can result in injury.
Label inside the machine 
(Laser radiation warning)
High temperature...

 
xOPERATION GUIDE
Installation Precautions
Environment
CAUTION
Avoid placing the machine on or in locations which ar e unstable or not level. Such locations may cause 
the machine fall down or fall over. This type of situation presents a danger of personal injury or damage 
to the machine.
Avoid locations with humidity or dust and dirt. If dust or dirt become attached to the power plug, clean 
the plug to avoid the danger of fire or electrical shock.
Avoid locations near radiators, heaters or other heat...

 
OPERATION GUIDExi
Message: Warning for high temperature. Adjust the ro
om temperature. or  Warning for low temperature. 
Adjust the room temperature.
To use the machine under optimum conditions, adjust t he temperature and the humidity of your room if the 
message is displayed.
• Avoid locations near a window or with exposure to direct sunlight.
• Avoid locations with vibrations.
• Avoid locations with drastic temperature fluctuations.
• Avoid locations with direct exposure to hot or cold air.
• Avoid...

 
xiiOPERATION GUIDE
Precautions for Use
Cautions when using the machine
WARNING
Do not place metallic objects or containers with water (flower vases, flower pots, cups, etc.) on or near 
the machine. This type of situation presents a danger  of fire or electrical shock should they fall inside.
Do not remove any of the covers from the machine as there is a danger of electrical shock from high 
voltage parts inside the machine.
Do not damage, break or attempt to repair the power cord. Do not place heavy...

 
OPERATION GUIDExiii
CAUTION
Do not pull the power cord when removing it from the outlet. If the power cord is pulled, the wires may 
become broken and there is a danger of fire or electrical shock. (Always grasp the power plug when 
removing the power cord from the outlet.)
Always remove the power plug from the outlet when moving the machine. If the power cord is 
damaged, there is a danger of fire or electrical shock.
Always hold the designated parts only when lifting or moving the machine.
If this...

 
xivOPERATION GUIDE
Cautions when handling consumables
CAUTION
Do not attempt to incinerate the toner container or the waste toner box. Dangerous sparks may cause 
burns.
Keep the toner container and the waste toner box out of the reach of children.
If toner happens to spill from the toner container or the waste toner box, avoid inhalation and ingestion, 
as well as contact with your eyes and skin.
• If you do happen to inhale toner, move to a place with fresh air and gargle thoroughly with a large...

 
OPERATION GUIDExv
Other precautions
Return the exhausted toner container and waste toner box to your dealer or service representative. The 
collected toner container and waste toner box will be recycled or disposed in accordance with the relevant 
regulations.
Store the machine while avoiding exposure to direct sunlight.
Store the machine in a place wher e the temperature stays below 40ºC  while avoiding sharp changes of 
temperature and humidity.
If the machine will not be used for an extended period...

 
xviOPERATION GUIDE
SAFETY OF LASER BEAM
1. Safety of laser beam
This machine has been certified by the manufacturer to Class 1 level under the radiation performance 
standards established by the U.S.DHHS (Department of Health and Human Services) in 1968. This 
indicates that the product is safe to use during normal operation and maintenance. The laser optical 
system, enclosed in a protective housing and sealed within the external covers, never permits the laser 
beam to escape.
2. The CDRH Act
A...

 
OPERATION GUIDExvii
3. Optical unit
When checking the optical unit, avoid direct exposure to the laser beam, which is invisible. Shown at below is 
the label located on the cover of the optical unit.
4. Maintenance
For safety of the service personnel, follow the maintenance in structions in the other section of this manual.
5. Safety switch
The power to the laser unit is cut off when the front cover is opened.
Downloaded From ManualsPrinter.com Manuals 

 
xviiiOPERATION GUIDE
Safety Instructions Regarding the Disconnection of Power
Caution: The power plug is the main isolation device! Othe r switches on the equipment are only functional 
switches and are not suitable for isolat ing the equipment from the power source.
Attention: Le débranchement de la fiche secteur est le seul moyen de mettre l’appareil hors tension. Les 
interrupteurs sur l’appareil ne sont que des interrupteurs de fonctionnement: ils ne mettent pas l’appareil hors 
tension.
Other...