Kyocera FS 9130DN User Manual

Machine Parts 
OPERATION GUIDE1-3
Components at the Left and the Rear of the Printer
15 Power Cord Connector
16 Option Unit Connector
17 Handles for Transport
18 Left Cover 2
19 Lock Lever
20 Left Cover 1
1617 18 20
19
15
Downloaded From ManualsPrinter.com Manuals 

Machine Parts 
1-4OPERATION GUIDE
Components at the Right of the Printer
21 Memory Card Slot
22 Option Interface Slot (OPT)
23 Option Memory Slot Cover
24 USB Memory Slot (A1)
25 Parallel Interface Connector
26 Option Hard Disk Unit Slot (HDD)
27 Network Interface Connector
28 USB Interface Connector (B1)
21
22
23
2
4
25
26
2
7
28
Downloaded From ManualsPrinter.com Manuals 

OPERATION GUIDE2-1
2 Printing Operation
This chapter contains explanations on the following topics:
•Loading Printer Driver .................................................  2-2
•Printing from Application Software ..............................  2-3
Downloaded From ManualsPrinter.com Manuals 

Printing Operation 
2-2OPERATION GUIDE
Loading Printer Driver
Ensure the printer is plugged in and connected to the PC before installing 
the printer driver from the CD-ROM.
1Switch on the PC and activate Windows.
NOTE:If the Welcome to the Found New Hardware Wizard dialog box 
displays, select Cancel.
2Insert the CD-ROM supplied with the printer into the optical drive of the PC.
3The installation program launches.
NOTE:If the installation program fails to launch, use Windows Explorer 
to access the...

Printing Operation 
OPERATION GUIDE2-3
Printing from Application Software
The steps required to print a document created with an application are 
explained below. You can select the printing Paper Size and Output 
Destination.
1Load the paper required into the paper cassette.
2From the application File menu, select Print. The Print dialog box 
displays.
3Click the drop down list of printer names. All the printers installed in 
Windows are listed. Click the name of the machine.
4Use Number of copies to...

Printing Operation 
2-4OPERATION GUIDE
Downloaded From ManualsPrinter.com Manuals 

OPERATION GUIDE3-1
3 Maintenance
This chapter contains explanations on the following topics:
•General Information.....................................................  3-2
•Toner Container Replacement.....................................  3-3
•Cleaning the Printer.....................................................  3-9
Downloaded From ManualsPrinter.com Manuals 

Maintenance 
3-2OPERATION GUIDE
General Information
This chapter describes basic maintenance tasks you can perform on the 
printer. You can replace the following component according to the printers 
display:
• Toner Container
• Waste Toner Box
Also, the internal parts need periodic cleaning.
Downloaded From ManualsPrinter.com Manuals 

Maintenance 
OPERATION GUIDE3-3
Toner Container Replacement
The toner container in the printer should be replaced as soon as the 
message display shows Toner low or soon after. If you continue to use 
the printer, eventually the toner supply will be exhausted at which point the 
printer will stop printing and the Replace toner Clean printer 
message will be shown instructing you to install a new toner kit.
Frequency of toner container replacement
Assuming an average toner coverage of 5 % and EcoPrint...

Maintenance 
3-4OPERATION GUIDE
Replenishing Toner
This section explains how to replace the toner container. When replacing 
the toner container, always replace the waste toner box at the same time.
If this box is full, the printer may be damaged or contaminated by the waste 
toner that may spill over the box.
NOTE: During toner container replacement, temporarily put storage 
media and computer supplies (such as floppy disks) away from around 
the toner container. This is to avoid damaging media by the...