Konica Minolta PagePro 5650EN User Manual

Lower Feeder Unit 211
6Pull out the trays.
7Lift up the printer by holding the 
recessed areas at both sides of 
the printer as shown in the fig-
ure.
8With another persons help, 
place the printer on top of the 
lower feeder unit, making sure 
that the positioning pins on the 
lower feeder unit correctly fit into 
the holes on the bottom of the 
printer.
The printer must be low-
ered gently. Otherwise, 
the interior parts may be 
damaged.
Downloaded From ManualsPrinter.com Manuals 

Lower Feeder Unit 212
WARNING!
This printer weighs approximately 23 kg (50.8 lbs) when it is fully loaded 
with consumables. The printer must be lifted by two people.
9Insert the fasteners into the 2 
locations inside and 2 locations 
at the back of the printer.
Downloaded From ManualsPrinter.com Manuals 

Lower Feeder Unit 213
10Push the trays completely into 
the printer.
11Reconnect all interface cables.
12Reconnect the power cord, and 
turn on the printer.
13Declare Paper Source Unit 3/4 in the Windows printer driver (Properties/
Configure tab).
Downloaded From ManualsPrinter.com Manuals 

Offset Tray 214
Offset Tray
When the offset tray is installed, job separation and offset printing can be per-
formed.
Installing the Offset Tray
1Turn off the printer and discon-
nect the power cord and inter-
face cables.
Downloaded From ManualsPrinter.com Manuals 

Offset Tray 215
2Loosen the right and left thumb-
screws as shown in the figure to 
remove the top cover of the 
paper exit. 
3Insert the right and left tabs of 
the offset tray into the holes at 
the top of the printer and slowly 
put the offset tray down to the 
top of the printer.
Downloaded From ManualsPrinter.com Manuals 

Offset Tray 216
4Tighten the two screws at both 
ends of the bottom of the offset 
tray.
5Draw the extension tray (1).
When printing a thick 
paper, you can flip the 
stopper as shown in the 
figure below (2).
6Reconnect all interface cables.
7Reconnect the power cord, and 
turn on the printer.
8Declare Offset Tray in the Windows printer driver (Properties/Configure 
tab).
Downloaded From ManualsPrinter.com Manuals 

Offset Tray 217 Installing the Face Up Tray
1Insert the right and left tabs of 
the face up tray into the holes at 
the back of the printer.
2Raise the lever as shown in the 
figure and draw the extension 
tray.
Downloaded From ManualsPrinter.com Manuals 

Offset Tray 218
Downloaded From ManualsPrinter.com Manuals 

Appendix
Downloaded From ManualsPrinter.com Manuals 

Safety Specifications 220
Safety Specifications
Technical Specifications
Printer
Printer
Safety standards U.S. model UL 60950-1, CSA C22.2 No. 
60950-1-03
European model EU Directive 73/23/EEC
EU Directive 93/68/EEC
EN 60950-1 (IEC 60950)
China model GB 4943
EMC standards U.S. model FCC part 15 subpart B class B
ICES-003
European model EU Directive 89/336/EEC
EU Directive 93/68/EEC
EN 55022 (CISPR Pub. 22) class B 
EN 61000-3-2
EN 61000-3-3
China model GB 9254 class B, GB 17625.1
Australian model EN...